Skip to content

BISE Gujranwala · Punjab Class 9

BISE Gujranwala Annual 2022 Class 9 Physics (Subjective, Group I)

Set by BISE Gujranwala for Punjab Class 9 Physics, Annual 2022: 1 hour 45 minutes and 48 marks, on Physical quantities and measurements, Kinematics, Dynamics, Turning effects of force, Work, energy and power, Mechanical properties of matter, Thermal properties of matter, Nature of science. The paper itself is on BISE Gujranwala’s website; this page adds what it covers, how to use it and original practice questions on the same topics.

Paper facts

Series
Annual 2022
Paper
Subjective, Group I
Set by
BISE Gujranwala
Tier
Not tiered
Time
1 hour 45 minutes
Marks
48
Calculator
Not recorded here: check the paper’s instructions
Syllabus
Old Punjab syllabus (PCTB Physics 9 used until the 2024-25 session), not the NC 2023 book. Some questions, such as satellites and heat transfer, are not in the new course.
Links checked
17 November 2026

Official files

These files belong to BISE Gujranwala. Labverse links to them and never hosts or copies them. Labverse is not affiliated with BISE Gujranwala.

What this paper covers

8 topic groups from our map of Punjab Board Class 9 Physics. Revise each one with its topic pages and simulations before you sit the paper.

How to use this paper

  1. 1. Time it. Set 1 hour 45 minutes for 48 marks: about 131 seconds a mark. At 53 minutes you should be roughly halfway through the marks; if you’re well behind, speed up on the short questions.
  2. 2. Sit it in one go. Open the question paper on BISE Gujranwala’s website (the link above) and work on paper, with no notes.
  3. 3. Mark it with the official scheme. The mark scheme isn’t public, so check answers with your teacher, and use the marking points on our questions below to practise marking.
  4. 4. Learn from the marks you lost. For every lost mark, note whether it was knowledge, method, reading the question or time.
  5. 5. Log mistakes by topic. Keep one line per topic group (Physical quantities and measurements, Kinematics, Dynamics, Turning effects of force, Work, energy and power, Mechanical properties of matter, Thermal properties of matter, Nature of science) and add a tally each time a mark goes there.
  6. 6. Revisit, then redo. Work through the weakest group’s topic pages and simulations, try the questions below, and come back to the paper in a week.

Practise the same topics

8 original exam-style questions on this paper’s topics, written in the style of Punjab board exams (not taken from the paper). Try each one before you reveal the answer.

  1. 1.A student uses a measuring cylinder to measure the volume of some water.

    From the topic: Measuring cylinders and displacement cans

    1. (a)What is meant by the meniscus?

      1 mark
      Show the answer

      Answer: The curved surface of a liquid in a narrow tube or cylinder.

      Marking points

      • Curved surface of the liquid in the cylinder
    2. (b)Where should the scale be read for (i) water, (ii) mercury?

      2 marks
      Show the answer

      Answer: (i) Water: level with the bottom of the concave meniscus. (ii) Mercury: level with the top of the convex meniscus.

      Marking points

      • Water: bottom of the meniscus
      • Mercury: top of the meniscus
    3. (c)The student reads the scale while looking down at the surface from above. Name the error made and state whether the reading is too high or too low.

      2 marks
      Show the answer

      Answer: Parallax error. Looking down from above makes the reading too high.

      Marking points

      • Parallax error
      • Reading too high
  2. 2.A student measures the length of a pencil with a metre rule marked in millimetres. One end of the pencil is exactly at the zero mark. The other end lies between the 14.3 cm and 14.4 cm marks, just past the midpoint of that division.

    From the topic: Errors and uncertainty in measurements

    1. (a)State the least count of the metre rule.

      1 mark
      Show the answer

      Answer: 1 mm, which is 0.1 cm.

      Marking points

      • 1 mm (0.1 cm)
    2. (b)What length should the student record? Give a reason.

      2 marks
      Show the answer

      Answer: 14.4 cm. The end has passed the midpoint of the division, so the reading is taken to the next mark.

      Marking points

      • 14.4 cm
      • The end is past the midpoint, so the higher mark is recorded
    3. (c)Write the length together with its uncertainty.

      2 marks
      Show the answer

      Answer: Uncertainty = ½ × least count = ½ × 0.1 cm = ±0.05 cm, so the length is 14.4 ± 0.05 cm.

      Marking points

      • Uncertainty = half the least count = ±0.05 cm
      • 14.4 ± 0.05 cm
  3. 3.Near the Earth's surface, bodies falling with negligible air resistance all have the same acceleration.

    From the topic: Free fall acceleration

    1. (a)What is meant by free fall?

      1 mark
      Show the answer

      Answer: Free fall is the motion of a body falling under the action of gravity alone, with no air resistance (or negligible air resistance).

      Marking points

      • Falling under gravity only, with no (or negligible) air resistance
    2. (b)State the value of g used in Class 9 numericals and give its direction.

      2 marks
      Show the answer

      Answer: g = 10 m s⁻² (its actual value is about 9.8 m s⁻²), directed vertically downwards towards the centre of the Earth.

      Marking points

      • 10 m s⁻²
      • Vertically downwards (towards the centre of the Earth)
    3. (c)Write the three equations of motion for a freely falling body.

      3 marks
      Show the answer

      Answer: vf = vi + gt; S = vi t + ½gt²; 2gS = vf² − vi²

      Marking points

      • vf = vi + gt
      • S = vi t + ½gt²
      • 2gS = vf² − vi²
  4. 4.A ceiling fan of mass 6 kg is switched off and hangs at rest from its rod. Take g = 10 N kg⁻¹.

