Skip to content

Cambridge IGCSE Physics (0625) · Transfer of thermal energy

Consequences of thermal energy transfer

2.3.4

Core: using conduction, convection and radiation to explain familiar cases, including a pan heated on a cooker and a room warmed by convection. Supplement: cases where two or three methods each matter, including an open fire of wood or coal and a car’s radiator.

Loading simulation…

Symbols match your course. Open the full conduction, convection and radiation simulation for more presets and teacher tools.

What this topic covers

Cooking dinner, warming a classroom and keeping an engine cool all depend on conduction, convection and radiation, often working together (syllabus 2.3.4).

A pan on the cooker (Core)

  • Base: metal, a good conductor, so energy from the flame or hot plate passes quickly to the food. A flat base suits an electric plate, as trapped air conducts badly.
  • Inside: water at the bottom warms, becomes less dense and rises. Convection currents spread the energy through the soup, since liquids conduct poorly.
  • Handle: plastic or wood, both bad conductors, so it stays cool enough to hold.
  • Solid food: a thick piece of yam warms inside by slow conduction, so it takes longer to cook through.

Warming a room (Core)

A heater is usually fixed low on a wall. Air beside it warms and expands; being less dense, it rises to the ceiling. It spreads out, cools, becomes denser and sinks on the far side, then drifts back along the floor to the heater. Panel heaters are often called radiators, but convection carries away most of their output.

Worked example: the classroom heater (Core)

An electric heater stands against one wall of a cold classroom in Santiago. Explain how it warms the whole room. (4 marks)

  1. Air next to the heater is warmed and expands.
  2. Its density decreases, so it rises towards the ceiling.
  3. Cooler, denser air sinks on the far side and flows across the floor to replace it.
  4. A convection current forms, carrying energy round the whole room.

Writing only "heat rises" would score nothing.

An open fire (Supplement)

  • Radiation: glowing coal or wood and the flames emit a great deal of infrared, which warms faces and hands turned towards the fire although the air between hardly warms.
  • Convection: hot, less dense gases stream up the chimney, pulling fresh air in at the base to keep the fire burning. Much of the energy leaves this way, so an open fire is wasteful.
  • Conduction: energy passes into the metal grate and the hearth bricks, which stay warm long afterwards.

A car radiator (Supplement)

  1. A pump drives coolant (water with antifreeze) through the hot engine. Energy is conducted from the metal into the coolant, and the moving liquid carries it to the radiator.
  2. There, energy is conducted through thin metal tubes into many thin fins, which give a very large surface area.
  3. Air forced through by the car's motion and a fan carries the energy away by convection. A little leaves as infrared, but despite the name, conduction and convection do most of the work.

Extra practice: the vacuum flask

A flask is not a named example, but it tests all three methods. The gap between its double walls holds a vacuum, and with no particles there, neither conduction nor convection can cross. The silvered surfaces facing the gap reflect infrared and emit very little, which cuts radiation. The stopper limits conduction and convection out of the top.

Linking the simulation to real life

In the simulation above, each experiment models one of these situations.

  1. (Core) With Conduction chosen, press Play. Copper drops its 14 cm pin at about 84 s, while glass loses only its nearest pin: compare a metal pan base with a handle that conducts badly.
  2. (Core) Press Convection, then Play. The dye traces the same loop as air round a heated room. Then press Flame on: the burner is removed and the loop slows almost to a stop, like a room once its heater is off.
  3. (Supplement) Press Radiation, choose Absorbing under Test, then Play. The dull black plate, like hands held up to a fire, absorbs most of the infrared and drops its pin after about 90 s. The shiny plate reflects most of it, as a flask's silvering does, and stays below 25 °C.

Common mistakes

  • Explaining a room heater by radiation alone because it is called a radiator. Most of its energy is carried round the room by convection currents in the air.
  • Saying that a pan handle is plastic because plastic 'does not get hot'. It can warm up, but plastic is a bad thermal conductor, so energy travels along it only slowly and the end you hold stays cool.
  • Placing a room heater close to the ceiling in a design answer. The warm air would stay near the top, so the lower part of the room, where people sit, would hardly warm.
  • Writing that the vacuum in a flask stops radiation. A vacuum stops conduction and convection, but infrared crosses it easily, so the silvered surfaces are needed to cut down radiation.
  • (Supplement) Saying that a car radiator cools the engine mainly by radiation. Despite its name, it loses most of its energy by conduction through the metal and convection into the air flowing past the fins.
  • (Supplement) Explaining an open fire with radiation only. Radiation warms the people in front of it, but convection also carries hot gases up the chimney and draws in fresh air, and conduction warms the grate and the hearth.

Exam-style questions

Original questions written in the style of Cambridge IGCSE. Try each one before you reveal the answer.

  1. 1.A cook in Hanoi heats a pan of water on a gas cooker. The pan has a thin aluminium base and a plastic handle.

    1. (a)Name the process by which thermal energy passes through the aluminium base.

      1 mark
      Show the answer

      Answer: Conduction

      Marking points

      • conduction
    2. (b)Explain why the base is made of aluminium.

      1 mark
      Show the answer

      Answer: Aluminium is a metal and a good thermal conductor, so energy passes quickly from the flame to the water.

