Skip to content

BISE Gujranwala · Punjab Class 9

BISE Gujranwala Annual 2025 Class 9 Physics (Objective, Group II) (5472)

Set by BISE Gujranwala for Punjab Class 9 Physics, Annual 2025: 15 minutes and 12 marks, on Physical quantities and measurements, Kinematics, Dynamics, Turning effects of force, Work, energy and power, Mechanical properties of matter, Thermal properties of matter, Nature of science. The paper itself is on BISE Gujranwala’s website; this page adds what it covers, how to use it and original practice questions on the same topics.

Paper facts

Series
Annual 2025
Paper
Objective, Group II
Set by
BISE Gujranwala
Code
5472
Tier
Not tiered
Time
15 minutes
Marks
12
Calculator
Not recorded here: check the paper’s instructions
Syllabus
Old Punjab syllabus (PCTB Physics 9 used until the 2024-25 session), not the NC 2023 book. Some questions, such as satellites and heat transfer, are not in the new course.
Links checked
17 November 2026

Official files

These files belong to BISE Gujranwala. Labverse links to them and never hosts or copies them. Labverse is not affiliated with BISE Gujranwala.

What this paper covers

8 topic groups from our map of Punjab Board Class 9 Physics. Revise each one with its topic pages and simulations before you sit the paper.

How to use this paper

  1. 1. Time it. Set 15 minutes for 12 marks: about 75 seconds a mark. At 8 minutes you should be roughly halfway through the marks; if you’re well behind, speed up on the short questions.
  2. 2. Sit it in one go. Open the question paper on BISE Gujranwala’s website (the link above) and work on paper, with no notes.
  3. 3. Mark it with the official scheme. The mark scheme isn’t public, so check answers with your teacher, and use the marking points on our questions below to practise marking.
  4. 4. Learn from the marks you lost. For every lost mark, note whether it was knowledge, method, reading the question or time.
  5. 5. Log mistakes by topic. Keep one line per topic group (Physical quantities and measurements, Kinematics, Dynamics, Turning effects of force, Work, energy and power, Mechanical properties of matter, Thermal properties of matter, Nature of science) and add a tally each time a mark goes there.
  6. 6. Revisit, then redo. Work through the weakest group’s topic pages and simulations, try the questions below, and come back to the paper in a week.

Practise the same topics

8 original exam-style questions on this paper’s topics, written in the style of Punjab board exams (not taken from the paper). Try each one before you reveal the answer.

  1. 1.A large stone is too wide to go into any measuring cylinder in the laboratory.

    From the topic: Measuring cylinders and displacement cans

    1. (a)Name the apparatus used to find its volume.

      1 mark
      Show the answer

      Answer: A displacement can (overflow can), with a measuring cylinder.

      Marking points

      • Displacement can / overflow can
    2. (b)Describe how this apparatus is used to find the volume of the stone.

      4 marks
      Show the answer

      Answer: Stand the can on a level table and pour in water until some runs out of the spout; wait for the dripping to stop. Put an empty measuring cylinder (or beaker) under the spout. Lower the stone gently on a thread until it is completely under water. The water that overflows, read on the measuring cylinder, has the same volume as the stone.

      Marking points

      • Can filled until water runs from the spout; dripping allowed to stop
      • Empty measuring cylinder or beaker placed under the spout
      • Stone lowered gently (on a thread) until fully under water
      • Volume of overflow collected = volume of the stone
  2. 2.Answer these short questions on distance and displacement.

    From the topic: Distance and displacement

    1. (a)Define displacement. Is it a scalar or a vector quantity?

      2 marks
      Show the answer

      Answer: Displacement is the change in position of a body. It is the straight line joining where the motion starts to where it ends, pointing from start to end. It is a vector quantity.

      Marking points

      • Change in position: the straight line joining start and end, pointing from start to end
      • Vector quantity
    2. (b)When is the magnitude of the displacement of a body equal to the distance it covers?

      2 marks
      Show the answer

      Answer: When the body moves along a single straight line in one direction, without turning or coming back.

      Marking points

      • Motion along a straight line
      • In one direction only, with no turning back
    3. (c)Write the SI unit of distance and of displacement.

      1 mark
      Show the answer

      Answer: Both are measured in metres (m).

      Marking points

      • Metre (m) for both
  3. 3.A bus moving at 20 m s⁻¹ on the Lahore Ring Road applies its brakes and decelerates uniformly at 2.5 m s⁻².

    From the topic: Equations of motion

    1. (a)Calculate the distance the bus covers before it stops.

      3 marks
      Show the answer

      Answer: vi = 20 m s⁻¹, vf = 0, a = −2.5 m s⁻². 2aS = vf² − vi² gives S = (0 − 400) ÷ (2 × −2.5) = 80 m

      Marking points

      • Takes a = −2.5 m s⁻² and vf = 0
      • Uses 2aS = vf² − vi²
      • 80 m
    2. (b)Calculate the time the bus takes to stop.

      2 marks
      Show the answer

      Answer: vf = vi + at gives 0 = 20 + (−2.5)t, so t = 8 s

      Marking points

      • Uses vf = vi + at with a negative
      • 8 s
  4. 4.The same horizontal force is applied in turn to an empty trolley and to the same trolley loaded with bricks. Friction is negligible.

    From the topic: Newton's second law

    1. (a)Which trolley has the greater acceleration? Explain using Newton's second law.

      2 marks
      Show the answer

      Answer: The empty trolley. With the same net force, a = F ÷ m, so a smaller mass gets a larger acceleration, and the empty trolley has the smaller mass.

