Skip to content

Matter and pressure simulation

Liquid Pressure and Depth Simulation

Move a pressure probe through a tall tank of liquid and watch the gauge and a pressure–depth graph respond. Compare liquids, see the pressure push equally in every direction, then unplug three holes and find out which jet lands furthest, and why.

Loading simulation…
Show symbols for

Predict first

Question 1 of 4

A tank holds water 1.0 m deep and stands in a tray. It has holes 0.2 m, 0.5 m and 0.8 m above its base, and a tap keeps it full. When the bungs come out, which jet lands furthest from the tank?

Try this

  1. 1Before you press Play, read the gauge with the probe at its starting depth of 0.50 m. Work out the pressure yourself from depth × density × g, then check it against the Pressure at the probe readout.
  2. 2Drag the probe down 0.20 m at a time and note each gauge reading. Then use the gradient tool on the Pressure against depth graph and compare the gradient with ρg.
  3. 3Predict which of the three jets will land furthest, then press Play to pull out the bungs. Set the Stand under the tank to 0.6 m and try again.
  4. 4Choose Mercury from the Liquid menu. Which readings become 13.6 times bigger, and which values in the jets table stay exactly the same?
  5. 5Press Top up to turn the tap off, then press Play. Watch the gauge, the level and the jets as the tank empties.

A tank, a probe and three jets

A tall glass tank holds a liquid, with a pressure probe hanging inside it on a thin rod. A rubber tube carries the pressure from the probe up to a dial gauge. Three holes in the right-hand wall stay plugged with rubber bungs until you press Play. A tap above the tank can keep the level steady while liquid pours out of the holes.

You choose the liquid, how deep it is, how tall a stand the tank sits on and where the probe is. The gauge, the readouts and the graph all respond straight away, even before the jets are running.

What the gauge measures

The gauge shows the extra pressure caused by the liquid above the probe. For a probe a depth h below the surface of a liquid of density ρ, where the gravitational field strength is g, that pressure is p=hρgp = h\rho g. With water, g = 9.8 N/kg and the probe 0.50 m down, the gauge reads 0.50 × 1000 × 9.8 = 4900 Pa.

Picture a slim column of liquid resting on a tiny patch of the probe. Lower the probe and the column above that patch gets taller and heavier, so it presses harder. Swap in a denser liquid and the same column carries more mass, so the pressure rises again. Your syllabus may write the same idea as p = ρgh, Δp = ρgΔh or P = ρgh.

The option for atmospheric pressure adds the push of the air on the surface, about 1.01×1051.01 \times 10^5 Pa. It adds the same amount at every depth, so the total pressure grows by exactly as much as the gauge reading does.

A straight line through the origin

On the pressure against depth graph, each liquid gives a straight line that starts at zero. Pressure is proportional to depth. Drag along a line with the gradient tool and you will find its gradient is ρg: about 9800 Pa for every metre of water, and 13.6 times that for mercury. A teacher can hide the density, leaving you to work it out from the gradient.

Equal in every direction, whatever the shape

The eight arrows round the probe always match in length. At a point in a liquid that is not flowing, pressure acts equally upwards, downwards and sideways.

The connected vessels below the stage make a second point. A wide tank, a funnel, a thin tube and a sloping tube are joined at the bottom. The liquid settles at one level in all four, and at the probe's depth the pressure is identical in each one. The vertical depth below the surface is all that matters. The funnel holds far more liquid than the thin tube, but its sloping walls carry much of that weight.

Extension: how fast, and how far?

Every jet leaves the wall at right angles, which is the sideways push made visible. Deeper holes give faster jets. With no friction, the speed is v=2gdv = \sqrt{2gd}, where d is the depth of the hole below the surface. This result goes beyond most courses for ages 14 to 16. Density cancels out of it, so mercury and water jets from the same depth leave equally fast.

Outside the tank, each jet is a projectile. It keeps its sideways speed while it drops the height H to the tray, landing at x=v2H/gx = v\sqrt{2H/g}. With the tank full and standing in the tray, the bottom jet is quickest but has the shortest fall, so the middle jet reaches furthest. Put the tank on a 0.6 m stand, or keep it in the tray with the liquid less than 0.7 m deep, and the bottom jet takes the lead. That is why the speed of a jet, rather than where it lands, is the fair test of pressure.

Switch the tap off and the level drops as the tank empties. Every jet slows and shortens, and the top hole is the first to run dry.

Equations

  • Pressure

    p=FA

    pressure = force normal to a surface ÷ area of that surface

    Open calculator →
  • Pressure in a liquid

    p=hρg

    pressure due to a column of liquid = height of column × density of liquid × gravitational field strength

    Open calculator →

Check your understanding

8 questions

  1. 1.A diver swims 3.0 m below the surface of a freshwater lake. Use 1000 kg/m³ for the water's density and 9.8 N/kg for g. Find the pressure on the diver due to the water.
  2. 2.Which change doubles the pressure due to a liquid at a point inside it?
  3. 3.A graph of the pressure due to a liquid (y-axis) against depth (x-axis) is a straight line through the origin. What is its gradient?
  4. 4.A narrow tube and a wide tank are filled with the same oil to the same depth. How do the pressures on their bottoms compare?
  5. 5.A probe 0.40 m below the surface of a liquid reads 3600 Pa, where g is 10 N/kg. Which density does the liquid have?
  6. 6.Water spurts from small holes at different heights in the side of a tall can. How does it leave each hole?
  7. 7.Atmospheric pressure is about 1.0 × 10⁵ Pa. Roughly how deep in fresh water (g = 9.8 N/kg) does the water add the same amount of pressure again?
  8. 8.A tank of water stands in a tray. The jet from its middle hole lands further away than the jet from its lowest hole. Why?

For teachers

Embed it in your site or open it full-screen for the projector.

Read more