Skip to content

GCSE Physics — AQA · Electricity

Mains electricity

4.2.3.14.2.3.2

UK mains is an alternating supply of about 230 V at 50 Hz. In three-core cable, brown live is at about 230 V, blue neutral is near 0 V, and the green-and-yellow earth is at 0 V and carries current only in a fault. Spec 4.2.3, both tiers, GCSE Physics and Combined Science.

Loading simulation…

Symbols match your course. Open the full mains electricity and safety simulation for more presets and teacher tools.

Where this sits in AQA GCSE Physics

Spec points 4.2.3.1 and 4.2.3.2 are tested on both tiers, for Combined Science students as well as GCSE Physics students. They bring no new equation; the worked example borrows V=IRV = IR (4.2.1.3, recall).

Direct or alternating?

A cell gives a direct p.d.: one terminal is always the positive one, so the current always flows the same way. An alternating p.d. keeps reversing, and so does the current it drives.

Mains electricity is a.c. In the UK it alternates at 50 Hz, meaning 50 complete cycles each second, and its p.d. is about 230 V. Both are nominal values.

The three cores

A three-core cable links most appliances to the mains, each core in its own colour of insulation.

CoreInsulationIts jobp.d. compared with earth
livebrownconnects the appliance to the supply's alternating p.d.about 230 V
neutralbluethe return path to the supply0 V, or very nearly
earthgreen and yellow stripesjoined to a metal case, so a fault cannot leave the case live0 V; no current unless something goes wrong

Why live is dangerous

Your body is normally at about 0 V, like the ground. If you touch the live wire, roughly 230 V is across you, so a current flows through your body to earth. No neutral is needed: you complete the circuit.

Opening a switch breaks the circuit in just one place. The live wire on the supply side of it, such as the wall wiring, stays at about 230 V. A switch wrongly fitted in the neutral leaves the whole appliance live when it is off.

Any link between live and earth has the full mains p.d. across it. Through a person, the current can kill. Through a path of very low resistance, the current is huge: it heats the wiring and could start a fire.

Worked example: a live core touches a metal case

A toaster's live core rubs through its insulation and touches the metal case. Explain what happens (a) if the case is earthed and (b) if the earth wire has come loose and someone touches the case. In (b), the path through the person and the floor has a resistance of 4600 Ω, a model value.

(a) Earthed case

  1. The earth wire holds the case close to 0 V, so it does not become live.
  2. Live is now joined to earth through a path of very little resistance.
  3. A very large current flows in the earth wire, the only time it carries one.
  4. Not in the AQA specification: this current melts the fuse or trips a circuit breaker, cutting off the live supply.

(b) No earth connection

  1. No extra current flows, so the toaster may seem fine.
  2. The case is now at about 230 V: it is live.
  3. The person is at about 0 V, so touching the case puts 230 V across their body.
  4. Current: I=VR=2304600=0.050I = \dfrac{V}{R} = \dfrac{230}{4600} = 0.050 A

Answer: in (a) the fault current goes down the earth wire, not through anyone. In (b), 50 mA flows through the person, which can be fatal.

In the simulation above

It opens on the Plug scene, which goes beyond AQA. Press Faults under the stage: a metal kettle is switched on, with Earthed metal case chosen.

  1. In the earth wire reads 0 A. Press Fault: it leaps to about 230 A until the 13 A fuse melts, then drops to 0 A, and the Case card reads 0 V.
  2. Choose No earth wire and press Fault. The fuse stays whole, but the Case card shows the case at 230 V.
  3. Press Switch off, then Fault. The status line explains why switching off did not help.
  4. Press Home and choose Light switch in the neutral from Examples. Every light is off, yet Light 1's holder is still at 230 V. Set Light 1’s switch is wired into the to Live wire and it drops to 0 V.

Common mistakes

  • Calling the neutral the safety wire. The neutral carries current whenever the appliance is on; the earth is the safety wire, and it carries current only in a fault.
  • Giving the earth's colour as plain green, or swapping live and neutral. Live is brown, neutral is blue and earth has green and yellow stripes.
  • Assuming nothing is live once an appliance is switched off. On the supply side of the switch, the live wire stays at about 230 V.
  • Saying the danger comes from a 'high current' in the live wire. It is the p.d. of about 230 V between the live wire and a person at 0 V that drives a current through the body.
  • Describing a.c. as a current that rises and falls. A direct current can change in size too; what makes a current alternating is that it reverses direction.
  • Mixing up the two mains values: about 230 V is the potential difference, and 50 Hz is the frequency, the number of cycles each second.

Exam-style questions

Original questions written in the style of GCSE AQA. Try each one before you reveal the answer.

  1. 1.A bicycle lamp runs from a battery. A table lamp runs from the UK mains supply.

    1. (a)Name the type of potential difference provided by the battery.

      1 mark
      Show the answer

      Answer: Direct potential difference (d.c.).

      Marking points

      • direct (allow d.c.)
    2. (b)Explain how the potential difference of the mains supply is different from the potential difference of the battery.

      2 marks
      Show the answer

      Answer: The mains p.d. is alternating: it reverses its direction many times each second. The battery's p.d. is direct: it always acts in the same direction, so its current flows one way only.

      Marking points

      • the mains p.d. keeps reversing direction / is alternating
      • the battery's p.d. always acts in the same direction / is direct
    3. (c)Give the frequency and the potential difference of the UK mains supply.

      2 marks
      Show the answer

      Answer: Frequency: 50 Hz. Potential difference: about 230 V.

