AQA · GCSE AQA
AQA GCSE Physics June 2023 Paper 1 Foundation (8463/1F)
Set by AQA for AQA GCSE Physics, June 2023: 1 hour 45 minutes and 100 marks, on Energy, Electricity, Particle model of matter, Atomic structure, Working scientifically. The paper itself is on AQA’s website; this page adds what it covers, how to use it and original practice questions on the same topics.
Paper facts
- Series
- June 2023
- Paper
- Paper 1 Foundation
- Code
- 8463/1F
- Tier
- Foundation
- Time
- 1 hour 45 minutes
- Marks
- 100
- Calculator
- Allowed
- Syllabus
- 8463 (first teaching 2016)
- Links checked
- 17 November 2026
Official files
- Question paper(opens the page on AQA’s website that lists it)
- Mark scheme(opens AQA’s website)
- Examiner report(opens AQA’s website)
These files belong to AQA. Labverse links to them and never hosts or copies them. Labverse is not affiliated with AQA.
What this paper covers
5 topic groups from our map of GCSE Physics — AQA. Revise each one with its topic pages and simulations before you sit the paper.
- Energy
Energy stores and systems · Kinetic and potential energy · Specific heat capacity · Power · Conservation and dissipation of energy · Efficiency · Energy resources
Energy stores and transfersEnergy skate trackSpecific heat capacityPower and efficiency
- Electricity
Circuit symbols · Electrical charge and current · Current, resistance and potential difference · I–V characteristics · LDRs and thermistors · Series and parallel circuits · Mains electricity · Electrical power · Energy transfers in appliances · The National Grid · Static electricity and electric fields
Circuit builderCharge, current, energy and powerResistance of a wireI–V characteristics
- Particle model of matter
Density · Changes of state · Internal energy · Specific latent heat · Particle motion in gases · Pressure in gases
Measuring densityParticle model and states of matterLatent heat and heating curvesGas laws and particles
- Atomic structure
Structure of the atom · Mass number and isotopes · Development of the atomic model · Radioactive decay and nuclear radiation · Nuclear equations · Half-life · Contamination and irradiation · Uses and hazards of radiation · Nuclear fission and fusion
Isotopes and atom builderAtomic models and Rutherford scatteringAlpha, beta and gamma radiationNuclear equations
- Working scientifically
Measuring instruments · Accuracy, precision and errors · Units, prefixes and significant figures
Vernier caliperMicrometer screw gaugeAccuracy, precision and errorsSignificant figures, prefixes and units trainer
How to use this paper
- 1. Time it. Set 1 hour 45 minutes for 100 marks: about 63 seconds a mark. At 53 minutes you should be roughly halfway through the marks; if you’re well behind, speed up on the short questions.
- 2. Sit it in one go. Find the question paper on AQA’s website (the link above opens the page that lists it) and work on paper, with no notes.
- 3. Mark it with the official scheme. Give a mark only when your answer matches a marking point. Be strict with yourself: it’s the gaps you find that improve your grade.
- 4. Read the examiner report. It says which questions students found hardest and what the best answers did, so compare it with your own script.
- 5. Log mistakes by topic. Keep one line per topic group (Energy, Electricity, Particle model of matter, Atomic structure, Working scientifically) and add a tally each time a mark goes there.
- 6. Revisit, then redo. Work through the weakest group’s topic pages and simulations, try the questions below, and come back to the paper in a week.
Practise the same topics
6 original exam-style questions on this paper’s topics, written in the style of GCSE AQA (not taken from the paper). Try each one before you reveal the answer.
1.Two students each measure the thickness of the same coin four times with their own micrometer. The true thickness of the coin is 1.85 mm. Student A records 1.84 mm, 1.86 mm, 1.85 mm and 1.85 mm. Student B records 1.95 mm, 1.96 mm, 1.95 mm and 1.96 mm.
From the topic: Measuring instruments
(a)Give the resolution of the micrometers used.
1 markShow the answerHide the answer
Answer: 0.01 mm
Marking points
- 0.01 mm
(b)Which student's readings are more accurate? Give a reason for your answer.
2 marksShow the answerHide the answer
Answer: Student A. The mean of A's readings is 1.85 mm, the same as the true value, while B's mean (about 1.96 mm) is about 0.1 mm too large.
Marking points
- Student A
- A's readings (mean 1.85 mm) are closer to the true value.
(c)A teacher says that Student B's readings are precise. Explain what this means.
1 markShow the answerHide the answer
Answer: The repeat readings are very close to each other: they spread over only 0.01 mm.
Marking points
- The readings are close together / cluster closely (range only 0.01 mm).
(d)Suggest the most likely cause of the error in Student B's readings, and how Student B could correct the results.
2 marksShow the answerHide the answer
Answer: Student B's micrometer probably has a zero error of about +0.10 mm. B should close the micrometer with nothing in it, read the zero error, and subtract it from every reading.
Marking points
- A zero error (systematic error) in Student B's micrometer.
- Close the micrometer with nothing between the jaws, read the zero error and subtract it from each reading.
2.This invented data shows the percentage of a model country's electricity that came from each resource in three years. 2005: coal 35%, gas 40%, nuclear 20%, wind 3%, solar 2%. 2015: coal 22%, gas 40%, nuclear 20%, wind 12%, solar 6%. 2025: coal 2%, gas 36%, nuclear 15%, wind 34%, solar 13%.
From the topic: Energy resources
(a)Describe how the shares from coal and from wind changed between 2005 and 2025.
