Skip to content

Cambridge International · Cambridge IGCSE

Cambridge IGCSE Physics Specimen (for exams from 2023) Paper 5 (0625/05)

Set by Cambridge International for Cambridge IGCSE Physics, Specimen (for exams from 2023): 1 hour 15 minutes and 40 marks, on Energy, work and power, Thermal physics, Transfer of thermal energy, Light and the electromagnetic spectrum, Electrical quantities, Electric circuits and electrical safety. The paper itself is on Cambridge International’s website; this page adds what it covers, how to use it and original practice questions on the same topics.

Paper facts

Series
Specimen (for exams from 2023)
Paper
Paper 5
Code
0625/05
Tier
Not tiered
Time
1 hour 15 minutes
Marks
40
Calculator
Allowed
Syllabus
0625 (2023–2025 syllabus)
Links checked
17 November 2026

Official files

These files belong to Cambridge International. Labverse links to them and never hosts or copies them. Labverse is not affiliated with Cambridge International.

What this paper covers

6 topic groups from our map of Cambridge IGCSE Physics (0625). Revise each one with its topic pages and simulations before you sit the paper.

How to use this paper

  1. 1. Time it. Set 1 hour 15 minutes for 40 marks: about 113 seconds a mark. At 38 minutes you should be roughly halfway through the marks; if you’re well behind, speed up on the short questions.
  2. 2. Sit it in one go. This is a hands-on lab test, so it can't be sat at home. Read the paper on Cambridge International’s website to see the kind of tasks set, then practise the skills it tests (measuring, recording, graphing and planning) with our virtual practicals.
  3. 3. Mark it with the official scheme. Give a mark only when your answer matches a marking point. Be strict with yourself: it’s the gaps you find that improve your grade.
  4. 4. Learn from the marks you lost. For every lost mark, note whether it was knowledge, method, reading the question or time.
  5. 5. Log mistakes by topic. Keep one line per topic group (Energy, work and power, Thermal physics, Transfer of thermal energy, Light and the electromagnetic spectrum, Electrical quantities, Electric circuits and electrical safety) and add a tally each time a mark goes there.
  6. 6. Revisit, then redo. Work through the weakest group’s topic pages and simulations, try the questions below, and come back to the paper in a week.

Practise the same topics

7 original exam-style questions on this paper’s topics, written in the style of Cambridge IGCSE (not taken from the paper). Try each one before you reveal the answer.

  1. 1.A car is travelling along a level road. The driver brakes and the car comes to rest.

    From the topic: Energy stores and transfers

    1. (a)Name the energy store of the car that decreases.

      1 mark
      Show the answer

      Answer: The kinetic store.

      Marking points

      • kinetic
    2. (b)Friction between the brake pads and the discs makes them hot. State how energy is transferred to the pads and discs, and name the store that increases.

      2 marks
      Show the answer

      Answer: By mechanical work done (by the friction forces). The internal (thermal) store of the pads and discs increases.

      Marking points

      • mechanical work done (by friction)
      • internal (thermal) store of the pads / discs
    3. (c)The car's kinetic store decreases by 180 kJ, and the pads and discs gain 172 kJ. Calculate how much energy goes elsewhere, and suggest where it goes.

      2 marks
      Show the answer

      Answer: 180 − 172 = 8 kJ. It warms the tyres, the road and the air (and a little leaves as sound).

      Marking points

      • 8 kJ
      • internal (thermal) store of tyres / road / air, or sound
  2. 2.A student fills a small glass cell with smoke and seals it. A lamp lights the cell from the side, and the student looks down into it through a microscope. Many bright specks of light are seen.

    From the topic: Brownian motion

    1. (a)State what the bright specks are.

      1 mark
      Show the answer

      Answer: Smoke particles, which scatter (reflect) the light from the lamp.

      Marking points

      • smoke particles
    2. (b)Describe the motion of the specks.

      2 marks
      Show the answer

      Answer: They move about at random, in a jerky zig-zag path, constantly changing direction and never stopping.

      Marking points

      • random / irregular / zig-zag motion
      • jerky, changing direction all the time / never stops
    3. (c)Explain what causes this motion.

      3 marks
      Show the answer

      Answer: The air particles, which are too small to see, move quickly in random directions. They collide with the smoke particles. At any instant the collisions on one side do not balance those on the other, so each smoke particle is pushed first one way and then another.

      Marking points

      • air particles (molecules) move quickly / randomly
      • air particles collide with (hit) the smoke particles
      • collisions are uneven (more on one side), so there is an unbalanced force in a changing direction
    4. (d)State what this observation is evidence for.

      1 mark
      Show the answer

      Answer: The kinetic particle model: air is made of tiny particles in constant, random motion.

      Marking points

      • kinetic particle model / air consists of particles that are always moving randomly
  3. 3.A convection box has a glass front and two chimneys, A and B. A lit candle stands under chimney A. A piece of smoking paper is held just above chimney B.

    From the topic: Convection

    1. (a)State the direction in which the smoke moves in chimney B.

      1 mark
      Show the answer

      Answer: Downwards, into the box.

      Marking points

      • downwards (into the box)
    2. (b)Explain why the smoke moves in this way.

      3 marks
      Show the answer

      Answer: The candle heats the air above it, which expands and becomes less dense. This warm air rises out through chimney A. Cooler, denser air, carrying the smoke, is drawn in through chimney B to replace it.

