Where this fits in AQA electricity
Spec point 4.2.1.3 links the three big quantities of circuit physics: current, resistance and potential difference. It is examined on both tiers. It also contains Required practical activity 3, on resistance, which you can be asked about in the written papers.
How resistance controls current
Two things decide how big the current in a component is: the p.d. across it and its resistance. The p.d. pushes charge through. The resistance opposes that flow.
Keep the p.d. the same and swap in a component with more resistance, and the current gets smaller. Swap in one with less resistance, and the current gets bigger. In a metal wire, resistance comes from the moving electrons bumping into the vibrating ions of the metal.
The equation: you must remember this
| Quantity | Symbol | Unit |
|---|---|---|
| potential difference | volt, V | |
| current | ampere (amp), A | |
| resistance | ohm, Ω |
The word version is potential difference = current × resistance. It is not on the equation sheet, so learn it alongside its two rearrangements, and .
Worked example 1: finding a resistance
A small heating element in a hand warmer has a p.d. of 4.5 V across it. The current through it is 0.30 A. Calculate its resistance.
Given: ,
Equation: , so
Substitution:
Answer:
Worked example 2: watch the prefixes
A 12 V supply is connected across a 2.4 kΩ resistor. Find the current in milliamps.
Given: ,
Equation:
Substitution:
Answer:
Kilo means multiply by 1000 and milli means divide by 1000. Convert first, then substitute.
Required practical activity 3: resistance
This practical has two parts, and both can turn up in an exam.
Length of a wire. Clamp a thin wire, such as constantan, along a metre ruler. Connect it in series with a cell and an ammeter, and put a voltmeter across the section being tested. Attach one crocodile clip at zero and move the other clip to change the length. For each length, record the current and the p.d., then work out . A graph of resistance against length should be a straight line, because resistance is directly proportional to length.
Resistors in series and parallel. Measure the total current and p.d. for single resistors, then for pairs joined in series and in parallel. You should find that series pairs give a larger total resistance and parallel pairs give a smaller one.
Using the simulation
In the simulation above, open the Empty circuit. Build one loop with the battery, a resistor and an ammeter, and put a voltmeter across the resistor. Select the resistor and raise its resistance in steps. The current falls each time while the p.d. stays the same. Now multiply the ammeter reading by the resistance you set, and check that the answer matches the voltmeter reading every time. Finally, swap in a variable resistor and see how it gives you a smooth way to control the current, just as in the practical.