    From the topic: Free-body diagrams

    1. (a)Name the two forces acting on the fan and state their directions.

      2 marks
      Show the answer

      Answer: Its weight, acting vertically downwards, and the pull (tension) of the rod, acting vertically upwards.

      Marking points

      • Weight, downwards
      • Pull (tension) of the rod, upwards
    2. (b)Calculate the size of each force.

      2 marks
      Show the answer

      Answer: Weight w = mg = 6 × 10 = 60 N. The fan is at rest, so the pull of the rod is also 60 N.

      Marking points

      • w = mg = 6 × 10 = 60 N
      • Pull of the rod = 60 N (forces balance because the fan is at rest)
  5. 5.Newton's first law of motion describes how a body behaves when no net force acts on it.

    From the topic: Newton's first law

    1. (a)State Newton's first law of motion.

      2 marks
      Show the answer

      Answer: A body stays at rest, or keeps moving with uniform velocity in a straight line, unless a net external force acts on it.

      Marking points

      • Stays at rest or moves with uniform velocity in a straight line
      • Unless a net (unbalanced) external force acts on it
    2. (b)Define inertia. Why is the first law also called the law of inertia?

      2 marks
      Show the answer

      Answer: Inertia is the tendency (property) of a body to resist any change in its state of rest or of uniform motion in a straight line. The first law describes exactly this property, so it is called the law of inertia.

      Marking points

      • Property of a body to keep (resist change to) its state of rest or uniform motion
      • The first law describes this property
  6. 6.Centre of mass and centre of gravity are two closely related ideas.

    From the topic: Centre of mass and centre of gravity

    1. (a)Define centre of gravity.

      1 mark
      Show the answer

      Answer: The point at which the whole weight of a body appears to act.

      Marking points

      • Point where the whole weight of the body appears to act
    2. (b)Define centre of mass.

      1 mark
      Show the answer

      Answer: The point at which the whole mass of a body can be taken to be concentrated.

      Marking points

      • Point where the whole mass of the body is assumed to be concentrated
    3. (c)When are the centre of mass and the centre of gravity at the same point?

      1 mark
      Show the answer

      Answer: When g is the same over the whole body, as it is for ordinary objects near the Earth's surface.

      Marking points

      • When g is uniform over the body (near the Earth's surface)
    4. (d)A body supported exactly at its centre of gravity stays balanced. Explain why.

      2 marks
      Show the answer

      Answer: The weight acts at the centre of gravity, so its line of action passes through the support. Its moment arm about the support is zero, so the weight produces no torque and the body does not turn.

      Marking points

      • Weight acts through the support (line of action passes through it)
      • Zero moment arm, so no torque / no rotation
  7. 7.At a port, two cranes each lift an identical 500 kg container through a height of 12 m at a steady speed. Crane P takes 40 s and crane Q takes 25 s. Take g = 10 m s⁻².

    From the topic: Power

    1. (a)Show that each crane does 60 000 J of work.

      2 marks
      Show the answer

      Answer: Lifting force = weight = mg = 500 × 10 = 5000 N. W = FS = 5000 N × 12 m = 60 000 J for each crane.

      Marking points

      • Weight = 500 × 10 = 5000 N
      • W = 5000 × 12 = 60 000 J
    2. (b)Calculate the power of each crane.

      2 marks
      Show the answer

      Answer: Crane P: 60 000 J ÷ 40 s = 1500 W. Crane Q: 60 000 J ÷ 25 s = 2400 W.

      Marking points

      • P: 60 000 ÷ 40 = 1500 W
      • Q: 60 000 ÷ 25 = 2400 W
    3. (c)Which crane is more powerful? Explain your answer.

      2 marks
      Show the answer

      Answer: Crane Q. It does the same work as crane P in less time, so it does work at a greater rate.

      Marking points

      • Crane Q
      • Same work in less time / greater rate of doing work
  8. 8.On a day of standard pressure, the mercury (ρ = 13 600 kg m⁻³) in a barometer stands 760 mm high. A second barometer is filled with an oil of density 850 kg m⁻³.

    From the topic: Barometers and manometers

    1. (a)Calculate the height of the oil column on the same day.

      3 marks
      Show the answer

      Answer: Both columns balance the same pressure, so ρ(oil) × g × h(oil) = ρ(Hg) × g × h(Hg). h(oil) = 13 600 × 0.760 ÷ 850 = 12.2 m.

      Marking points

      • ρ(oil) g h(oil) = ρ(Hg) g h(Hg), so g cancels
      • h(oil) = 13 600 × 0.760 ÷ 850
      • 12.2 m
    2. (b)Explain why mercury, rather than water or oil, is used in a simple barometer.

      2 marks
      Show the answer

      Answer: Mercury is very dense, so a short column of about 0.76 m balances the air pressure. A water or oil barometer would have to stand over 10 m high, far too tall for a laboratory.

      Marking points

      • Mercury has a very high density, so the column is short (about 0.76 m)
      • Water or oil would need an impractically tall tube (over 10 m)
    3. (c)The mercury barometer tube is tilted away from the vertical. What happens to the vertical height of the mercury column?

      1 mark
      Show the answer

      Answer: It stays the same, about 760 mm; the mercury simply fills a longer length of the tube.

      Marking points

      • Vertical height unchanged (mercury fills more of the tube's length)
    4. (d)Some air gets trapped above the mercury. How does this affect the reading? Explain.

      2 marks
      Show the answer

      Answer: The column becomes shorter. The trapped air presses down on the top of the mercury, so a shorter column is enough to balance atmospheric pressure, and the barometer reads too low.

      Marking points

      • The column becomes shorter (the reading is too low)
      • Trapped air exerts pressure on top of the column