      Marking points

      • air above the candle is heated and becomes less dense
      • the warm air rises out through chimney A
      • cooler, denser air (with the smoke) enters through chimney B to replace it
    3. (c)The candle is blown out. Suggest what happens to the flow of smoke after a short time.

      1 mark
      Show the answer

      Answer: The flow slows down and stops, because nothing is heating the air any more.

      Marking points

      • the flow slows and stops (no heating to drive the current)
  4. 4.An object 4.0 cm tall stands on the principal axis, 12 cm from a thin converging lens of focal length 8.0 cm.

    From the topic: Thin lenses

    1. (a)Describe how a pair of rays, both leaving the top of the object, can be drawn to locate the image.

      3 marks
      Show the answer

      Answer: One ray runs parallel to the principal axis as far as the lens, then through the principal focus on the far side. The other passes through the optical centre and keeps its direction. The top of the image is where the two rays cross.

      Marking points

      • ray parallel to the principal axis, then through the principal focus on the far side
      • ray through the centre of the lens, undeviated
      • top of the image where the rays cross
    2. (b)On an accurate diagram the rays cross 24 cm beyond the lens, 8.0 cm below the principal axis. Describe the image.

      3 marks
      Show the answer

      Answer: Real, inverted and enlarged.

      Marking points

      • real
      • inverted
      • enlarged
    3. (c)A screen is placed 24 cm beyond the lens. State what is seen on the screen and explain why.

      2 marks
      Show the answer

      Answer: A sharp, upside-down image of the object, because rays of light from the object really meet at the screen.

      Marking points

      • a sharp / focused image (of the object)
      • light rays actually meet there / the image is real
    4. (d)The object is moved to 16 cm from the lens. State where the image now forms and compare its size with the object.

      2 marks
      Show the answer

      Answer: 16 cm beyond the lens, at 2F on the opposite side. It is the same size as the object.

      Marking points

      • 16 cm beyond the lens / at 2F on the opposite side
      • same size as the object
  5. 5.(Supplement) An isolated metal sphere on an insulating stand is given a positive charge.

    From the topic: Electric fields Supplement

    1. (a)Describe the electric field pattern around the sphere, including its direction.

      3 marks
      Show the answer

      Answer: Straight lines radiate from the sphere as if from its centre. Each line meets the surface at right angles, and the lines are evenly spaced all round. The arrows point away from the sphere.

      Marking points

      • straight radial lines (as if from the centre)
      • lines at right angles to the surface / evenly spaced all round the sphere
      • arrows pointing away from (out of) the sphere
    2. (b)The sphere is given a negative charge of the same size instead. State how the field pattern changes.

      1 mark
      Show the answer

      Answer: Only the direction changes: the arrows now point in towards the sphere, while the shape of the pattern stays the same.

      Marking points

      • arrows reversed / point towards the sphere (same shape)
    3. (c)A small positive charge is placed near the negatively charged sphere. In which direction does the force on it act?

      1 mark
      Show the answer

      Answer: Towards the sphere, along the field lines.

      Marking points

      • towards the sphere
  6. 6.A student is given a component sealed in a box with two terminals. The apparatus includes a variable d.c. power supply, an ammeter and a voltmeter.

    From the topic: Current–voltage graphs Supplement

    1. (a)(Core) State where the student should place each meter.

      2 marks
      Show the answer

      Answer: The ammeter goes in series with the component. The voltmeter goes in parallel, across the two terminals of the box.

      Marking points

      • ammeter in series with the component
      • voltmeter in parallel across the component
    2. (b)(Core) The readings are: 2.0 V gives 0.10 A, 4.0 V gives 0.20 A and 6.0 V gives 0.30 A. Calculate the resistance for each pair of readings.

      2 marks
      Show the answer

      Answer: R = V/I: 2.0 ÷ 0.10 = 20 Ω, 4.0 ÷ 0.20 = 20 Ω and 6.0 ÷ 0.30 = 20 Ω

      Marking points

      • R = V/I used, e.g. 2.0 ÷ 0.10
      • 20 Ω for all three
    3. (c)(Supplement) With the connections reversed, the readings are the same size but negative. Identify the component and give a reason.

      2 marks
      Show the answer

      Answer: A fixed resistor (a resistor of constant resistance). Its resistance is the same at every voltage and in both directions, so it is not a lamp, whose resistance changes, or a diode, which would block the reversed current.

      Marking points

      • fixed resistor / resistor of constant resistance
      • resistance the same at every voltage and in both directions (current proportional to voltage)
  7. 7.The lamps in a house in Kenya are connected in parallel to the mains supply.

    From the topic: Series and parallel circuits

    1. (a)State two advantages of connecting the lamps in parallel rather than in series.

      2 marks
      Show the answer

      Answer: Each lamp can be switched on or off on its own; if one lamp fails the others keep working. (Also: each lamp has the whole supply p.d. across it.)

      Marking points

      • lamps can be switched independently
      • if one lamp fails the others stay on / each lamp has the whole supply p.d.
    2. (b)Compare the current from the supply with the current in one of the lamps.

      1 mark
      Show the answer

      Answer: The current from the supply is larger than the current in any one lamp.

      Marking points

      • supply current is larger than the current in each lamp (branch)