What AQA expects from you
Spec point 4.2.1.2 covers what an electric current actually is and how it links to charge and time. It is on both tiers and in both Combined Science and GCSE Physics. There is one equation here, and you must remember it: it is not printed on the equation sheet.
Why charge flows
Wires are full of charged particles that can move. In a metal, these are electrons. On their own they move about at random, so there is no overall flow in one direction. Two things are needed to make charge move round a circuit:
- A closed circuit. There must be a complete loop with no breaks. Opening a switch makes a gap, and the flow stops everywhere at once.
- A source of potential difference. A cell, a battery or a power supply provides the push. Without it, a complete loop of wire and lamps carries no current at all.
What current means
Current is moving charge. We measure how big a current is by its rate of flow: the number of coulombs that pass a point in the circuit every second.
A current of 1 ampere means 1 coulomb of charge passes a point each second. So a current of 3 A moves 3 C past a point every second, and in one minute it moves 180 C.
The equation: you must remember this
| Quantity | Symbol | Unit |
|---|---|---|
| charge flow | coulomb, C | |
| current | ampere (amp), A | |
| time | second, s |
In words: charge flow equals current multiplied by time. Rearranged, and .
One loop, one current
Put an ammeter anywhere in a circuit that has just one loop and it gives the same reading. Charge is not used up as it passes through a lamp or a resistor. What the components take from the charge is energy, not the charge itself. So an ammeter placed before a lamp reads the same as one placed after it.
Worked example 1: charging a phone
A phone charger supplies a steady current of 1.5 A for 40 minutes. How much charge flows into the phone?
Given: ,
Equation:
Substitution:
Answer:
Worked example 2: finding a current
In a bicycle lamp, 90 C of charge passes through the bulb in 2.5 minutes. Calculate the current.
Given: ,
Equation:
Substitution:
Answer:
A quick check helps here: 0.60 C each second for 150 seconds is 90 C, which matches the question.
Where this leads
Charge flow appears again later in the AQA course. In spec point 4.2.4.2 you link it to energy and potential difference, and the same comes straight from this page. Getting confident with now makes those questions much quicker.
Using the simulation
In the simulation above, load the Series circuit. The ammeter sits in the bottom wire of the loop. Note its reading. Choose the Wire tool and tap the ammeter to swap it for a wire. Then choose the Ammeter tool and tap a different wire, such as the one between the two lamps. The reading does not change, which shows the current is the same all round one loop. Now remove one wire: the current falls to zero everywhere, not just near the break. Use the "Show the flow of" buttons to switch the moving dots between conventional current and electrons. Either way, the dots never pile up or vanish at a lamp.