Skip to content

GCSE Physics — AQA · Forces

Atmospheric pressure

4.5.5.2Physics only

GCSE Physics only, both tiers. The atmosphere is a thin layer of air, densest near the ground. Atmospheric pressure, about 100 kPa at sea level, comes from air molecules hitting surfaces. Higher up, less air sits over a surface: less weight of air and fewer collisions, so the pressure is lower.

Loading simulation…

Symbols match your course. Open the full atmospheric pressure and altitude simulation for more presets and teacher tools.

Who needs this: GCSE Physics only

Spec point 4.5.5.2 is GCSE Physics only (not Combined Science), examined on both tiers, with no equation. You should be able to:

  • picture the Earth's air as a model: a thin layer, densest at the bottom
  • say how moving air molecules produce atmospheric pressure
  • give the reason the pressure is lower the higher up a surface is.

Barometers, manometers and the collapsing can are not named by AQA and appear here only as context.

The atmosphere: a thin layer

Gravity holds a layer of air around the Earth. Almost all of it sits in the lowest 30 km or so, while the Earth's radius is about 6400 km. Shrink the Earth to a globe 30 cm across and its air would be under 1 mm thick, like a coat of paint.

Air at the bottom is squashed by the weight of everything resting on it, so it is the densest. Higher up, each cubic metre holds fewer molecules: density falls as height increases.

Where the push comes from

Air molecules move quickly in random directions. Each one that strikes a surface and bounces off gives it a tiny push. Vast numbers of hits each second combine into a steady force. That force per square metre of surface is the atmospheric pressure. Because molecules arrive from every side, the air presses on a surface whichever way it faces, always at right angles to it.

At sea level the pressure is about 100 kPa (100 000 Pa). You are not flattened because the fluids inside your body push outwards just as hard.

Why the pressure falls as you climb

On a mountain top, compared with sea level:

  1. Above the summit there is less air: fewer molecules, so a smaller weight of air pressing down.
  2. With less weight on top, the air at the summit is squashed less, so it is less dense.
  3. Fewer molecules per cubic metre means fewer hits on each square metre of the surface every second.
  4. Fewer hits per second give a smaller force on each square metre, so the pressure is lower.

So the pressure keeps dropping with height, fastest near the ground, where the air is densest.

Worked example: sea level and Everest. Pressure is about 100 kPa at sea level and about 34 kPa, roughly a third as much, on the summit of Everest (approximate measured values). Use p=FAp = \dfrac{F}{A} (4.5.5.1.1, learn it by heart) to find the force of the air on 1.0 cm² at each place.

Given: A=1.0A = 1.0 cm² =1.0×10−4= 1.0 \times 10^{-4} m². Equation: F=pAF = pA. Sea level: F=100 000×1.0×10−4=10F = 100\,000 \times 1.0 \times 10^{-4} = 10 N. Everest: F=34 000×1.0×10−4=3.4F = 34\,000 \times 1.0 \times 10^{-4} = 3.4 N.

Why: about two thirds of the air lies below the summit, so only a third of its weight presses down there.

Beyond the specification: barometers, cans and manometers

  • Mercury barometer: a tube sealed at the top stands with its open end in a dish of mercury. Above the column is almost a vacuum, so the air pressing on the dish holds up about 760 mm of mercury at sea level.
  • Collapsing can: a can holding a little boiling water is sealed and cooled. The steam condenses, so the outside air pushes in harder than the leftover gas pushes out, crushing the can. Nothing sucks the walls in.
  • Manometer: in a U-tube of liquid, the side at higher pressure pushes its liquid surface down.

Barometer and manometer readings use p=hρgp = h\rho g (pressure and depth in a liquid, Higher tier only). That equation cannot give the whole atmosphere's pressure, because air's density changes with height.

Climbing with the simulation

In the simulation above, a weather balloon waits at sea level. Air pressure reads 101.3 kPa and Air density 1.225 kg/m³. On a phone, these cards are under the Readings tab.

  1. Predict how both readings will change, then press Play. The balloon rises to 15 km and Air still above you shrinks.
  2. Look at the graphs (on a phone, open the Graphs tab). Pressure and density both fall, steeply at first and then more gently.
  3. When the climb stops, choose Everest, 8.8 km from Go to…. Pressure reads 31.7 kPa, a model value slightly below real measurements. Weight of air above each square centimetre has fallen from 10.1 N to 3.17 N, and the crisp packet is stretched taut.
  4. Context only: choose Barometer from the scene menu, pick Sea level from Go to… and press Play. The column drops to 760 mm, and the working turns that height into 1.01×1051.01 \times 10^5 Pa.

