What this simulation shows
A steel platform in a test bay is hinged along one edge. Stand a bookcase, a double-decker bus, a racing car, a floor lamp or a plain block on it, then raise the platform slowly with the Tilt button. At some angle the object lifts off its uphill edge and crashes onto the padded mat. The simulation records that angle on the scale and in the readouts.
Everything that decides the result is drawn on the stage. The chequered disc is the centre of mass, G. (Some courses, including Cambridge IGCSE and the Punjab textbook, call it the centre of gravity. Near the Earth, where gravity is the same throughout an object, the two are at the same point.) The dashed line hanging straight down from it shows where the weight acts. The glowing strip is the base, and the orange dot at the hinge is the pivot edge the object turns about.
The tipping condition
While the dashed line from G still meets the base, the weight has a moment about the pivot edge that presses the object back onto its base, and the line glows green. Tilt further and G drifts sideways until it is directly over the pivot edge. One step beyond that, the line misses the base, turns red, and the same moment now rolls the object over.
That balance point is the critical angle. With G a height above the middle of a base of width , a little trigonometry gives
For a base 2 m wide with G 2 m up, and . The dashed outline on the stage shows the object turned to exactly this angle, with G straight above the edge.
Lower and wider means steadier
Two changes raise the critical angle: widening the base, and bringing G down. With the books on the bottom shelf, the bookcase's centre of mass sits 0.5 m up. Move the same books to the top shelf and it rises to 1.3 m, so the bookcase goes over at about 11° instead of 27°. Passengers upstairs do the same to the bus. The racing car, low and wide, hangs on until about 72°.
The panel shows how h comes from the parts: multiply each mass by the height of its own centre of mass, add these up, then divide by the total mass.
Tipping by hand
Press Tip, or drag the object, to lean it over its edge while the platform stays put. Let go below the critical angle and it drops back onto its base with a thud. Let go beyond it and it topples. Leaning is not the same as falling: what matters is which side of the pivot edge G is on.
States of equilibrium
The Equilibrium experiment has three set-ups on a level table. A cone on its base lifts its centre of mass when tipped slightly, then settles back: stable equilibrium. Balanced on its point, the same cone lowers G as soon as it leans, and keeps going: unstable equilibrium. A cylinder on its side can be rolled anywhere without its centre of mass changing height, so it stays wherever it is left: neutral equilibrium.
Finding a centre of mass with a plumb line
In the Plumb line experiment a flat card hangs from a pin. It swings, then stops with G straight below the pin, on the plumb line. Mark that line, hang the card from a different hole and mark again. The two lines cross at the centre of mass. On the boomerang they meet in the empty gap between its arms, because a centre of mass does not have to lie on the object itself.
For more on turning effects, try the principle of moments simulation.
What the model assumes
The platform grips well enough that nothing ever slides, so objects can only tip. Each object is symmetrical, so G sits above the middle of its base. The masses and sizes are realistic examples, not measurements of any real vehicle or product.