What a free-body diagram shows
A free-body diagram is a sketch of one body with every force that acts on it, and nothing else. The body is drawn as a small box or a dot. Each force is an arrow that starts at the centre of the box and points outwards, in the direction the force acts. Your textbook calls it a special case of a vector diagram, because every arrow stands for a vector.
Each arrow carries three pieces of information:
- the arrowhead shows which way the force acts;
- the length shows how big the force is, so a force twice as large gets an arrow twice as long;
- the label says which force it is (weight, friction, tension, normal force and so on), often with its value in newtons.
A good diagram lets an examiner see at a glance which forces balance and which do not.
Drawing one step by step
- Choose the single body you are studying and draw it as a box.
- Draw its weight first: an arrow straight down from the centre, .
- Look for everything that touches the body. A surface gives a normal force, and friction if the body slides or tries to slide. A rope gives tension. Moving air gives air resistance.
- Add any other non-contact force, such as a magnet's pull.
- Give equal forces equal arrows, and make a bigger force a longer arrow.
- Leave out forces that the body exerts on other things. A trunk presses down on the floor, but that force acts on the floor, so it belongs on the floor's diagram, not the trunk's.
Diagrams for everyday bodies
| Body | Forces to draw |
|---|---|
| A ceiling fan hanging still, switched off | Weight down; pull of the rod up, the same length |
| A bucket lifted from a well at a steady speed | Weight down; tension in the rope up, the same length |
| A rickshaw moving steadily on a level road | Weight down, normal force up; driving force forward, friction and air resistance backward |
| A stone falling, with air resistance ignored | Weight down only |
From the diagram to the resultant force
Once all the arrows are drawn, treat the vertical and horizontal forces separately. Forces pointing the same way add. Forces pointing opposite ways subtract, and their resultant points the way of the larger one. If both totals are zero the forces are balanced. If not, the resultant force gives the acceleration through .
Worked numerical
A crate of mangoes of mass 25 kg is dragged across a level floor at a Multan fruit market by a horizontal rope. The tension in the rope is 120 N and the friction on the crate is 70 N. Draw the free-body diagram, then find the resultant force and the acceleration. Take .
Forces on the crate:
- weight: , downwards
- normal force from the floor: 250 N, upwards (the crate does not rise or sink)
- tension: 120 N, forwards
- friction: 70 N, backwards
Vertical: , so there is no vertical resultant.
Horizontal:
The crate speeds up at in the direction of the pull.
Building diagrams in the simulation
In the simulation above, the crate in Pushing a crate is already drawn as a free-body diagram with the Scale grid on. Read the scale printed on the picture and use the squares to estimate each arrow, then compare with the chips under Forces: 20.0 N, 20.0 N, 12.0 N and 8.00 N. The red arrow is the resultant, 4.00 N to the right, and the Horizontal total and Vertical total readouts show how it was found.
Now rebuild the mango crate. Choose Empty: add your own forces and press Add four times. For each arrow, pick a Name, type its value in Size (N) and set its direction with Point it. The readouts should give a Resultant force of 50.0 N and a Direction of 0°. Set Mass to 25 kg and press What next?: after 3 s the speed reads 6.00 m/s, as predicts.
Then switch View to Vector diagram to see the same forces joined tip to tail.