Skip to content

BISE Gujranwala · Punjab Class 9

BISE Gujranwala Annual 2021 Class 9 Physics (Objective, Group I) (5473)

Set by BISE Gujranwala for Punjab Class 9 Physics, Annual 2021: 15 minutes and 12 marks, on Physical quantities and measurements, Kinematics, Dynamics, Turning effects of force, Work, energy and power, Mechanical properties of matter, Thermal properties of matter, Nature of science. The paper itself is on BISE Gujranwala’s website; this page adds what it covers, how to use it and original practice questions on the same topics.

Paper facts

Series
Annual 2021
Paper
Objective, Group I
Set by
BISE Gujranwala
Code
5473
Tier
Not tiered
Time
15 minutes
Marks
12
Calculator
Not recorded here: check the paper’s instructions
Syllabus
Old Punjab syllabus (PCTB Physics 9 used until the 2024-25 session), not the NC 2023 book. Some questions, such as satellites and heat transfer, are not in the new course.
Links checked
17 November 2026

Official files

These files belong to BISE Gujranwala. Labverse links to them and never hosts or copies them. Labverse is not affiliated with BISE Gujranwala.

What this paper covers

8 topic groups from our map of Punjab Board Class 9 Physics. Revise each one with its topic pages and simulations before you sit the paper.

How to use this paper

  1. 1. Time it. Set 15 minutes for 12 marks: about 75 seconds a mark. At 8 minutes you should be roughly halfway through the marks; if you’re well behind, speed up on the short questions.
  2. 2. Sit it in one go. Open the question paper on BISE Gujranwala’s website (the link above) and work on paper, with no notes.
  3. 3. Mark it with the official scheme. The mark scheme isn’t public, so check answers with your teacher, and use the marking points on our questions below to practise marking.
  4. 4. Learn from the marks you lost. For every lost mark, note whether it was knowledge, method, reading the question or time.
  5. 5. Log mistakes by topic. Keep one line per topic group (Physical quantities and measurements, Kinematics, Dynamics, Turning effects of force, Work, energy and power, Mechanical properties of matter, Thermal properties of matter, Nature of science) and add a tally each time a mark goes there.
  6. 6. Revisit, then redo. Work through the weakest group’s topic pages and simulations, try the questions below, and come back to the paper in a week.

Practise the same topics

6 original exam-style questions on this paper’s topics, written in the style of Punjab board exams (not taken from the paper). Try each one before you reveal the answer.

  1. 1.Significant figures show how reliably a quantity has been measured.

    From the topic: Significant figures

    1. (a)What are significant figures?

      2 marks
      Show the answer

      Answer: The digits in a measurement that are known reliably, together with the first doubtful (estimated) digit.

      Marking points

      • The digits that are known reliably (accurately)
      • Plus the first doubtful (estimated) digit
    2. (b)Give the number of significant figures shown by each reading: (i) 0.0405 m (ii) 7.20 s (iii) 1.080 × 10⁻² kg

      3 marks
      Show the answer

      Answer: (i) 3 (ii) 3 (iii) 4

      Marking points

      • 0.0405 m: 3
      • 7.20 s: 3
      • 1.080 × 10⁻² kg: 4
    3. (c)Which zeros in 0.00350 m are significant? Give a reason.

      2 marks
      Show the answer

      Answer: Only the last zero. The zeros before the 3 only fix the decimal point, but a zero at the end of a decimal was measured.

      Marking points

      • Only the final zero (after the 5)
      • Leading zeros only fix the decimal point; an end zero after the point counts
  2. 2.A passenger train covers 324 km between two cities in 3 hours.

    From the topic: Speed and velocity

    1. (a)Calculate the average speed of the train in km h⁻¹.

      2 marks
      Show the answer

      Answer: Average speed = total distance ÷ total time = 324 km ÷ 3 h = 108 km h⁻¹

      Marking points

      • Uses average speed = total distance ÷ total time
      • 108 km h⁻¹
    2. (b)Express this average speed in m s⁻¹.

      2 marks
      Show the answer

      Answer: 108 × 1000 m ÷ 3600 s = 30 m s⁻¹

      Marking points

      • Converts km to m and h to s (× 1000 ÷ 3600, or × 5/18)
      • 30 m s⁻¹
    3. (c)At some moments the train's speedometer shows a reading greater than this average. Explain why.

      2 marks
      Show the answer

      Answer: The speedometer shows instantaneous speed. The train goes slowly or stops at times (for example at stations), so at other times it must move faster than its average speed.

      Marking points

      • Speedometer shows instantaneous speed (the speed at that moment)
      • The train is slower or stopped at some times, so at other times its speed is above the average
  3. 3.The principle of conservation of momentum is used to solve collision problems.

