Skip to content

BISE Gujranwala · Punjab Class 9

BISE Gujranwala Annual 2024 Class 9 Physics (Objective, Group I) (5471)

Set by BISE Gujranwala for Punjab Class 9 Physics, Annual 2024: 15 minutes and 12 marks, on Physical quantities and measurements, Kinematics, Dynamics, Turning effects of force, Work, energy and power, Mechanical properties of matter, Thermal properties of matter, Nature of science. The paper itself is on BISE Gujranwala’s website; this page adds what it covers, how to use it and original practice questions on the same topics.

Paper facts

Series
Annual 2024
Paper
Objective, Group I
Set by
BISE Gujranwala
Code
5471
Tier
Not tiered
Time
15 minutes
Marks
12
Calculator
Not recorded here: check the paper’s instructions
Syllabus
Old Punjab syllabus (PCTB Physics 9 used until the 2024-25 session), not the NC 2023 book. Some questions, such as satellites and heat transfer, are not in the new course.
Links checked
17 November 2026

Official files

These files belong to BISE Gujranwala. Labverse links to them and never hosts or copies them. Labverse is not affiliated with BISE Gujranwala.

What this paper covers

8 topic groups from our map of Punjab Board Class 9 Physics. Revise each one with its topic pages and simulations before you sit the paper.

How to use this paper

  1. 1. Time it. Set 15 minutes for 12 marks: about 75 seconds a mark. At 8 minutes you should be roughly halfway through the marks; if you’re well behind, speed up on the short questions.
  2. 2. Sit it in one go. Open the question paper on BISE Gujranwala’s website (the link above) and work on paper, with no notes.
  3. 3. Mark it with the official scheme. The mark scheme isn’t public, so check answers with your teacher, and use the marking points on our questions below to practise marking.
  4. 4. Learn from the marks you lost. For every lost mark, note whether it was knowledge, method, reading the question or time.
  5. 5. Log mistakes by topic. Keep one line per topic group (Physical quantities and measurements, Kinematics, Dynamics, Turning effects of force, Work, energy and power, Mechanical properties of matter, Thermal properties of matter, Nature of science) and add a tally each time a mark goes there.
  6. 6. Revisit, then redo. Work through the weakest group’s topic pages and simulations, try the questions below, and come back to the paper in a week.

Practise the same topics

7 original exam-style questions on this paper’s topics, written in the style of Punjab board exams (not taken from the paper). Try each one before you reveal the answer.

  1. 1.Solve each of the following and give the answer in scientific notation.

    From the topic: Prefixes and scientific notation

    1. (a)(6 × 10⁵ m) × (4 × 10⁻² m)

      2 marks
      Show the answer

      Answer: 24 × 10³ m² = 2.4 × 10⁴ m²

      Marking points

      • 6 × 4 = 24 and 10⁵ × 10⁻² = 10³, giving 24 × 10³ m²
      • 2.4 × 10⁴ m²
    2. (b)(8.4 × 10⁶ kg) ÷ (2.1 × 10³ m³)

      2 marks
      Show the answer

      Answer: 8.4 ÷ 2.1 = 4.0 and 10⁶ ÷ 10³ = 10³, so 4.0 × 10³ kg m⁻³

      Marking points

      • 8.4 ÷ 2.1 = 4.0 and 10⁶⁻³ = 10³
      • 4.0 × 10³ kg m⁻³
    3. (c)3.6 × 10⁵ s + 4 × 10⁴ s

      2 marks
      Show the answer

      Answer: 4 × 10⁴ s = 0.4 × 10⁵ s, so the total is (3.6 + 0.4) × 10⁵ s = 4.0 × 10⁵ s

      Marking points

      • Same power first: 4 × 10⁴ s = 0.4 × 10⁵ s
      • 4.0 × 10⁵ s
  2. 2.A cyclist rides 900 m due east in 150 s, then turns round and rides 300 m due west in 90 s.

    From the topic: Speed and velocity

    1. (a)Calculate the average speed of the cyclist for the whole ride.

      3 marks
      Show the answer

      Answer: Total distance = 900 + 300 = 1200 m. Total time = 150 + 90 = 240 s. Average speed = 1200 ÷ 240 = 5 m s⁻¹

      Marking points

      • Total distance = 1200 m
      • Total time = 240 s
      • Average speed = 5 m s⁻¹
    2. (b)Calculate the average velocity of the cyclist for the whole ride.

      3 marks
      Show the answer

      Answer: Displacement = 900 − 300 = 600 m due east. Average velocity = 600 m ÷ 240 s = 2.5 m s⁻¹ due east

      Marking points

      • Displacement = 600 m
      • Average velocity = 600 ÷ 240 = 2.5 m s⁻¹
      • Direction given as due east
  3. 3.Free-body diagrams are used to show the forces acting on a body.

    From the topic: Free-body diagrams

    1. (a)What is a free-body diagram?

