Skip to content

BISE Gujranwala · Punjab Class 9

BISE Gujranwala Annual 2023 Class 9 Physics (Objective, Group II) (5474)

Set by BISE Gujranwala for Punjab Class 9 Physics, Annual 2023: 15 minutes and 12 marks, on Physical quantities and measurements, Kinematics, Dynamics, Turning effects of force, Work, energy and power, Mechanical properties of matter, Thermal properties of matter, Nature of science. The paper itself is on BISE Gujranwala’s website; this page adds what it covers, how to use it and original practice questions on the same topics.

Paper facts

Series
Annual 2023
Paper
Objective, Group II
Set by
BISE Gujranwala
Code
5474
Tier
Not tiered
Time
15 minutes
Marks
12
Calculator
Not recorded here: check the paper’s instructions
Syllabus
Old Punjab syllabus (PCTB Physics 9 used until the 2024-25 session), not the NC 2023 book. Some questions, such as satellites and heat transfer, are not in the new course.
Links checked
17 November 2026

Official files

These files belong to BISE Gujranwala. Labverse links to them and never hosts or copies them. Labverse is not affiliated with BISE Gujranwala.

What this paper covers

8 topic groups from our map of Punjab Board Class 9 Physics. Revise each one with its topic pages and simulations before you sit the paper.

How to use this paper

  1. 1. Time it. Set 15 minutes for 12 marks: about 75 seconds a mark. At 8 minutes you should be roughly halfway through the marks; if you’re well behind, speed up on the short questions.
  2. 2. Sit it in one go. Open the question paper on BISE Gujranwala’s website (the link above) and work on paper, with no notes.
  3. 3. Mark it with the official scheme. The mark scheme isn’t public, so check answers with your teacher, and use the marking points on our questions below to practise marking.
  4. 4. Learn from the marks you lost. For every lost mark, note whether it was knowledge, method, reading the question or time.
  5. 5. Log mistakes by topic. Keep one line per topic group (Physical quantities and measurements, Kinematics, Dynamics, Turning effects of force, Work, energy and power, Mechanical properties of matter, Thermal properties of matter, Nature of science) and add a tally each time a mark goes there.
  6. 6. Revisit, then redo. Work through the weakest group’s topic pages and simulations, try the questions below, and come back to the paper in a week.

Practise the same topics

8 original exam-style questions on this paper’s topics, written in the style of Punjab board exams (not taken from the paper). Try each one before you reveal the answer.

  1. 1.Write each quantity using a suitable prefix.

    From the topic: Prefixes and scientific notation

    1. (a)6.5 × 10⁻⁷ m

      1 mark
      Show the answer

      Answer: 650 nm (or 0.65 µm)

      Marking points

      • 650 nm (allow 0.65 µm)
    2. (b)4.2 × 10⁷ W

      1 mark
      Show the answer

      Answer: 42 MW

      Marking points

      • 42 MW
    3. (c)3 × 10⁻¹² s

      1 mark
      Show the answer

      Answer: 3 ps

      Marking points

      • 3 ps
    4. (d)2.5 × 10⁴ g

      1 mark
      Show the answer

      Answer: 25 kg

      Marking points

      • 25 kg
  2. 2.A boat sails at 12 m/s in a direction 40° east of north.

    From the topic: Scalars and vectors

    1. (a)Using a scale of 1 cm = 2 m/s, find the length of the representative line.

      1 mark
      Show the answer

      Answer: 12 ÷ 2 = 6.0 cm.

      Marking points

      • 6.0 cm
    2. (b)Taking east as the positive x-axis, find the angle the velocity makes with it, measured anticlockwise.

      1 mark
      Show the answer

      Answer: 90° − 40° = 50°.

      Marking points

      • 50°
    3. (c)Describe how to draw the representative line of this velocity.

      3 marks
      Show the answer

      Answer: Draw north–south and east–west lines crossing at a point O. From O, draw a line 6.0 cm long at 40° from north towards east (50° from east). Put an arrowhead at the far end and label it v.

      Marking points

      • Reference lines (N–S and E–W, or x and y axes) crossing at O
      • 6.0 cm line from O at 40° east of north (or 50° from the x-axis)
      • Arrowhead at the far end, showing the direction
  3. 3.A 1000 kg car is moving at 20 m s⁻¹ when its brakes are applied. The net braking force on the car is 4000 N and stays constant until it stops.

    From the topic: Newton's second law

    1. (a)Calculate the deceleration of the car.

      2 marks
      Show the answer

      Answer: a = F ÷ m = 4000 ÷ 1000 = 4 m s⁻² (a deceleration, so −4 m s⁻² taking the motion as positive).

      Marking points

      • a = F ÷ m = 4000 ÷ 1000
      • 4 m s⁻² deceleration (−4 m s⁻²)
    2. (b)Calculate the time taken to stop.

      2 marks
      Show the answer

      Answer: vf = vi + at, so 0 = 20 + (−4)t, giving t = 5 s.

      Marking points

      • 0 = 20 − 4t
      • t = 5 s
    3. (c)Calculate the distance travelled while braking.

      2 marks
      Show the answer

      Answer: 2aS = vf² − vi², so 2(−4)S = 0 − 20², giving S = 400 ÷ 8 = 50 m.