    From the topic: Conservation of momentum

    1. (a)State the principle of conservation of momentum.

      2 marks
      Show the answer

      Answer: The total momentum of an isolated system stays constant, provided no external force acts on it. So the total momentum before a collision equals the total momentum after it.

      Marking points

      • No external force acts (isolated system)
      • Total momentum before = total momentum after (stays constant)
    2. (b)What is meant by an isolated system?

      1 mark
      Show the answer

      Answer: A system (group of bodies) on which no external force acts.

      Marking points

      • A system on which no external force acts
  4. 4.Energy can be stored as potential energy.

    From the topic: Potential energy

    1. (a)Define potential energy.

      1 mark
      Show the answer

      Answer: Potential energy is the energy stored in a body because of its position or its deformation (change of shape).

      Marking points

      • Energy due to position or deformation
    2. (b)Name two forms of potential energy and give one example of each.

      2 marks
      Show the answer

      Answer: Any two, e.g. gravitational potential energy (water stored behind a dam); elastic potential energy (a compressed spring or stretched catapult rubber); chemical potential energy (petrol or the chemicals in a battery).

      Marking points

      • First form with a matching example
      • Second form with a matching example
    3. (c)A body of mass m is lifted at a constant velocity through a height h. Show that its gravitational potential energy is Ep = mgh.

      3 marks
      Show the answer

      Answer: At constant velocity there is no acceleration, so the upward force equals the weight, w = mg. Work done = force × distance = mg × h. This work is stored in the body as gravitational potential energy, so Ep = mgh.

      Marking points

      • Constant velocity, so lifting force = weight = mg
      • Work done = mg × h
      • Work done is stored as Ep, so Ep = mgh
  5. 5.In one mountain valley, the fresh snow can support a pressure of up to about 5.0 × 10³ Pa before a walker sinks in. A trekker of mass 60 kg stands on it in boots with a total contact area of 0.050 m². Use g = 10 m s⁻².

    From the topic: Pressure

    1. (a)Calculate the pressure that the trekker exerts on the snow.

      3 marks
      Show the answer

      Answer: w = mg = 60 kg × 10 m s⁻² = 600 N. P = F/A = 600 N ÷ 0.050 m² = 1.2 × 10⁴ Pa.

      Marking points

      • w = mg = 60 × 10 = 600 N
      • P = F/A = 600 ÷ 0.050
      • 1.2 × 10⁴ Pa
    2. (b)Does the trekker sink into the snow? Give a reason.

      1 mark
      Show the answer

      Answer: Yes. The pressure, 1.2 × 10⁴ Pa, is more than the 5.0 × 10³ Pa that the snow can support.

      Marking points

      • Yes, because 1.2 × 10⁴ Pa is greater than 5.0 × 10³ Pa
    3. (c)Calculate the smallest total area of snowshoes that would stop the trekker sinking in.

      2 marks
      Show the answer

      Answer: A = F/P = 600 N ÷ 5.0 × 10³ Pa = 0.12 m².

      Marking points

      • A = F/P = 600 ÷ (5.0 × 10³)
      • 0.12 m²
  6. 6.The kinetic molecular theory describes matter in terms of moving molecules.

    From the topic: Kinetic molecular theory of matter

    1. (a)State any three postulates of the kinetic molecular theory of matter.

      3 marks
      Show the answer

      Answer: Any three of: matter is made of very small particles called molecules; the molecules are always in motion; molecules attract each other with an intermolecular force that becomes weaker as the distance between them increases; molecules have kinetic energy because they move and potential energy because they attract each other; the temperature of a substance depends on the average kinetic energy of its molecules.

      Marking points

      • First correct postulate, e.g. matter consists of very small particles called molecules
      • Second correct postulate, e.g. the molecules are always in motion
      • Third correct postulate, e.g. molecules attract each other with a force that weakens with distance; they have kinetic and potential energy; or temperature depends on their average kinetic energy
    2. (b)Name the three kinds of motion that molecules may have, and state which kind is the main motion of the molecules in a solid.

      2 marks
      Show the answer

      Answer: Vibrational, rotational and linear (translational) motion. In a solid the molecules mainly vibrate about fixed positions.

      Marking points

      • Vibrational, rotational and linear (translational)
      • Vibrational motion in a solid
    3. (c)What is meant by intermolecular force, and how does it change as the distance between two molecules increases?

      2 marks
      Show the answer

      Answer: It is the force of attraction between molecules. It becomes weaker as the molecules move further apart.

      Marking points

      • Force of attraction between molecules
      • Decreases as the distance between them increases