Skip to content

BISE Gujranwala · Punjab Class 9

BISE Gujranwala Annual 2025 Class 9 Physics (Subjective, Group I)

Set by BISE Gujranwala for Punjab Class 9 Physics, Annual 2025: 1 hour 45 minutes and 48 marks, on Physical quantities and measurements, Kinematics, Dynamics, Turning effects of force, Work, energy and power, Mechanical properties of matter, Thermal properties of matter, Nature of science. The paper itself is on BISE Gujranwala’s website; this page adds what it covers, how to use it and original practice questions on the same topics.

Paper facts

Series
Annual 2025
Paper
Subjective, Group I
Set by
BISE Gujranwala
Tier
Not tiered
Time
1 hour 45 minutes
Marks
48
Calculator
Not recorded here: check the paper’s instructions
Syllabus
Old Punjab syllabus (PCTB Physics 9 used until the 2024-25 session), not the NC 2023 book. Some questions, such as satellites and heat transfer, are not in the new course.
Links checked
17 November 2026

Official files

These files belong to BISE Gujranwala. Labverse links to them and never hosts or copies them. Labverse is not affiliated with BISE Gujranwala.

What this paper covers

8 topic groups from our map of Punjab Board Class 9 Physics. Revise each one with its topic pages and simulations before you sit the paper.

How to use this paper

  1. 1. Time it. Set 1 hour 45 minutes for 48 marks: about 131 seconds a mark. At 53 minutes you should be roughly halfway through the marks; if you’re well behind, speed up on the short questions.
  2. 2. Sit it in one go. Open the question paper on BISE Gujranwala’s website (the link above) and work on paper, with no notes.
  3. 3. Mark it with the official scheme. The mark scheme isn’t public, so check answers with your teacher, and use the marking points on our questions below to practise marking.
  4. 4. Learn from the marks you lost. For every lost mark, note whether it was knowledge, method, reading the question or time.
  5. 5. Log mistakes by topic. Keep one line per topic group (Physical quantities and measurements, Kinematics, Dynamics, Turning effects of force, Work, energy and power, Mechanical properties of matter, Thermal properties of matter, Nature of science) and add a tally each time a mark goes there.
  6. 6. Revisit, then redo. Work through the weakest group’s topic pages and simulations, try the questions below, and come back to the paper in a week.

Practise the same topics

6 original exam-style questions on this paper’s topics, written in the style of Punjab board exams (not taken from the paper). Try each one before you reveal the answer.

  1. 1.Round each value to 2 significant figures by your book's method (section 1.13).

    From the topic: Significant figures

    1. (a)6.45 A

      1 mark
      Show the answer

      Answer: 6.4 A

      Marking points

      • 6.4 A
    2. (b)0.0735 kg

      1 mark
      Show the answer

      Answer: 0.074 kg

      Marking points

      • 0.074 kg
    3. (c)3.2502 m

      1 mark
      Show the answer

      Answer: 3.3 m

      Marking points

      • 3.3 m
    4. (d)9.97 s

      1 mark
      Show the answer

      Answer: 10 s (1.0 × 10¹ s)

      Marking points

      • 10 s (allow 1.0 × 10¹ s)
    5. (e)Explain why 6.45 A and 6.55 A do not both round up.

      2 marks
      Show the answer

      Answer: Each ends in a lone 5, and your book keeps the last digit even. In 6.45 the 4 is already even, so it stays (6.4); in 6.55 the 5 is odd, so it becomes 6 (6.6).

      Marking points

      • A lone 5 is rounded so that the last kept digit is even
      • 6.45 → 6.4 (4 is even), but 6.55 → 6.6 (5 is odd)
  2. 2.A student notes the distance covered by a van on Jail Road every 10 s. Time t: 0, 10, 20, 30, 40 s. Distance S: 0, 120, 240, 360, 480 m.

    From the topic: Distance–time graphs

    1. (a)What shape will the distance–time graph of this data have? Give a reason.

      2 marks
      Show the answer

      Answer: A straight line sloping upwards from the origin, because the van covers equal distances (120 m) in equal intervals of time (10 s).

      Marking points

      • Straight line sloping upwards (through the origin)
      • Equal distances in equal time intervals, i.e. uniform speed
    2. (b)Use the gradient of the graph to find the speed of the van.