      Marking points

      • The empty trolley
      • Same force, so a is inversely proportional to m (smaller mass, larger a)
    2. (b)Explain why the force in F = ma must be the net force and not just the applied force.

      2 marks
      Show the answer

      Answer: Other forces such as friction also act on the body and oppose the applied force. Only the resultant of all the forces produces the acceleration.

      Marking points

      • Other forces (e.g. friction) act on the body as well
      • The acceleration is produced by the resultant of all the forces
  5. 5.A uniform plank 3.0 m long has a mass of 20 kg. A 40 kg sack of wheat rests on it 0.60 m from end A. Take g = 10 N/kg.

    From the topic: Centre of mass and centre of gravity

    1. (a)Calculate the total weight of the plank and the sack.

      2 marks
      Show the answer

      Answer: Plank: w = 20 × 10 = 200 N. Sack: w = 40 × 10 = 400 N. Total = 600 N.

      Marking points

      • Plank 200 N and sack 400 N
      • Total weight 600 N
    2. (b)Find the distance from A of the centre of gravity of the plank and sack together.

      3 marks
      Show the answer

      Answer: The plank's weight acts at its midpoint, 1.5 m from A. Taking moments about A: 600 × x = 200 × 1.5 + 400 × 0.60 = 300 + 240 = 540, so x = 540 ÷ 600 = 0.90 m from A.

      Marking points

      • Plank's weight taken at its midpoint (1.5 m from A)
      • 600 × x = 200 × 1.5 + 400 × 0.60 = 540
      • x = 0.90 m from A
    3. (c)A single support placed under this point holds the plank level. What upward force does the support provide?

      1 mark
      Show the answer

      Answer: 600 N, equal to the total weight.

      Marking points

      • 600 N
  6. 6.Sources of energy are divided into two groups: renewable and non-renewable.

    From the topic: Renewable and non-renewable energy sources

    1. (a)Differentiate between renewable and non-renewable sources of energy.

      2 marks
      Show the answer

      Answer: Renewable sources are replaced by nature as they are used, so they will not run out. Non-renewable sources exist in limited amounts and will run out, because they took millions of years to form or are mined from limited deposits.

      Marking points

      • Renewable: replaced by nature / will not run out
      • Non-renewable: limited in amount / will run out once used
    2. (b)Give two examples of each type.

      2 marks
      Show the answer

      Answer: Renewable: any two of solar, wind, hydroelectric, geothermal, tidal and wave energy (allow biofuels such as biogas, if new plants are grown to replace those used). Non-renewable: any two of coal, oil, natural gas and nuclear fuel.

      Marking points

      • Two correct renewable sources (allow biofuels if replanted)
      • Two correct non-renewable sources
    3. (c)Why is nuclear energy counted as a non-renewable source?

      1 mark
      Show the answer

      Answer: Its fuel, such as uranium, is found in limited amounts and is used up in the reactor.

      Marking points

      • Nuclear fuel (uranium) is limited and gets used up
  7. 7.An underground water tank, with a flat base 1.5 m long and 1.0 m wide, is filled to a depth of 1.2 m with water of density 1000 kg m⁻³ (g = 10 m s⁻²).

    From the topic: Pressure in liquids

    1. (a)Work out the pressure that the water exerts on the base of the tank.

      2 marks
      Show the answer

      Answer: P = ρgh = 1000 × 10 × 1.2 = 1.2 × 10⁴ Pa.

      Marking points

      • P = 1000 × 10 × 1.2
      • 1.2 × 10⁴ Pa
    2. (b)Find the total force that the water exerts on the base.

      2 marks
      Show the answer

      Answer: A = 1.5 m × 1.0 m = 1.5 m². F = PA = 1.2 × 10⁴ Pa × 1.5 m² = 1.8 × 10⁴ N.

      Marking points

      • A = 1.5 m² and F = PA
      • 1.8 × 10⁴ N
    3. (c)A second tank has a base of twice this area and holds water to the same depth. State the pressure and the force on its base.

      2 marks
      Show the answer

      Answer: The pressure is unchanged at 1.2 × 10⁴ Pa, because the depth and the liquid are the same. The force doubles to 3.6 × 10⁴ N, because F = PA and the area is doubled.

      Marking points

      • Pressure still 1.2 × 10⁴ Pa
      • Force doubles to 3.6 × 10⁴ N
  8. 8.A bicycle pump is full of air, and its outlet is sealed with a thumb.

    From the topic: Kinetic molecular theory of matter

    1. (a)The handle can still be pushed some way in. Explain why, using the kinetic molecular theory.

      2 marks
      Show the answer

      Answer: Air molecules are far apart with large empty spaces between them. Pushing the handle moves the molecules closer together, so the volume of the air decreases.

      Marking points

      • Large spaces between the air molecules
      • Pushing moves the molecules closer together, so the volume decreases
    2. (b)With the same pump full of water, the handle can hardly be moved. Explain why.

      2 marks
      Show the answer

      Answer: Water molecules are already very close together, so there is almost no empty space to push them into. A liquid can hardly be compressed.

      Marking points

      • Water molecules are already very close together
      • Almost no space to push them into, so a liquid can hardly be compressed
    3. (c)Does the mass of the air change when it is squeezed into a smaller volume? Give a reason.

      1 mark
      Show the answer

      Answer: No. The number of molecules stays the same; only the spaces between them get smaller.

      Marking points

      • No, because the number of molecules is unchanged