Skip to content

BISE Gujranwala · Punjab Class 9

BISE Gujranwala Annual 2023 Class 9 Physics (Subjective, Group II)

Set by BISE Gujranwala for Punjab Class 9 Physics, Annual 2023: 1 hour 45 minutes and 48 marks, on Physical quantities and measurements, Kinematics, Dynamics, Turning effects of force, Work, energy and power, Mechanical properties of matter, Thermal properties of matter, Nature of science. The paper itself is on BISE Gujranwala’s website; this page adds what it covers, how to use it and original practice questions on the same topics.

Paper facts

Series
Annual 2023
Paper
Subjective, Group II
Set by
BISE Gujranwala
Tier
Not tiered
Time
1 hour 45 minutes
Marks
48
Calculator
Not recorded here: check the paper’s instructions
Syllabus
Old Punjab syllabus (PCTB Physics 9 used until the 2024-25 session), not the NC 2023 book. Some questions, such as satellites and heat transfer, are not in the new course.
Links checked
17 November 2026

Official files

These files belong to BISE Gujranwala. Labverse links to them and never hosts or copies them. Labverse is not affiliated with BISE Gujranwala.

What this paper covers

8 topic groups from our map of Punjab Board Class 9 Physics. Revise each one with its topic pages and simulations before you sit the paper.

How to use this paper

  1. 1. Time it. Set 1 hour 45 minutes for 48 marks: about 131 seconds a mark. At 53 minutes you should be roughly halfway through the marks; if you’re well behind, speed up on the short questions.
  2. 2. Sit it in one go. Open the question paper on BISE Gujranwala’s website (the link above) and work on paper, with no notes.
  3. 3. Mark it with the official scheme. The mark scheme isn’t public, so check answers with your teacher, and use the marking points on our questions below to practise marking.
  4. 4. Learn from the marks you lost. For every lost mark, note whether it was knowledge, method, reading the question or time.
  5. 5. Log mistakes by topic. Keep one line per topic group (Physical quantities and measurements, Kinematics, Dynamics, Turning effects of force, Work, energy and power, Mechanical properties of matter, Thermal properties of matter, Nature of science) and add a tally each time a mark goes there.
  6. 6. Revisit, then redo. Work through the weakest group’s topic pages and simulations, try the questions below, and come back to the paper in a week.

Practise the same topics

7 original exam-style questions on this paper’s topics, written in the style of Punjab board exams (not taken from the paper). Try each one before you reveal the answer.

  1. 1.A different pair of Vernier Callipers is closed. Its Vernier zero lies on the left of the main-scale zero, and the 6th Vernier division is in line with a main-scale mark. The least count is 0.01 cm.

    From the topic: Vernier callipers

    1. (a)Will this instrument give readings that are too large or too small? Give a reason.

      2 marks
      Show the answer

      Answer: Too small. The Vernier zero starts on the left of (behind) the main-scale zero, so every reading is less than the true length.

      Marking points

      • Too small
      • Vernier zero starts behind (left of) the main-scale zero
    2. (b)Calculate the zero error.

      2 marks
      Show the answer

      Answer: Zero error = (10 − 6) × 0.01 cm = 0.04 cm, which is added to each reading.

      Marking points

      • (10 − 6) × L.C.
      • 0.04 cm
    3. (c)The callipers are closed on a wooden scale. The main scale reading is 0.8 cm and the 3rd Vernier division is in line. Find the true thickness of the wooden scale.

      2 marks
      Show the answer

      Answer: Observed reading = 0.8 cm + (3 × 0.01 cm) = 0.83 cm. True thickness = 0.83 cm + 0.04 cm = 0.87 cm.

      Marking points

      • Observed reading 0.83 cm
      • 0.83 + 0.04 = 0.87 cm
  2. 2.A rickshaw travels 1.2 km due north and then 0.5 km due west. The whole trip takes 200 s.

    From the topic: Distance and displacement

    1. (a)Find the distance S covered by the rickshaw.

      1 mark
      Show the answer

      Answer: S = 1.2 + 0.5 = 1.7 km = 1700 m

      Marking points

      • 1.7 km (1700 m)
    2. (b)Find the magnitude of the displacement d.

      2 marks
      Show the answer

      Answer: The parts are at right angles, so d = √(1.2² + 0.5²) = √1.69 = 1.3 km (1300 m). A head-to-tail scale drawing gives the same value.

      Marking points

      • √(1.2² + 0.5²), or a correct head-to-tail scale drawing
      • 1.3 km (1300 m)
    3. (c)Give the direction of d as an angle measured from north.

      2 marks
      Show the answer

      Answer: tan θ = 0.5 ÷ 1.2 = 0.417, so θ = 22.6°. The displacement points 22.6° west of north.

      Marking points

      • tan θ = 0.5 ÷ 1.2 (or the angle measured from north on a scale drawing)
      • 22.6° west of north (accept 21° to 24° from a drawing; this allowance is our own estimate, not the board's)
    4. (d)Calculate the average speed and the average velocity of the rickshaw.

      4 marks
      Show the answer

      Answer: Average speed = S ÷ t = 1700 m ÷ 200 s = 8.5 m s⁻¹. Average velocity = d ÷ t = 1300 m ÷ 200 s = 6.5 m s⁻¹, directed 22.6° west of north.

      Marking points

      • Average speed = 1700 ÷ 200
      • 8.5 m s⁻¹
      • Average velocity = 1300 ÷ 200 = 6.5 m s⁻¹
      • Direction 22.6° west of north (the same as d)
  3. 3.Answer these short questions on gravitation.

    From the topic: Newton's law of gravitation

    1. (a)State Newton's law of gravitation.