      Marking points

      • aluminium (metal) is a good thermal conductor
    3. (c)Explain why the handle is made of plastic.

      2 marks
      Show the answer

      Answer: Plastic is a thermal insulator, a poor conductor of thermal energy, so energy travels along the handle only slowly and the end the cook holds stays cool.

      Marking points

      • plastic is a bad (poor) thermal conductor / an insulator
      • so the handle stays cool enough to hold
    4. (d)Describe how thermal energy is spread through all of the water in the pan.

      3 marks
      Show the answer

      Answer: Water at the bottom of the pan is heated and becomes less dense. It rises, and cooler, denser water sinks to take its place. This sets up convection currents that carry energy through all the water.

      Marking points

      • water at the bottom is heated and becomes less dense
      • warm water rises and cooler, denser water sinks
      • convection currents carry energy through the water
  2. 2.A family in Toronto warms their living room with an electric heater fixed to a wall just above the floor.

    1. (a)State the direction in which the air just above the heater moves.

      1 mark
      Show the answer

      Answer: Upwards

      Marking points

      • upwards
    2. (b)Explain why the heater is fixed near the floor and not near the ceiling.

      2 marks
      Show the answer

      Answer: Warm air rises, so a heater near the floor sets up a convection current that circulates through the whole room. A heater near the ceiling would leave the warm air at the top and the lower part of the room cold.

      Marking points

      • warm (less dense) air rises
      • a heater near the floor sets up a convection current through the whole room / near the ceiling the warm air would stay at the top
    3. (c)The heater is often called a radiator. State the main process by which it warms the air in the room.

      1 mark
      Show the answer

      Answer: Convection

      Marking points

      • convection
    4. (d)Suggest why an air conditioner is usually fixed high up on a wall.

      2 marks
      Show the answer

      Answer: The air it cools becomes denser, so it sinks through the room. Warmer air rises to take its place, so a convection current cools the whole room.

      Marking points

      • cooled air is denser, so it sinks
      • a convection current forms that cools the whole room (warmer air rises to the unit)
  3. 3.A cottage in Wales is heated by an open coal fire in a fireplace with a chimney.

    1. (a)(Supplement) A person sitting in front of the fire feels warm on the side facing the fire but not on their back. Explain why.

      2 marks
      Show the answer

      Answer: Most of the energy reaches the person by infrared radiation from the glowing coal and flames. The radiation travels outwards from the fire, so it is absorbed only by the side of the body that faces the fire.

      Marking points

      • energy reaches the person mainly by (infrared) radiation
      • radiation from the fire falls only on (is absorbed only by) the side facing it
    2. (b)(Supplement) Explain why air from the room is drawn into the fireplace.

      2 marks
      Show the answer

      Answer: The hot gases above the fire are less dense, so they rise up the chimney. Cooler, denser air from the room flows in at the bottom to replace them.

      Marking points

      • hot gases are less dense and rise up the chimney
      • cooler (denser) air flows in to replace them
    3. (c)(Supplement) Suggest why an open fire is a wasteful way to heat a room.

      1 mark
      Show the answer

      Answer: Much of the energy is carried up the chimney by the rising hot gases.

      Marking points

      • much energy is carried up the chimney (by convection)
    4. (d)(Supplement) The metal grate that holds the coal becomes very hot. Name the process that transfers energy into the grate where it touches the burning coal.

      1 mark
      Show the answer

      Answer: Conduction

      Marking points

      • conduction
  4. 4.In a car, a pump sends coolant through channels in the hot engine and then through a radiator at the front of the car. The radiator is made of thin metal tubes joined to many thin metal fins.

    1. (a)(Supplement) Name the process that transfers energy from the hot metal of the engine to the coolant.

      1 mark
      Show the answer

      Answer: Conduction

      Marking points

      • conduction
    2. (b)(Supplement) Explain why the radiator has many thin metal fins.

      2 marks
      Show the answer

      Answer: The fins give the radiator a very large surface area in contact with the air, so energy is transferred to the air at a greater rate. Metal is a good conductor, so energy passes from the tubes into the fins quickly.

      Marking points

      • large surface area (in contact with the air)
      • energy is transferred to the air faster / metal conducts energy into the fins quickly
    3. (c)(Supplement) Explain how the air flowing through the radiator removes energy from it.

      2 marks
      Show the answer

      Answer: Air touching the hot fins is warmed. The moving air carries this energy away and is replaced by cooler air, so energy is removed by convection.

      Marking points

      • air in contact with the fins is warmed
      • the warmed air is carried away and replaced by cooler air (convection)
    4. (d)(Supplement) Suggest why painting the radiator dull black helps it a little.

      1 mark
      Show the answer

      Answer: A dull black surface is a good emitter of infrared, so slightly more energy is lost by radiation.

      Marking points

      • dull black is a good emitter, so more energy is lost by radiation

Quick check

6 questions

  1. 1.Why are saucepan bases usually made of metal?
  2. 2.Why is a room heater usually fitted near the floor?
  3. 3.In a vacuum flask, what does the vacuum between the walls prevent?
  4. 4.Which material is best for the handle of a frying pan?
  5. 5.(Supplement) How does most of the energy leave a car radiator?
  6. 6.(Supplement) A person sits facing an open fire. How does most of the energy reach their face?