Common mistakes

  • Writing only that the air is 'thinner' higher up. Link it to fewer molecules hitting each square metre every second, and to a smaller weight of air above the surface.
  • Blaming weaker gravity for the lower pressure on a mountain. Gravity hardly changes over a few kilometres; the pressure is lower because less air lies above the surface.
  • Saying a collapsing can is 'sucked in'. The gas inside still pushes out, just far less strongly than the outside air pushes in.
  • Thinking that atmospheric pressure only pushes downwards. Molecules strike from every side, so the air pushes on surfaces facing any way, always at right angles to them, including upwards on the underside of an object.
  • Assuming the pressure drops by the same amount for each kilometre climbed. It falls fastest near the ground, where the air is densest, and more slowly higher up.
  • Describing the atmosphere as thick. Nearly all of its air is packed into a depth of a few tens of kilometres, a tiny fraction of the 6400 km radius of the Earth.

Exam-style questions

Original questions written in the style of GCSE AQA. Try each one before you reveal the answer.

  1. 1.GCSE Physics only. The table gives the atmospheric pressure at different heights above sea level. 0 km: 101 kPa. 2 km: 80 kPa. 4 km: 62 kPa. 6 km: 47 kPa. 8 km: 36 kPa.

    1. (a)Describe the pattern shown by the data.

      2 marks
      Show the answer

      Answer: The pressure decreases as the height increases. The drop for each 2 km gets smaller: 21 kPa between 0 km and 2 km, but only 11 kPa between 6 km and 8 km.

      Marking points

      • Pressure decreases as height increases.
      • The decrease for each 2 km becomes smaller as height increases (data quoted, e.g. 21 kPa then 11 kPa).
    2. (b)A town is 1.0 km above sea level. Estimate the atmospheric pressure in the town.

      1 mark
      Show the answer

      Answer: About 90 kPa (accept 88–92 kPa).

      Marking points

      • Any value from 88 kPa to 92 kPa.
    3. (c)A tent has a flat panel of area 2.5 m². Calculate the force of the atmosphere on one side of the panel when the tent is pitched 6 km above sea level.

      3 marks
      Show the answer

      Answer: p = 47 kPa = 47 000 Pa. F = pA = 47 000 × 2.5 = 117 500 N (about 1.2 × 10⁵ N).

      Marking points

      • 47 kPa converted to 47 000 Pa.
      • F = 47 000 × 2.5
      • F = 117 500 N (accept 1.2 × 10⁵ N).
    4. (d)Explain why the panel is not pushed in by this large force.

      2 marks
      Show the answer

      Answer: The air inside the tent is at almost the same pressure. It pushes back on the inner side of the panel just as hard, so the two forces cancel and the resultant force is about zero.

      Marking points

      • Air on the other side of the panel exerts an (almost) equal force in the opposite direction.
      • So the resultant force is (about) zero.
  2. 2.GCSE Physics only. The radius of the Earth is about 6400 km. Almost all of the air in the atmosphere lies within 30 km of the ground.

    1. (a)Calculate the depth of this layer of air as a percentage of the Earth's radius.

      2 marks
      Show the answer

      Answer: (30 ÷ 6400) × 100 = 0.47%

      Marking points

      • (30 ÷ 6400) × 100
      • 0.47% (accept 0.5%)
    2. (b)Use your answer to explain why the atmosphere is modelled as a thin layer.

      1 mark
      Show the answer

      Answer: The air is less than 1% as deep as the Earth's radius, so next to the Earth it is a very shallow covering.

      Marking points

      • Its depth is tiny (under 1%) compared with the size of the Earth.
    3. (c)Describe how the density of the air changes as the height above the ground increases. Give a reason for this change.

      2 marks
      Show the answer

      Answer: The density decreases with height. The lowest air is squeezed by the air resting on top of it, so it has more molecules in each cubic metre.

      Marking points

      • Density decreases as height increases.
      • Air lower down is squeezed by the air resting on it (so it has more molecules per cubic metre).
    4. (d)A bag of crisps, sealed in a factory near sea level, is taken up a high mountain. The bag swells up. Explain why.

