Skip to content

Cambridge IGCSE Physics (0625) · Transfer of thermal energy

Conduction

2.3.1

Core: practical tests showing metals passing thermal energy on quickly and thermal insulators passing it slowly. Supplement: lattice vibrations in all solids, free (delocalised) electrons in metals, why gases and nearly all liquids conduct slowly, and solids such as glass and brick in between.

Loading simulation…

Symbols match your course. Open the full conduction, convection and radiation simulation for more presets and teacher tools.

What this topic covers

Stand a steel spoon and a wooden spoon in hot groundnut soup in Accra: only the steel handle soon gets too hot to touch. Energy travelled along the steel; the spoon itself never moved. This is conduction (syllabus 2.3.1).

Good and bad conductors (Core)

Good thermal conductors, such as copper, aluminium and steel, let energy flow through quickly. Bad thermal conductors, or thermal insulators, such as wood, plastic, wool and still air, let it through only slowly. No insulator stops the flow completely.

Three experiments (Core)

1. Rods, wax and pins. Take rods of different materials that share one length and thickness. Wax a drawing pin to each, the same distance from one end. Heat those ends equally, say in one hot metal block, and time each pin. The first to fall marks the best conductor.

2. Paper on a wood-and-brass rod. Wrap paper tightly over the joint and hold it briefly in a Bunsen flame. The paper chars over the wood but not over the brass, which carries energy away before the paper can burn.

3. Water conducts badly. Trap ice under wire gauze at the bottom of a boiling tube of water, then heat near the top. The top boils while the ice barely melts. Warm water stays at the top, so no convection current carries energy down.

Explaining conduction (Supplement)

Every solid holds its particles in a lattice. Particles at the hot end gain energy and vibrate with a larger amplitude, jostling their neighbours into stronger vibration. Energy passes along the lattice, slowly.

Metals also have free (delocalised) electrons, which belong to no single atom. They gain kinetic energy where the metal is hot, race through the lattice and hand it to particles in cooler parts by colliding with them. This route is far quicker.

Gases and most liquids. Gas particles are far apart, so energy passes on only in occasional collisions. Liquid particles are close but not locked into a lattice, so they pass vibrations on poorly, and they have no free electrons. Mercury, a liquid metal, is an exception.

The middle group. Glass, brick, concrete and stone lack free electrons, so they conduct far less well than metals, yet much better than foam or wool. The simulation's glass rod belongs here.

Worked example: reading pin times (Core)

A class heats the rods in a block set to 250 °C, timing from when the burner is lit.

RodTime for 2 cm pin / sTime for 14 cm pin / s
Copper1884
Aluminium19107
Steel36563
Glass380never fell

(a) Rank the rods, best conductor first. Copper, aluminium, steel, glass: the earlier a pin falls, the sooner energy reached it.

(b) The nearest copper and aluminium pins fall only 1 s apart. What separates them? The 14 cm pins: 84 s against 107 s. The gap widens with distance.

(c) How many times longer does steel's nearest pin take than copper's? 36 ÷ 18 = 2.

Investigating with the rods

In the simulation above, Conduction is already chosen, with Block temperature at 250 °C and Rods lose energy to the air on.

  1. (Core) Predict the order, then press Play. The warm colours race along copper, and When each pin dropped lists the nearest pins at about 18 s (copper), 19 s (aluminium), 36 s (steel) and 380 s (glass).
  2. (Core) When the 1800 s run ends, the Copper card reads 5 / 5 but Glass is stuck at 1 / 5.
  3. (Core) Set Block temperature to 100 °C, which resets the run, then press Play again. Copper and aluminium still drop every pin; steel keeps most and glass keeps all five.
  4. (Supplement) With lattice vibrations alone, the glass colour fades to the room shade a few centimetres out, because the rod loses energy to the air almost as fast as it arrives.

Common mistakes

  • Writing that the metal itself flows from the hot end to the cold end. In conduction the material stays in place: its atoms only vibrate about fixed positions while energy is passed along (helped, in metals, by free electrons).
  • Thinking a metal railing feels colder than a wooden fence because it is at a lower temperature. Out of the sun on a cool day, both are at about the same temperature as the air; the metal simply conducts energy out of your hand much faster.
  • Describing an insulator as a material that blocks all thermal energy. Insulators only slow the transfer down, so a little energy always gets through.
  • Comparing rods that are not identical apart from the material, for example a thick copper rod and a thin glass one, or pins at different distances. Then the order in which the pins fall cannot show which material conducts best.
  • (Supplement) Saying that free electrons explain conduction in every solid. All solids conduct by lattice vibrations; free electrons are an extra, much faster route that only metals have.
  • (Supplement) Claiming that gases conduct badly because their particles move slowly. Gas particles move fast, but they are so far apart that they rarely collide, so energy is handed on only occasionally.

Exam-style questions

Original questions written in the style of Cambridge IGCSE. Try each one before you reveal the answer.

  1. 1.A teacher in Jakarta has four rods, made of copper, iron, glass and wood. All four have the same length and the same thickness.

    1. (a)Describe how the teacher could use the rods, some wax, four drawing pins and a source of heat to compare how well the materials conduct thermal energy.