      2 marks
      Show the answer

      Answer: Gradient = (480 − 0) ÷ (40 − 0) = 12 m s⁻¹, so the speed is 12 m s⁻¹.

      Marking points

      • Gradient = change in distance ÷ change in time, using any correct pair of points
      • 12 m s⁻¹
    3. (c)If the van keeps the same speed, how far will it have travelled after 55 s?

      1 mark
      Show the answer

      Answer: S = vt = 12 × 55 = 660 m

      Marking points

      • 660 m
  3. 3.A 1000 kg car is moving at 20 m s⁻¹ when its brakes are applied. The net braking force on the car is 4000 N and stays constant until it stops.

    From the topic: Newton's second law

    1. (a)Calculate the deceleration of the car.

      2 marks
      Show the answer

      Answer: a = F ÷ m = 4000 ÷ 1000 = 4 m s⁻² (a deceleration, so −4 m s⁻² taking the motion as positive).

      Marking points

      • a = F ÷ m = 4000 ÷ 1000
      • 4 m s⁻² deceleration (−4 m s⁻²)
    2. (b)Calculate the time taken to stop.

      2 marks
      Show the answer

      Answer: vf = vi + at, so 0 = 20 + (−4)t, giving t = 5 s.

      Marking points

      • 0 = 20 − 4t
      • t = 5 s
    3. (c)Calculate the distance travelled while braking.

      2 marks
      Show the answer

      Answer: 2aS = vf² − vi², so 2(−4)S = 0 − 20², giving S = 400 ÷ 8 = 50 m.

      Marking points

      • Uses 2aS = vf² − vi² (or S = vi t + ½at²)
      • 50 m
  4. 4.The principle of conservation of momentum is used to solve collision problems.

    From the topic: Conservation of momentum

    1. (a)State the principle of conservation of momentum.

      2 marks
      Show the answer

      Answer: The total momentum of an isolated system stays constant, provided no external force acts on it. So the total momentum before a collision equals the total momentum after it.

      Marking points

      • No external force acts (isolated system)
      • Total momentum before = total momentum after (stays constant)
    2. (b)What is meant by an isolated system?

      1 mark
      Show the answer

      Answer: A system (group of bodies) on which no external force acts.

      Marking points

      • A system on which no external force acts
  5. 5.The position of the centre of gravity depends on the shape of a body and how its mass is spread.

    From the topic: Centre of mass and centre of gravity

    1. (a)State the position of the centre of gravity of (i) a uniform triangular sheet and (ii) a uniform solid cylinder.

      2 marks
      Show the answer

      Answer: (i) The point where the three medians meet. (ii) The midpoint of its axis.

      Marking points

      • Triangle: point where the medians meet
      • Cylinder: middle of its axis
    2. (b)Where is the centre of gravity of a uniform steel bangle? Explain why the bangle cannot be balanced on a fingertip placed at that point.

      2 marks
      Show the answer

      Answer: At the centre of the bangle. That point is in the empty space inside the bangle, so there is no material there to rest on a fingertip.

      Marking points

      • At the centre of the bangle
      • It lies outside the material (in empty space), so it cannot be supported there
  6. 6.A 2.0 kg stone is dropped from rest from a height of 20 m. Ignore air resistance. Take g = 10 N/kg.

    From the topic: Conservation of energy

    1. (a)Calculate the potential energy of the stone before it is dropped.

      2 marks
      Show the answer

      Answer: Ep = mgh = 2.0 × 10 × 20 = 400 J.

      Marking points

      • Ep = mgh = 2.0 × 10 × 20
      • 400 J
    2. (b)Find the potential energy and the kinetic energy of the stone when it is 8.0 m above the ground.

      3 marks
      Show the answer

      Answer: Ep = 2.0 × 10 × 8.0 = 160 J. By conservation of energy, Ek = 400 − 160 = 240 J. The total is still 400 J.

      Marking points

      • Ep = 160 J
      • Ek = 400 − 160 (conservation of energy used)
      • Ek = 240 J
    3. (c)Calculate the speed of the stone just before it hits the ground.

      2 marks
      Show the answer

      Answer: All 400 J is now kinetic energy: ½ × 2.0 × v² = 400, so v² = 400 and v = 20 m/s.

      Marking points

      • ½ × 2.0 × v² = 400
      • v = 20 m/s