2 marksShow the answerHide the answer
Answer: The share from coal fell from 35% to 2%. The share from wind rose from 3% to 34%.
Marking points
- Coal decreased (from 35% to 2%)
- Wind increased (from 3% to 34%)
(b)Suggest two reasons for these trends.
2 marksShow the answerHide the answer
Answer: Burning coal releases a lot of carbon dioxide, so the country is cutting emissions to limit global warming. Wind turbines have become cheaper, and wind is renewable while coal will run out.
Marking points
- One reason, e.g. coal releases a lot of carbon dioxide / concern about global warming / laws or targets to cut emissions
- A second reason, e.g. wind turbines have become cheaper / wind is renewable while coal will run out / coal also causes acid rain
(c)Scientists agree that the country's gas power stations add to global warming, yet the country has not closed them. Suggest a reason why the gas power stations are still needed.
2 marksShow the answerHide the answer
Answer: Gas stations can be started quickly and run at any time, so they supply electricity when there is little wind or sunlight. Without them, supply might not match demand and there could be power cuts.
Marking points
- Gas power stations are reliable / can be started up quickly
- Needed when wind and solar output is low (to match supply to demand / avoid power cuts)
3.A thermistor is used to control the heater in a tropical fish tank.
From the topic: LDRs and thermistors
(a)Describe how the resistance of the thermistor changes as the temperature of the water increases.
1 markShow the answerHide the answer
Answer: The resistance decreases.
Marking points
- Resistance decreases as temperature increases.
(b)The potential difference across the thermistor is 4.0 V and the current through it is 0.0020 A. Calculate its resistance.
2 marksShow the answerHide the answer
Answer: R = V ÷ I = 4.0 ÷ 0.0020 = 2000 Ω
Marking points
- R = 4.0 ÷ 0.0020
- R = 2000 Ω (accept 2.0 kΩ)
(c)The water cools down. The potential difference across the thermistor stays the same. Explain what happens to the current in the thermistor.
2 marksShow the answerHide the answer
Answer: As the water cools, the thermistor's resistance increases. With the same p.d., a larger resistance means the current decreases.
Marking points
- Resistance of the thermistor increases.
- So the current decreases (for the same p.d.).
4.A 10 Ω resistor and a 40 Ω resistor are connected in parallel.
From the topic: Series and parallel circuits
(a)Which of these could be the total resistance of the combination: 8 Ω, 25 Ω or 50 Ω? Give a reason for your answer.
2 marksShow the answerHide the answer
Answer: 8 Ω, because the total resistance of resistors in parallel is less than the smallest individual resistance (10 Ω).
Marking points
- 8 Ω
- Total resistance in parallel is less than the smallest resistor.
5.When a candle burns, the solid wax near the wick melts. Some of the liquid wax turns to vapour, and the vapour burns in air to form carbon dioxide and water.
From the topic: Changes of state
(a)Liquid wax runs down the side of the candle and turns solid. Name this change of state.
1 markShow the answerHide the answer
Answer: Freezing (solidifying)
Marking points
- Freezing (accept solidifying)
(b)Melting the wax is a physical change. Burning the wax vapour is a chemical change. Explain the difference.
2 marksShow the answerHide the answer
Answer: Melting makes no new substance: when the liquid wax cools it becomes solid wax again, with its original properties. Burning makes new substances, carbon dioxide and water, which do not turn back into wax when they are cooled.
Marking points
- Physical change: no new substance; reversing it (cooling) gives back wax with its original properties.
- Chemical change: new substances (carbon dioxide and water) form, and cooling does not give back the wax.
(c)Explain why the mass of a burning candle goes down, even though mass is conserved when the wax melts.
2 marksShow the answerHide the answer
Answer: The wax vapour burns, and the products are gases that escape into the air. That mass leaves the candle; it is not destroyed. Melting alone would not change the mass.
Marking points
- Wax vapour burns to form gases (carbon dioxide and water vapour) that move away into the air.
- So mass leaves the candle (it is not destroyed); melting on its own does not change the mass.
6.Americium-241 is used in smoke alarms. Its nuclei are unstable and emit alpha particles.
From the topic: Radioactive decay and nuclear radiation
(a)Describe what an alpha particle is made of.
2 marksShow the answerHide the answer
Answer: It consists of two protons and two neutrons: the same particles as a helium nucleus.
Marking points
- Two protons
- Two neutrons (allow: a helium nucleus, for both marks)
(b)The decay of americium-241 nuclei is random. Explain what this means.
2 marksShow the answerHide the answer
Answer: It is impossible to predict which nucleus will decay next, or when any particular nucleus will decay.
Marking points
- Cannot predict which nucleus will decay (next)
- Cannot predict when a given nucleus will decay
(c)The americium-241 in one smoke alarm has an activity of 37 000 Bq. State what this tells you.
2 marksShow the answerHide the answer
Answer: 37 000 nuclei in the sample decay every second.
Marking points
- 37 000 nuclei decay / 37 000 decays
- Each second
(d)Explain why an alpha source is suitable for a smoke alarm used in a home.
3 marksShow the answerHide the answer
Answer: Alpha is strongly ionising, so it ionises the air inside the alarm's chamber. It has a range in air of only a few centimetres and is stopped by thin materials, so it is absorbed inside the alarm and does not reach people in the room.
Marking points
- Alpha is strongly ionising, so it ionises the air in the alarm
- Short range in air (a few cm) / absorbed by a thin layer such as the case
- So the radiation does not escape to reach people in the room