      4 marks
      Show the answer

      Answer: Stick one pin to each rod with wax, the same distance from one end. Heat those ends of all four rods equally and at the same time, for example by putting them in the same hot metal block or tank of hot water. Time how long each pin takes to fall, or note the order in which they fall. The rod whose pin falls first is the best conductor.

      Marking points

      • pin fixed to each rod with wax, the same distance from the heated end
      • one end of every rod heated equally / at the same time
      • time taken for each pin to fall measured (or the order of falling noted)
      • the pin that falls first is on the best conductor
    2. (b)Explain why the rods must all have the same thickness.

      1 mark
      Show the answer

      Answer: So that the material is the only thing that changes, making it a fair test.

      Marking points

      • fair test: only the material is different
    3. (c)Predict which rod's pin falls first. Give a reason for your answer.

      2 marks
      Show the answer

      Answer: The pin on the copper rod, because copper is the best thermal conductor of the four materials.

      Marking points

      • copper
      • copper is the best (thermal) conductor of the four
    4. (d)After 30 minutes, the pin on the wooden rod has still not fallen. State what this shows about wood.

      1 mark
      Show the answer

      Answer: Wood is a bad thermal conductor (a thermal insulator).

      Marking points

      • wood is a bad (poor) thermal conductor / a thermal insulator
  2. 2.A student wraps a small piece of ice in wire gauze and lets it sink to the bottom of a boiling tube full of cold water. The student then heats the tube near the top with a Bunsen burner. Soon the water at the top boils, but most of the ice is still there.

    1. (a)State what this experiment shows about water.

      1 mark
      Show the answer

      Answer: Water is a bad (poor) thermal conductor.

      Marking points

      • water is a bad (poor) thermal conductor
    2. (b)Explain why the tube is heated near the top and not at the bottom.

      2 marks
      Show the answer

      Answer: Hot water is less dense, so it stays at the top and no convection current forms. Heating at the bottom would set up convection currents that carry energy to the ice, so the test would no longer be about conduction only.

      Marking points

      • warm water is less dense so it stays at the top / no convection current forms
      • heating at the bottom would cause convection that carries energy to the ice (the test would not be about conduction alone)
    3. (c)State two safety precautions the student should take.

      2 marks
      Show the answer

      Answer: Wear eye protection, and hold the tube in a holder with its open end pointing away from everyone.

      Marking points

      • one precaution from: wear eye protection; hold the tube with a holder (tongs); point the open end away from people; heat gently; tie back long hair
      • a second, different precaution from the same list
  3. 3.A copper rod and a glass rod of the same size each have one end held in a flame.

    1. (a)(Supplement) Describe how thermal energy is conducted along the glass rod.

      2 marks
      Show the answer

      Answer: The particles at the hot end gain energy and vibrate with a larger amplitude. They pass the energy on to neighbouring particles, so the vibrations spread through the lattice towards the cold end.

      Marking points

      • particles (atoms or molecules) at the hot end vibrate more (with larger amplitude)
      • energy is passed to neighbouring particles (lattice vibrations spread along the rod)
    2. (b)(Supplement) Explain why energy is conducted much faster along the copper rod.

      3 marks
      Show the answer

      Answer: Copper is a metal, so it has free (delocalised) electrons. These gain kinetic energy at the hot end and move quickly through the metal. They transfer the energy to particles further along when they collide with them. This adds to the lattice vibrations, so conduction is much faster.

      Marking points

      • copper (a metal) has free (delocalised) electrons
      • the electrons gain (kinetic) energy at the hot end and move quickly through the rod
      • they pass energy to particles (ions) further along in collisions
    3. (c)(Supplement) Glass conducts much less well than copper, but better than polystyrene foam. Name one other solid that, like glass, conducts better than a thermal insulator but much less well than a metal.

      1 mark
      Show the answer

      Answer: Brick (or concrete, stone or ceramic).

      Marking points

      • brick / concrete / stone / ceramic (any one)
  4. 4.A winter jacket sold in Ulaanbaatar has a thick layer of fibres that traps a lot of still air.

    1. (a)(Supplement) Air conducts thermal energy very poorly. Use ideas about its particles to explain why.

      2 marks
      Show the answer

      Answer: The particles in air are far apart. They collide with each other only rarely, so energy is passed from particle to particle very slowly.

      Marking points

      • particles are far apart
      • collisions are rare, so energy is passed on slowly
    2. (b)State why the air needs to be held still between the fibres.

      1 mark
      Show the answer

      Answer: If the air could move, convection currents would carry energy away from the body.

      Marking points

      • moving air would carry energy away by convection
    3. (c)(Supplement) Mercury is a liquid, yet it conducts thermal energy much better than water. Suggest why.

      2 marks
      Show the answer

      Answer: Mercury is a metal, so it contains free (delocalised) electrons that carry energy through it quickly. Water has no free electrons.

      Marking points

      • mercury is a metal
      • it has free (delocalised) electrons that carry energy

Quick check

6 questions

  1. 1.Which of these materials is a good thermal conductor?
  2. 2.In a rods-and-wax experiment, why must every rod be the same length and thickness?
  3. 3.What does heating a boiling tube of water near the top, with ice held at the bottom, show?
  4. 4.A metal spoon and a wooden spoon stand in the same pot of hot soup. Why does the metal handle become hot first?
  5. 5.(Supplement) Which process carries thermal energy through a metal but not through glass?
  6. 6.(Supplement) Why is air a bad thermal conductor?