Sections 6.7 and 6.8 in brief
Section 6.7 measures air pressure with a mercury barometer, and section 6.8 measures the pressure of a gas supply with a U-tube manometer. Both rest on from Pressure in liquids, which you must recall. The pressure of the air itself is explained on the Atmospheric pressure page.
Building a mercury barometer
- Take a strong glass tube roughly 1 m in length, sealed at one end, and fill it to the brim with mercury.
- Seal the open end, turn the tube over and put that end under the mercury in a dish. Hold the tube upright and unseal it.
- The mercury in the tube sinks, then stops. At sea level the top of the column stands about 760 mm above the surface in the dish, measured with a scale fixed alongside.
The space above the column is very nearly a vacuum, so the top of the column feels almost no pressure.
Why the column stays up. Choose point A inside the tube and point B on the open surface in the dish, both at the same level. In one liquid at rest, points at the same level have the same pressure. At B the atmosphere presses on the mercury. At A the only pressure is due to the mercury column standing above it. Therefore
where is the vertical height of the column above the surface in the dish.
Worked numerical 1: the mercury column
What height of mercury () will standard atmospheric pressure hold up? Take .
The book's 760 mm comes from the real value of g, about 9.8 m s⁻²:
Rounding g to 10 makes h about 2% smaller, so use whichever g the question gives.
Worked numerical 2: a water barometer
Could water replace mercury? Both columns balance the same air pressure, so . The g cancels:
Such a tall tube is impractical. The mercury column is 13.6 times shorter, small enough for a laboratory bench.
What changes the reading
- A wider tube: no change, because contains no area.
- A tilted tube: mercury runs further along the tube, but the vertical height stays the same.
- Air trapped above the column: it presses down on the mercury, so the column is shorter than it should be.
- A leak at the closed end: air enters and the column falls until it is level with the dish.
- Height and weather: the column is shorter on a mountain. Steadily dropping pressure often comes before rain.
The U-tube manometer
A manometer is a glass tube bent into a U and partly filled with liquid, usually mercury. With both arms open to the air, the two surfaces are level. Join one arm to a gas supply and keep the other open. Whichever side has the greater pressure forces its liquid surface downwards.
If the liquid in the open arm stands higher by , the gas pressure is above atmospheric:
If the open arm stands lower by , the air pushes harder than the gas, so . Equal levels mean the gas is at atmospheric pressure.
Worked numerical 3: a gas cylinder
A mercury manometer is connected to a gas cylinder. The mercury in the open arm stands 12 cm above the mercury in the arm joined to the cylinder. Atmospheric pressure is Pa and . Find the gas pressure.
Had the open arm been 12 cm lower, the answer would be Pa.
Exploring the barometer and manometer
In the simulation above, choose Barometer from the scene menu.
- Press Play. The mercury sinks to 760 mm. The working multiplies 13 600 × 10 × 0.760 to give about Pa, 2% above the true value because g is rounded.
- Switch on Compare with a water barometer and press Play again. The water column, drawn beside a house, settles at 10.3 m.
- Use Go to… to visit Everest, 8.8 km. The mercury column shrinks to 238 mm.
- Pick Sea level from Go to…, then switch the scene menu to Manometer and press Play: the tap opens. The gas starts 10 kPa above the air, so Level difference reads 75.0 mm and the working gives about Pa.
- Drag Gas pressure compared with the air below zero. Now the open arm stands lower: the gas is below atmospheric pressure.
To watch the pressure of a liquid column grow with depth, open the liquid pressure and depth simulation.