What this topic covers
A football pumped up at breakfast in Doha feels rock hard after a morning in the sun. A blocked syringe pushes back harder the further you press. Both come from gas particles striking surfaces (syllabus 2.1.2–2.1.3).
Where gas pressure comes from (Core)
Gas particles are far apart and move fast in random directions. A particle striking the container wall rebounds and gives the wall a tiny push. Vast numbers of these pushes every second add up to a steady pressure on every surface.
The pressure grows when particles reach the walls more often (more collisions per second), or when each collision is harder because the particles are faster.
Force per unit area (Supplement)
Each collision exerts a small force on the wall. Add the forces from every collision on a surface, divide by its area, and you have the pressure, as in (topic 1.8). From topic 1.6: a rebounding particle's momentum changes, so a force acts on it, and it pushes back on the wall.
Heating at constant volume (Core)
Picture a sealed steel gas bottle in sunshine; its volume cannot change.
- The particles gain kinetic energy and move faster on average.
- They arrive at the walls more frequently, and each impact is harder.
- So the pressure rises. Cooling the bottle lowers it.
Changing the volume at constant temperature (Core)
Press the plunger of a sealed syringe slowly, so the air stays at room temperature.
- The particles keep the same average speed, so the impacts are no harder on average.
- In the smaller space they reach each square centimetre of wall more often.
- So the pressure rises. A larger volume gives a lower pressure.
The equation pV = constant (Supplement)
When the mass of gas is fixed and its temperature does not change, pressure times volume stays the same:
Subscript 1 means before the change; 2 means after. You need to remember this equation. Any units work, as long as both pressures use one unit and both volumes another. If the volume falls to half, the pressure becomes twice as big.
The graph of against is a curve, steep at small volumes and flatter at large ones, approaching both axes without ever reaching them. Plotting against gives a straight line through the origin.
Worked example 1: the football (Core)
Explain, in particle terms, why the football's pressure is higher at midday, given that its volume has barely changed.
- The air particles gain kinetic energy and move faster.
- They hit the inside of the ball more often.
- Each hit is harder, so the pressure is greater.
Worked example 2: oxygen for a hospital (Supplement)
A hospital in Nairobi stores oxygen in a 0.040 m³ cylinder at Pa. What volume would this oxygen fill at Pa and the same temperature?
Answer: 6.0 m³. The pressure falls 150-fold, so the volume grows 150-fold.
Simulation tasks
In the simulation above, Experiment starts on Constant temperature, with Volume 300 cm³, Set temperature 300 K (27 °C) and 60 particles. Readings wobble, so treat them as approximate.
- (Core) Press Play: flashes show particles bouncing off the walls. Once 4 s average appears on the Pressure card, it reads close to 102 kPa.
- (Core) Bring the Volume to 150 cm³ with the piston handle, the slider or Squeeze. The Temperature card rises a little while the piston moves, then returns to 300 K; the pressure settles near 208 kPa.
- (Supplement) Record settled readings at 300, 250, 200, 150 and 100 cm³. Pressure × volume stays near 31 000 kPa cm³, creeping up a few per cent at small volumes, as the particles take up room. Under Plot, the points on p against 1/V fall almost on a line through the origin; switch to p against V to see the curve.
- (Core) Choose Constant volume, press Heat and watch the gauge climb, then press Cool.
Work done (thermostat off) goes beyond the Cambridge syllabus.