Where this fits in AQA
Spec point 4.5.6.1.1 has no equation to learn. It is on both tiers, and GCSE Physics and Combined Science students all need it. It builds on scalars and vectors (4.5.1.1) and leads into speed, velocity and distance–time graphs. Every displacement you write needs a size and a direction.
Same trip, two measurements
Distance is the length of the route actually covered, bends and backtracks included. It carries no direction, which makes it a scalar. It starts at zero and can never go down, so it is never negative.
Displacement ignores the route. Rule a straight line from where the trip begins to where it ends: its length is the size of the displacement, and the way it points gives the direction. Having a direction makes displacement a vector. Both quantities are measured in metres.
| Question to ask | Distance | Displacement |
|---|---|---|
| Does the route matter? | Yes, every metre counts | No, only the start and finish points |
| A complete answer looks like | 850 m | 420 m due south |
| After a trip back to the start | More than zero | Zero |
Stating the direction
Along a line, pick one direction as positive and write it down, for example "east is positive". A minus sign then means the opposite way. On a map, use a compass direction or an angle from a named line, such as 37° east of north.
Beyond the specification: bearings use three figures and turn clockwise from north, so due east is 090° and due west is 270°. They belong to GCSE Maths; the AQA Physics specification does not mention them.
Worked example 1: turning back on a beach
A dog runs 45 m east along a straight beach, then 60 m west. East is positive.
Distance:
Displacement: , so the dog ends 15 m west of its start.
If the run lasts 35 s, the average speed uses the whole distance: .
Worked example 2: two legs at right angles
A student crosses a playground, walking 30 m due east and then 40 m due north.
Distance:
Displacement (Higher tier: scale drawing): the legs point different ways, so do not just add them. At 1 cm to 10 m, draw 3.0 cm east, then 4.0 cm north from the end of that arrow. Rule a line from the first tail to the final head: it measures 5.0 cm, which is 50 m. A protractor at the start reads 37° from north towards east.
Answer: 50 m at 37° east of north (a bearing of 037°).
Scale drawings of vectors are Higher-tier work in 4.5.1.4, where AQA sets them for forces. Pythagoras from maths confirms the size, , but the physics specification does not list it.
Worked example 3: laps of a track
An athlete runs two laps of a 400 m track in 160 s and stops on the start line. The distance is 800 m, so the average speed is . The displacement is zero, because the finish point is the start point.
Higher tier only (4.5.6.1.3): on each bend the direction of travel keeps turning, so the velocity changes even at a steady speed. Beyond the specification: average velocity, which is displacement ÷ time, is zero here.
Simulation checks
In the simulation above, the L-shaped walk opens already finished. Distance travelled reads 70.0 m and Displacement reads 50.0 m at 037°, because Direction as starts on Bearing for GCSE. Press Angle from N–S to see 36.9° east of north instead.
- Press Walk. The two bars below the cards stay level along the first leg and separate after the corner.
- Press Line under the stage, then pick Back past the start from Example. The walk starts straight away and ends at −8.00 m, "8.00 m west of the start", after 32.0 m.
- Slide Stop at each turn to 10 s. The distance is unchanged but the time grows, so Average speed drops from 1.50 m/s to 1.02 m/s.
- (Higher tier) Press Map and pick Round the running track (400 m). The pace holds at 3 m/s while the direction swings right round, so the velocity changes. At the finish: 400 m travelled, zero displacement.
The Average velocity card goes beyond AQA.