      2 marks
      Show the answer

      Answer: Every body in the universe attracts every other body with a force that is directly proportional to the product of their masses and inversely proportional to the square of the distance between their centres.

      Marking points

      • force directly proportional to the product of the two masses
      • inversely proportional to the square of the distance between their centres
    2. (b)Write the value and the SI unit of the constant of gravitation G.

      2 marks
      Show the answer

      Answer: G = 6.67 × 10⁻¹¹ N m² kg⁻²

      Marking points

      • 6.67 × 10⁻¹¹
      • N m² kg⁻²
    3. (c)Why is the gravitational force called a field force?

      1 mark
      Show the answer

      Answer: It acts across a gap, with no contact: each mass has a gravitational field around it, and another mass in that field feels the force.

      Marking points

      • it acts without contact, through the gravitational field around a mass
    4. (d)Two books lie side by side on a desk but do not move towards each other. Explain why.

      2 marks
      Show the answer

      Answer: The gravitational force between them is extremely small, because G is tiny and the masses of the books are small. It is far smaller than the friction between the books and the desk, so they do not move.

      Marking points

      • the force is tiny because G (and the masses) are very small
      • friction is much larger than this force, so the books stay at rest
  4. 4.A shopkeeper has a 50 kg sack of rice and a 5 kg bag of rice on the floor.

    From the topic: Newton's first law

    1. (a)Which has more inertia? Give a reason.

      2 marks
      Show the answer

      Answer: The 50 kg sack, because it has the greater mass, and mass is the measure of inertia.

      Marking points

      • The 50 kg sack
      • Greater mass, and mass is a measure of inertia
    2. (b)Explain how the difference in inertia would show itself if the same horizontal force were applied to each.

      2 marks
      Show the answer

      Answer: The same force would give the 50 kg sack a much smaller acceleration (one tenth as much), so its velocity would change far more slowly; the sack is harder to start moving and harder to stop.

      Marking points

      • The sack gets a smaller acceleration (its velocity changes more slowly)
      • So it is harder to start (and to stop) than the bag
  5. 5.A uniform metre rule is pivoted at its 50 cm mark. A 6 N weight hangs from the 15 cm mark.

    From the topic: Principle of moments

    1. (a)Calculate the moment of the 6 N weight about the pivot.

      2 marks
      Show the answer

      Answer: ℓ = 50 − 15 = 35 cm = 0.35 m. τ = F × ℓ = 6 × 0.35 = 2.1 N m (anticlockwise).

      Marking points

      • ℓ = 0.35 m
      • 2.1 N m
    2. (b)Find the position on the scale at which a 7 N weight must hang to balance the rule.

      3 marks
      Show the answer

      Answer: By the principle of moments, 7 × ℓ = 2.1, so ℓ = 2.1 ÷ 7 = 0.30 m. The weight hangs 30 cm on the other side of the pivot, at the 80 cm mark.

      Marking points

      • 7 × ℓ = 2.1 (clockwise moment = anticlockwise moment)
      • ℓ = 0.30 m
      • At the 80 cm mark (on the other side of the pivot)
  6. 6.Sources of energy are divided into two groups: renewable and non-renewable.

    From the topic: Renewable and non-renewable energy sources

    1. (a)Differentiate between renewable and non-renewable sources of energy.

      2 marks
      Show the answer

      Answer: Renewable sources are replaced by nature as they are used, so they will not run out. Non-renewable sources exist in limited amounts and will run out, because they took millions of years to form or are mined from limited deposits.

      Marking points

      • Renewable: replaced by nature / will not run out
      • Non-renewable: limited in amount / will run out once used
    2. (b)Give two examples of each type.

      2 marks
      Show the answer

      Answer: Renewable: any two of solar, wind, hydroelectric, geothermal, tidal and wave energy (allow biofuels such as biogas, if new plants are grown to replace those used). Non-renewable: any two of coal, oil, natural gas and nuclear fuel.

      Marking points

      • Two correct renewable sources (allow biofuels if replanted)
      • Two correct non-renewable sources
    3. (c)Why is nuclear energy counted as a non-renewable source?

      1 mark
      Show the answer

      Answer: Its fuel, such as uranium, is found in limited amounts and is used up in the reactor.

      Marking points

      • Nuclear fuel (uranium) is limited and gets used up
  7. 7.A spring with a spring constant of 200 N m⁻¹ hangs vertically. A 500 g mass is hung from it. Take g = 10 m s⁻².

    From the topic: Elasticity and Hooke's law

    1. (a)Calculate the weight of the mass.

      1 mark
      Show the answer

      Answer: w = mg = 0.500 kg × 10 m s⁻² = 5.0 N.

      Marking points

      • 0.500 × 10 = 5.0 N
    2. (b)Calculate the extension of the spring in centimetres.

      2 marks
      Show the answer

      Answer: x = F/k = 5.0 N ÷ 200 N m⁻¹ = 0.025 m = 2.5 cm.

      Marking points

      • x = F/k = 5.0 ÷ 200 = 0.025 m
      • 2.5 cm
    3. (c)A second mass is added and the total extension becomes 4.0 cm, still within the elastic limit. Find the size of the second mass.

      3 marks
      Show the answer

      Answer: Total load F = kx = 200 × 0.040 = 8.0 N. Total mass = 8.0 ÷ 10 = 0.80 kg. Second mass = 0.80 − 0.50 = 0.30 kg = 300 g.

      Marking points

      • F = kx = 200 × 0.040 = 8.0 N
      • Total mass = 8.0 ÷ 10 = 0.80 kg
      • Second mass = 0.30 kg (300 g)