      2 marks
      Show the answer

      Answer: A diagram of a single body, drawn as a box or dot, showing all the forces acting on it as labelled arrows, with their relative sizes and directions.

      Marking points

      • Shows one (single) body, drawn as a box or dot
      • All forces acting on it shown as arrows with their sizes and directions
    2. (b)State what the length and the head of each arrow represent.

      2 marks
      Show the answer

      Answer: The length represents the size (magnitude) of the force; the arrowhead shows the direction in which it acts.

      Marking points

      • Length shows the magnitude of the force
      • Arrowhead shows the direction of the force
  4. 4.Newton's second law links force, mass and acceleration.

    From the topic: Newton's second law

    1. (a)State Newton's second law of motion.

      2 marks
      Show the answer

      Answer: A net force acting on a body gives it an acceleration in the direction of the net force. This acceleration is directly proportional to the net force and inversely proportional to the body’s mass.

      Marking points

      • A net force produces acceleration in the direction of the force
      • a is directly proportional to F and inversely proportional to m
    2. (b)Define the newton, the SI unit of force.

      2 marks
      Show the answer

      Answer: 1 N is the net force needed to accelerate a 1 kg mass at 1 m s⁻². So 1 N = 1 kg m s⁻².

      Marking points

      • Net force that accelerates a 1 kg mass at 1 m s⁻²
      • 1 N = 1 kg m s⁻²
  5. 5.A student of mass 50 kg stands on a uniform wooden plank of mass 20 kg laid across a narrow stream. Each end of the plank rests on a bank. Take g = 10 N/kg.

    From the topic: Parallel forces and addition of forces

    1. (a)Name the type of parallel forces formed by the weight of the student and the weight of the plank.

      1 mark
      Show the answer

      Answer: Like parallel forces, because both act vertically downwards.

      Marking points

      • Like parallel forces (both downwards)
    2. (b)Calculate the resultant of these two weights.

      2 marks
      Show the answer

      Answer: Weights: 50 × 10 = 500 N and 20 × 10 = 200 N. Resultant = 500 + 200 = 700 N, vertically downwards.

      Marking points

      • 500 N and 200 N (w = mg)
      • 700 N downwards
    3. (c)One bank pushes up on the plank with a force of 450 N. The plank is in equilibrium. Find the upward force from the other bank.

      2 marks
      Show the answer

      Answer: Upward forces must balance the downward forces: 450 + F = 700, so F = 250 N upwards.

      Marking points

      • Total upward force = total downward force (450 + F = 700)
      • 250 N
  6. 6.A 2.0 kg stone is dropped from rest from a height of 20 m. Ignore air resistance. Take g = 10 N/kg.

    From the topic: Conservation of energy

    1. (a)Calculate the potential energy of the stone before it is dropped.

      2 marks
      Show the answer

      Answer: Ep = mgh = 2.0 × 10 × 20 = 400 J.

      Marking points

      • Ep = mgh = 2.0 × 10 × 20
      • 400 J
    2. (b)Find the potential energy and the kinetic energy of the stone when it is 8.0 m above the ground.

      3 marks
      Show the answer

      Answer: Ep = 2.0 × 10 × 8.0 = 160 J. By conservation of energy, Ek = 400 − 160 = 240 J. The total is still 400 J.

      Marking points

      • Ep = 160 J
      • Ek = 400 − 160 (conservation of energy used)
      • Ek = 240 J
    3. (c)Calculate the speed of the stone just before it hits the ground.

      2 marks
      Show the answer

      Answer: All 400 J is now kinetic energy: ½ × 2.0 × v² = 400, so v² = 400 and v = 20 m/s.

      Marking points

      • ½ × 2.0 × v² = 400
      • v = 20 m/s
  7. 7.A jeweller tests a bangle that is said to be pure gold. The bangle has a mass of 38.6 g. When it is lowered into a measuring cylinder of water, the reading rises from 25.0 cm³ to 27.0 cm³. The density of pure gold is 19 300 kg m⁻³.

    From the topic: Density

    1. (a)Find the volume of the bangle.

      1 mark
      Show the answer

      Answer: V = 27.0 cm³ − 25.0 cm³ = 2.0 cm³.

      Marking points

      • 27.0 − 25.0 = 2.0 cm³
    2. (b)Calculate the density of the bangle in kg m⁻³.

      2 marks
      Show the answer

      Answer: ρ = m/V = 38.6 g ÷ 2.0 cm³ = 19.3 g cm⁻³ = 19 300 kg m⁻³.

      Marking points

      • 38.6 ÷ 2.0 = 19.3 g cm⁻³
      • 19 300 kg m⁻³
    3. (c)Could the bangle be pure gold? Give a reason.

      1 mark
      Show the answer

      Answer: Yes. Its density is the same as the density of pure gold.

      Marking points

      • Yes, its density equals that of pure gold