      3 marks
      Show the answer

      Answer: Atmospheric pressure falls as the bag is carried higher. The gas inside the bag stays at its sea-level pressure at first, so it pushes outwards harder than the air outside pushes inwards. The gas expands and stretches the bag until the pressures balance or the bag is tight.

      Marking points

      • Atmospheric pressure outside the bag decreases with height.
      • The gas inside is at a higher pressure than the air outside (it pushes out harder than the air pushes in).
      • So the gas expands and the bag swells (until the pressures are equal or the bag is taut).
  3. 3.GCSE Physics only. An airliner cruises 11 km above sea level, where the air pressure outside is 23 kPa. The air in the cabin is kept at 75 kPa. One cabin window has an area of 0.060 m².

    1. (a)Explain why the air pressure at 11 km is much lower than at sea level.

      3 marks
      Show the answer

      Answer: At 11 km there is much less air above, so the weight of air pressing down is smaller. The air is less dense, with fewer molecules in each cubic metre. So fewer molecules strike each square metre of a surface every second, and the force per unit area is smaller.

      Marking points

      • Fewer air molecules above, so a smaller weight of air pressing down.
      • The air is less dense: fewer molecules per unit volume.
      • Fewer collisions with a surface per second, so a smaller force per unit area.
    2. (b)Calculate the resultant force on the window caused by the difference in pressure, and give its direction.

      4 marks
      Show the answer

      Answer: Difference in pressure = 75 − 23 = 52 kPa = 52 000 Pa. F = pA = 52 000 × 0.060 = 3120 N (about 3100 N), acting outwards, from the cabin towards the outside air.

      Marking points

      • Difference in pressure = 52 kPa = 52 000 Pa.
      • F = 52 000 × 0.060
      • F = 3120 N (accept 3100 N).
      • Direction: outwards (from the cabin to the outside).
  4. 4.GCSE Physics only. A weather balloon carries a pressure sensor from sea level up to a height of 10 km. The sensor reads about 100 kPa at sea level and about 26 kPa at 10 km.

    1. (a)Explain why the pressure reading falls as the balloon rises. In your answer, describe what the atmosphere is like and how air molecules produce atmospheric pressure.

      6 marks
      Show the answer

      Answer: Compared with the size of the Earth, the air forms only a shallow covering. Air molecules move randomly and collide with any surface, including the sensor. Each collision exerts a small force, and the total force on each unit of area is the atmospheric pressure. The air nearest the ground is squeezed by everything on top of it, so it is densest there, and its density decreases with height. As the balloon rises there is less air, and so less weight of air, above the sensor. With fewer molecules in each cubic metre, fewer of them hit the sensor each second, so the force per unit area, and the reading, falls. (Level-of-response marking: the answer is placed in a level as a whole, then given a mark within that level. Level 3, 5–6 marks: a full, logical chain from the thin layer and molecular collisions to less air above and a lower pressure. Level 2, 3–4 marks: some correct links, for example less air above giving a lower pressure. Level 1, 1–2 marks: isolated correct points, for example that the air is thinner high up. No relevant content: 0 marks.)

      Marking points

      • Model: the air is a shallow covering, thin next to the radius of the Earth.
      • Air molecules move randomly and collide with surfaces such as the sensor.
      • Each collision exerts a force; the total force per unit area is the atmospheric pressure.
      • Air is densest near the ground (squeezed by the air on top) and its density decreases with height.
      • As the balloon rises there is less air above the sensor, so less weight of air.
      • Fewer molecules per unit volume, so fewer collisions per second on the sensor: smaller force per unit area, so lower pressure.

Quick check

6 questions

  1. 1.What produces the pressure that the atmosphere exerts on the wall of a room?
  2. 2.How does the density of the atmosphere change as the height above sea level increases?
  3. 3.Which statement best explains why the air pressure on a mountain summit is less than at sea level?
  4. 4.At a height of 5.5 km the air pressure is about 50 kPa. What force does the air exert on a flat surface of area 2.0 m² at that height?
  5. 5.Compared with the radius of the Earth, the layer that contains almost all of the atmosphere is:
  6. 6.A walker drinks from a plastic bottle at the top of a mountain, screws the cap on tightly and carries the bottle down to sea level. What happens to the bottle?