What this topic covers
No machine delivers all of its input energy to the place you want it. Efficiency measures what fraction it does manage.
Useful and wasted energy (Core)
Every device sends its input energy to more than one place. The part that does the job you want is the useful output. Everything else is wasted: mostly it heats the device and its surroundings, and some may leave as sound. Wasted energy is not destroyed. It ends up spread thinly through internal (thermal) stores, where nobody can use it again.
A device is more efficient when a larger share of its input becomes useful output. From the same electrical energy, an LED lamp gives far more light than a filament lamp, which gets very hot. Oiling a bicycle chain cuts friction, so more of the rider's effort reaches the back wheel. Energy is conserved, so a device can never deliver more useful energy than its total input: nothing beats 100% efficiency.
The efficiency equations (Supplement)
You must recall both forms:
Leave out the × 100% to give efficiency as a decimal. It has no unit, but the top and bottom must be in the same unit.
Worked example 1: a dockside crane (Supplement)
At a port in Mombasa, a crane motor is supplied with 50 kJ of energy while it lifts a 400 kg crate through 9.0 m. Find its efficiency, using N/kg.
Useful output: the crate's gain in gravitational potential energy.
Answer: 70.6%. The other 14.7 kJ heats the motor, cables and air, and some leaves as sound.
Worked example 2: two lamps (Supplement)
A 40 W filament lamp produces 2.0 W of light, while a 6.0 W LED lamp produces 1.5 W of light. Which is more efficient?
Answer: the LED, by a factor of five, even though it gives slightly less light.
Sankey diagrams (Supplement)
In a Sankey diagram, the width of each arrow shows how much energy (or power) it carries. The input arrow enters on the left and divides: the useful part continues to the right, while the wasted parts curve off, usually downwards. Because energy is conserved, the output widths add up to the input width, and the efficiency is the useful width divided by the input width.
Simulation tasks
In the simulation above, the Electric kettle heats 1.0 kg of water at 2000 W for 150 s. Even before you press Play, the readouts cover the whole run: 300 kJ of Energy in and an Efficiency of 0.870 (87.0%), with 261 kJ Useful. The Efficiency card, the Sankey diagram and Check it with the equations carry a Supplement tag.
- (Core) Press Play. Most of the energy reaches the water's internal (thermal) store; the kettle itself and the surroundings take the rest.
- (Supplement) Try 3000 W for 100 s, then 1200 W for 250 s (sliders Power of the kettle, Time switched on). Both supply 300 kJ, yet the quick heat-up scores 0.884 (88.4%) and the slow one 0.842 (84.2%): the longer the kettle stays hot, the more it loses to the room.
- (Supplement) Pick Battery torch left on and compare the two Bulb buttons. Filament gives 0.0500 (5.00%) and LED gives 0.250 (25.0%). Moving Power of the torch changes how long the batteries last, but not the efficiency.
- (Supplement) Pick Car braking to a stop. The efficiency is 0 (0%), as nothing is stored usefully. Switch on Regenerative braking: 79.3 kJ now reaches the chemical store of the battery, and the efficiency becomes 0.587 (58.7%).