      Marking points

      • 50 Hz
      • (about) 230 V
  2. 2.The table lamp has a metal base. It is connected to the mains by a three-core cable.

    1. (a)Give the colour of the insulation on the live wire and on the earth wire.

      2 marks
      Show the answer

      Answer: Live: brown. Earth: green and yellow stripes.

      Marking points

      • live: brown
      • earth: green and yellow (stripes)
    2. (b)State the potential difference between the neutral wire and earth.

      1 mark
      Show the answer

      Answer: 0 V, or very close to 0 V.

      Marking points

      • 0 V (allow close to 0 V)
    3. (c)State when there is a current in the earth wire.

      1 mark
      Show the answer

      Answer: Only when there is a fault, for example when the live wire touches the metal base.

      Marking points

      • only when there is a fault (e.g. the live wire touching the metal base)
    4. (d)Explain why the earth wire is described as a safety wire.

      2 marks
      Show the answer

      Answer: It is connected to the metal base and keeps the base at 0 V. So a fault cannot make the base live, and someone touching it does not get a shock.

      Marking points

      • it is connected to the metal base / case
      • it stops the base becoming live (keeps it at 0 V), so a user does not get a shock
  3. 3.A student switches off a ceiling light at the wall switch before changing the bulb. The switch is correctly wired into the live wire.

    1. (a)The wiring between the supply and the switch is still dangerous to touch. Explain why.

      3 marks
      Show the answer

      Answer: That part of the live wire is still connected to the supply, so it is at about 230 V. A person is at about 0 V, the same as earth. Touching it would put a large p.d. across the body, so a current would flow through the body to earth: an electric shock.

      Marking points

      • the live wire up to the switch remains joined to the supply / stays at about 230 V
      • a person is at (about) 0 V / earth potential
      • so there is a p.d. across the body and a current flows through it to earth (electric shock)
    2. (b)In another room, a light switch has been wrongly wired into the neutral wire. Explain why changing that bulb is dangerous, even with the switch off.

      2 marks
      Show the answer

      Answer: With the switch in the neutral, the lamp holder is still connected to the live wire, so it stays at about 230 V. Touching its contacts could let a current flow through the person to earth.

      Marking points

      • the lamp holder is still connected to the live wire / still at about 230 V
      • touching it lets a current flow through the person to earth (shock)
    3. (c)A person touches a live wire. The potential difference across their body is 230 V and the resistance of the path through them to earth is 9200 Ω. Calculate the current through the person. Give your answer in milliamps.

      3 marks
      Show the answer

      Answer: V = IR, so I = V ÷ R = 230 ÷ 9200 = 0.025 A = 25 mA. (9200 Ω is a model value: real body resistance varies widely, and wet skin lowers it.)

      Marking points

      • 230 = I × 9200 (or I = 230 ÷ 9200)
      • I = 0.025 A
      • 25 mA
  4. 4.A washing machine has a metal case and is connected to the mains by a three-core cable. Inside the machine, the live wire comes loose and touches the metal case.

    1. (a)Explain what happens when a person touches the case (i) if the earth wire is connected and (ii) if the earth wire is broken. Use ideas about potential difference and current in your answer.

      6 marks
      Show the answer

      Answer: (i) The earth wire joins the case to earth, so the case stays at (close to) 0 V and does not become live. The live wire is now connected to earth through a path of very low resistance, so a large current flows from the live wire through the case and down the earth wire. The person is also at 0 V, so there is almost no p.d. across them and no current through them. (Not required by the AQA specification, but worth credit: the large current melts the fuse or trips a circuit breaker, which cuts off the live supply.) (ii) With the earth wire broken, nothing carries current away from the case, so the machine may seem to work normally, but the case is now at about 230 V. The person is at about 0 V, so there is a p.d. of about 230 V across their body. A current flows through them to earth: an electric shock, which could be fatal. Switching the machine off may not help if the fault is on the supply side of its switch. (Level-of-response question: the whole answer is read and placed in a level, rather than points being ticked off one by one. Level 3, 5–6 marks: a clear, logical explanation of both cases that links the p.d. across the person to whether a current flows through them. Level 2, 3–4 marks: both cases described with some explanation, or one case explained fully. Level 1, 1–2 marks: simple statements, such as 'the earth wire makes it safe' or 'the person gets a shock'. 0 marks: no relevant content.)

      Marking points

      • Earth wire connected: the case is kept at (about) 0 V, so it does not become live.
      • A large current flows from the live wire through the case and down the low-resistance earth wire.
      • The person and the case are both at about 0 V, so there is almost no p.d. across the person and no current through them.
      • Earth wire broken: no current flows to earth, but the case is now at about 230 V (it is live).
      • The person is at about 0 V, so there is a p.d. of about 230 V across their body.
      • A current flows through the person to earth: an electric shock, which could be fatal. (Also credit, beyond the specification: in (i) the large current melts the fuse or trips a circuit breaker.)

Quick check

6 questions

  1. 1.Which row is correct for the neutral wire in a UK three-core cable?
  2. 2.What is the frequency of the UK mains supply?
  3. 3.In normal use, which wire of a three-core cable carries no current?
  4. 4.A kettle is plugged in with the socket switched on, but its own switch is off. Why could a bare patch on the live core of its cable still give a shock?
  5. 5.Which statement describes an alternating potential difference?
  6. 6.A person standing on the ground touches the live wire. What is the potential difference across their body?