Spec point 4.4.2.3: who sits it
Half-life is for every AQA student, Foundation or Higher, GCSE Physics or Combined Science. Nothing here needs an equation. Aim to:
- explain random decay, and why a large sample still has a steady half-life
- give the half-life in terms of nuclei, or of count rate or activity
- find a half-life from a graph or a table
- Higher tier only: compare an emission after a whole number of half-lives with its starting value, as a ratio (AQA calls this the net decline)
Activity and count rate are defined in 4.4.2.1. Background radiation (4.4.3.1) and the huge spread of half-lives (4.4.3.2) are GCSE Physics only.
Chance for one nucleus, a pattern for billions
One unstable nucleus might decay in the next second or last for many half-lives, and nothing can tell you which. That is what random means. Heat, pressure and chemical changes make no difference.
A sample holds billions of these nuclei, each with the same small chance of decaying every second. So each second a nearly fixed fraction of the undecayed nuclei decays, and equal times remove equal fractions. The time that removes half is the half-life, a fixed property of the isotope.
Stating the half-life
The specification gives two versions; either will do in a definition.
- Nuclei: how long a sample takes to lose half of its undecayed nuclei of that isotope.
- Rates: how long the activity, or a detector's count rate, takes to drop to 50% of its starting value.
Both rates depend on how many undecayed nuclei remain, so they halve in the same time. A detector catches only the emissions that reach it, so its count rate is below the activity. Decayed nuclei stay in the sample as daughter nuclei.
GCSE Physics only: subtract any background count rate from every reading first.
Worked example: half-life from a table
Given: a sealed sample's activity, measured every 3 hours.
| Time (hours) | Activity (Bq) |
|---|---|
| 0 | 1200 |
| 3 | 849 |
| 6 | 600 |
| 9 | 424 |
| 12 | 300 |
- Half of 1200 Bq is 600 Bq, reached at 6 h.
- Check from a later start: 849 Bq at 3 h has halved to about 424 Bq by 9 h, again 6 h later.
Answer: half-life = 6 hours. On a graph, read across from half the starting value to the curve, then down.
Higher tier: net decline as a ratio
After whole half-lives an emission is of its starting value. AQA asks for the net decline as a ratio but does not say which two amounts to compare. So write your ratio in the order the question uses, and label it.
- Left compared with the start: final : start is 1 : 2, then 1 : 4, 1 : 8 and so on, which is . This page and the simulation use this form.
- Lost compared with the start: decrease : start is . After three half-lives that is 7 : 8, so 7/8 of the emission has gone.
Both describe the same change, seen from opposite sides.
Given: a school's cobalt-60 source had an activity of 160 000 Bq when new; its half-life is 5.3 years. Find its activity 21.2 years later.
- Number of half-lives: .
- Halving four times divides by 16: Bq.
- Final : start = .
Answer: 10 000 Bq. As a ratio, final : start = 1 : 16. The activity has dropped by 150 000 Bq, so decrease : start = 15 : 16, and 15/16 of it has gone.
In the simulation above
The simulation opens on 400 nuclei of Protactinium-234m, showing the Nuclei N graph.
- Press Play. Dots dim one by one, at random. The readout below the graph reports when this sample dropped to 200 nuclei: about 70 s, close to the 69.5 s on the Half-life T½ card.
- When the run ends, press ¼ under Half-life line at: about 137 s, two halvings of roughly 69 s.
- Switch on Mark every halving: the brackets are similar but not equal, varying most once few nuclei are left.
- Higher tier: press Reset, choose 4 under Pause after in After whole half-lives, then press Play. When the run stops, compare This sample with Expected N (25) and read Left : start, 1 : 16.
- GCSE Physics only: set Pause after to Off and choose 1600 under Nuclei at the start; the run restarts, paused. At 400 nuclei the source gives only about 1 count/s, too close to the background. Press Count rate above the graph, then Play. Once the run finishes, the background-subtracted readings halve in about 73 s. Switch off Subtract the background: the recorded readings take about 88 s, because background never decays.