What the simulation shows
The stage holds three fixed circuits: a series loop, a set of parallel branches, and a mixed circuit with one resistor in series with a parallel pair. Ammeters sit at several points and voltmeters sit across each resistor and across the supply. Every reading updates the moment you change a resistance, a switch or the number of cells.
Glowing dots travel along the wires. Each dot stands for 0.5 C of charge, so faster dots mean a bigger current in that wire. Switch the dots to show electrons and they drift the other way, out of the negative terminal and back into the positive one.
Choose a rule from the Prove a rule menu under the stage. The simulation builds a circuit, outlines the meters to compare and checks the rule with live numbers. The panel under the stage turns green whenever a check updates, so you can change any value and watch the rule keep holding.
Series: one path for the charge
A series circuit has no junctions. Every coulomb goes through every component in turn, which is why each ammeter in the loop gives the same reading. Resistors do not use up current. What a coulomb hands over in a resistor is energy.
The supply gives each coulomb a fixed amount of energy, and the resistors share it between them. So the p.d.s across the resistors always total the supply p.d. The same current flows through each resistor, so the one with the most resistance takes the biggest share. Adding a third resistor raises the total resistance and the current falls.
Here is the total resistance of the loop.
Parallel: branches side by side
In a parallel circuit, each branch joins the same two points, so every branch has the full supply p.d. The current divides at a junction, and together the branch currents equal the supply current. A branch with less resistance carries more current.
Opening one branch switch stops the current in that branch only. The other branches keep their p.d. and their current, which is why the lamps in a building are wired this way. Closing a switch adds another path: the supply current rises, so the total resistance has fallen. It always ends up smaller than the smallest resistor.
Not every course asks you to calculate this. Pick your course with the symbol switcher and each rule in the simulation shows how your course treats it.
Mixed circuits
The mixed circuit puts one resistor in series with two resistors in parallel. To solve it, replace the parallel pair with a single resistor that has the same effect, then add the series resistor to get the total. Find the supply current from , share out the supply p.d., and split the current at the junction. The rule panel works through those five steps with your own values.