      Marking points

      • Uses 2aS = vf² − vi² (or S = vi t + ½at²)
      • 50 m
  4. 4.The gravitational field strength g is not exactly the same everywhere.

    From the topic: Mass, weight and balances

    1. (a)What is meant by gravitational field strength?

      1 mark
      Show the answer

      Answer: The gravitational force acting on a unit mass (1 kg) placed in the field.

      Marking points

      • Gravitational force per unit mass / on 1 kg
    2. (b)On another planet, a 4.0 kg block hung from a force meter gives a reading of 14.8 N. Calculate g on that planet.

      2 marks
      Show the answer

      Answer: g = w ÷ m = 14.8 N ÷ 4.0 kg = 3.7 N/kg.

      Marking points

      • g = w ÷ m = 14.8 ÷ 4.0
      • 3.7 N/kg
    3. (c)A climber carries a 15 kg rucksack from Skardu up to the summit of K2. Explain what happens to the mass and to the weight of the rucksack.

      3 marks
      Show the answer

      Answer: The mass stays 15 kg, because the amount of matter does not change. The value of g decreases with height, so w = mg becomes slightly smaller at the summit.

      Marking points

      • Mass unchanged (15 kg)
      • g decreases with altitude
      • So the weight (w = mg) decreases slightly
  5. 5.Doors, taps and spanners all rely on the turning effect of a force.

    From the topic: Torque (moment of force) and couple

    1. (a)Define torque and write its SI unit.

      2 marks
      Show the answer

      Answer: Torque (moment of force) is the product of the force and its moment arm, τ = F × ℓ. Its SI unit is the newton metre (N m).

      Marking points

      • Torque = force × moment arm (perpendicular distance from the axis to the line of action)
      • Unit N m
    2. (b)Explain why a door handle is fixed far from the hinges.

      2 marks
      Show the answer

      Answer: Torque = force × moment arm. A handle far from the hinges has a large moment arm, so a small force produces enough torque to turn the door.

      Marking points

      • Large moment arm (distance from the axis/hinges)
      • Less force needed for the same torque
  6. 6.A student is given a piece of cardboard cut into an irregular shape, a stand with a pin, a plumb line and a pencil.

    From the topic: Centre of mass and centre of gravity

    1. (a)Describe how the student can find the centre of gravity of the cardboard.

      4 marks
      Show the answer

      Answer: Make three small holes close to the rim of the card. Hang the card from the pin through one hole so that it swings freely, and hang the plumb line from the same pin. When both are at rest, mark the line of the plumb line on the card. Repeat with a second hole; the centre of gravity is where the two lines cross. A third hole gives a check, since its line also goes through G.

      Marking points

      • Card hung freely from the pin through a hole near its edge
      • Plumb line hung from the same pin; its line marked on the card when at rest
      • Repeated from a second hole
      • G is where the lines cross (third hole as a check)
    2. (b)Explain why the centre of gravity of the card lies on the plumb line.

      2 marks
      Show the answer

      Answer: A freely hanging card comes to rest only when its weight has no moment about the pin. This happens when the centre of gravity is directly below the pin, on the vertical plumb line.

      Marking points

      • At rest, the weight has no moment about the point of suspension
      • So G is vertically below the pin, on the plumb line
  7. 7.An electric motor has an efficiency of 75%. Its useful power output is 900 W.

    From the topic: Efficiency

    1. (a)Calculate the total power input to the motor.

      2 marks
      Show the answer

      Answer: 75 = (900 ÷ input) × 100, so input = 900 × 100 ÷ 75 = 1200 W.

      Marking points

      • Input = 900 × 100 ÷ 75
      • 1200 W
    2. (b)Calculate the energy wasted by the motor in 1 minute.

      2 marks
      Show the answer

      Answer: Power wasted = 1200 − 900 = 300 W. Energy wasted in 60 s = 300 × 60 = 18 000 J.

      Marking points

      • Power wasted = 300 W
      • 300 × 60 = 18 000 J
  8. 8.A jeweller tests a bangle that is said to be pure gold. The bangle has a mass of 38.6 g. When it is lowered into a measuring cylinder of water, the reading rises from 25.0 cm³ to 27.0 cm³. The density of pure gold is 19 300 kg m⁻³.

    From the topic: Density

    1. (a)Find the volume of the bangle.

      1 mark
      Show the answer

      Answer: V = 27.0 cm³ − 25.0 cm³ = 2.0 cm³.

      Marking points

      • 27.0 − 25.0 = 2.0 cm³
    2. (b)Calculate the density of the bangle in kg m⁻³.

      2 marks
      Show the answer

      Answer: ρ = m/V = 38.6 g ÷ 2.0 cm³ = 19.3 g cm⁻³ = 19 300 kg m⁻³.

      Marking points

      • 38.6 ÷ 2.0 = 19.3 g cm⁻³
      • 19 300 kg m⁻³
    3. (c)Could the bangle be pure gold? Give a reason.

      1 mark
      Show the answer

      Answer: Yes. Its density is the same as the density of pure gold.

      Marking points

      • Yes, its density equals that of pure gold