What this topic covers
Robert Millikan watched tiny charged oil drops drifting between two charged metal plates, and from their motion worked out the charge on a single electron. This part of syllabus 4.2.1 gives you the ideas behind that experiment: what an electric field is, which way it points and the shapes it takes.
Measuring charge (Supplement)
The SI unit of charge is the coulomb (C). That is a huge amount of static charge: a rubbed rod holds only a tiny fraction of one, measured in nanocoulombs (1 nC is C).
Beyond the syllabus: an electron's charge is C. A rod charged to −5 nC has therefore gained about electrons.
What an electric field is (Supplement)
Every charge is surrounded by an electric field: the space in which any other charge feels a push or a pull. Field lines map it.
Its direction at any point is the direction of the force that a small positive charge placed there would feel. So:
- lines start on positive charges and end on negative ones
- a negative charge is pushed against the arrows, opposite to the field
Lines never cross, because the force at each point has only one direction. Where they crowd together, the field is stronger.
Three patterns to learn (Supplement)
| Arrangement | Shape of the lines | Direction |
|---|---|---|
| Point charge | Straight lines spreading out evenly on all sides, close together near the charge | Outwards from +, inwards to − |
| Charged metal sphere (a conductor) | Outside, the same radial pattern; each line meets the surface at right angles, and none is drawn inside | Outwards from +, inwards to − |
| Parallel plates, one + and one − | In the gap: straight, parallel and evenly spaced, at right angles to both plates | From the + plate to the − plate |
Evenly spaced lines between the plates mean a uniform field: its strength and direction are the same throughout the middle of the gap. At the edges the lines bow outwards, but you will not be asked about that.
Worked example: predicting the force (Supplement)
Two horizontal metal plates are joined to a high-voltage supply: the upper one positive, the lower one negative. A tiny charged bead is placed between them, well away from the edges. Ignore its weight.
- The field: straight, parallel, evenly spaced lines pointing straight down, from + to −.
- A positive bead: the force acts along the field, so the bead is pushed down, towards the negative plate.
- A negative bead: the force acts against the field, so the bead is pushed up, towards the positive plate.
- Moving the bead: the field is uniform, so the force has the same size and direction anywhere in the gap.
- Beside a negative sphere instead: the lines point inwards, so a positive bead is pulled towards the sphere, less strongly further out, where the lines spread apart.
Simulation tasks (Supplement)
In the simulation above, switch Part to Fields. One positive charge loads: a charged metal ball seen from above, whose field outside matches a point charge's. Field lines and the yellow test charge, a small positive charge, are already showing.
- Drag the test charge round the ball. Its arrow always points straight away from the ball, along the field. With it touching the ball, the Field at the test charge card says Strong; near the edge of the picture, Weak.
- Choose One negative charge: the arrows on the lines, and on the test charge, now point inwards.
- Choose Parallel plates. Force on it reads ↓ down the page, from the positive plate towards the negative one. Drag the test charge around the middle of the gap: it stays Moderate and points down. Take it out past one end, near the top plate, and the arrow tilts.
- Switch on Strength colours: one even shade fills the middle of the gap.
Field strength values (N/C), Spark gap and Sharp point go beyond 0625, and the two-charge set-ups are extra practice.