What this simulation shows
A block sits on a level bench, hooked to a spring balance held in a gloved hand. You control the pull. Drag the Applied force slider, or press Pull beside Play to make the pull grow at a steady rate, like tugging harder and harder on a real newton-meter. Arrows drawn to one shared scale show the pull, friction, the weight, the normal contact force and the resultant. A live graph plots friction against the applied force as you go.
Friction matches the pull at first
Start with the 2 kg wooden block and pull gently. Nothing moves, and the friction arrow grows to exactly the length of the pull arrow. Many students find this surprising. Friction is not a fixed force lying in wait; it is a response. While the block is at rest the resultant force has to be zero, so static friction takes whatever value cancels the pull. On the friction against applied force graph this is the straight part with a gradient of 1, where the friction and pull lines lie on top of each other.
The limit
Static friction cannot grow without end. The most it can provide is
where is the coefficient of static friction for that pair of surfaces and is the normal contact force. On a level surface with a horizontal pull, . For the 2 kg block on wood, with and N/kg, the limit is N. A dashed outline behind the friction arrow marks this limit, and the contact under the block starts to glow as the pull closes in on it.
Sliding and kinetic friction
The moment the pull passes , the block breaks free. Surfaces that are sliding grip less well, so friction falls to
with usually smaller than . That is the sudden step down on the graph. After it, the line is flat: kinetic friction stays the same however hard you pull. Any pull bigger than leaves a forward resultant, so the block accelerates with
This has a surprising consequence. If you hold the pull at the value that only just started the block moving, it does not creep along at a steady speed. It speeds up, because that pull is now bigger than the friction acting on it.
Easing off and stopping
Press Ease while the block slides to lower the pull. While the pull is still bigger than , the block keeps speeding up, just more gently. As the pull falls past the forces balance for an instant, so the block is at its top speed: the highest point of the velocity–time graph, where the line is flat for a moment. Below the resultant force points backwards and the block slows down. (A pull held at exactly would keep it at a steady speed.) Once it stops, friction becomes static again and simply matches whatever pull is left, so the block stays still rather than being dragged backwards. To set it moving again you have to pull harder than once more.
Mass and surfaces
Masses stacked on top raise the normal contact force, so the limit and the kinetic friction both grow in proportion. Choosing different surfaces changes the coefficients instead. The rubber, wood and ice values here are typical figures chosen for teaching, not measurements. Real coefficients depend on how clean, dry and smooth the surfaces are.
Friction in your course
Courses at this level, such as AQA GCSE, Cambridge IGCSE and Punjab Class 9, usually describe friction in words and do not ask you to calculate with or . The simulation uses the coefficients so that the numbers work out. The names vary too. Some books use sliding friction to mean kinetic friction only. Others use sliding friction for all friction between solid surfaces, with static and kinetic friction as its two kinds.