Velocity–time graphs in the AQA course
Velocity–time graphs belong to spec point 4.5.6.1.5. How much of it you need depends on your tier:
- Both tiers: plot a velocity–time graph from data, describe the motion it shows, and get an acceleration from its gradient.
- Higher tier only: find the distance travelled (or displacement) from the area under the line, counting squares if the line is curved.
- GCSE Physics only (not Combined Science): the graph for a falling object that reaches terminal velocity.
The equation behind the gradient is , which you must remember.
Reading the shape
On these graphs, the height of the line is the velocity. Read the slope to see how the velocity is changing.
| What the line does | Motion |
|---|---|
| Runs along the time axis at zero | At rest |
| Flat, above the axis | Steady velocity, no acceleration |
| Straight, sloping up | Uniform acceleration |
| Straight, sloping down towards the axis | Uniform deceleration |
| Rising, but curving so it gets flatter | Still speeding up, but the acceleration is getting smaller |
The steeper the slope, the bigger the acceleration.
Worked example: three stages of a bus ride
A double-decker in Dublin pulls away from a stop. Its velocity–time graph has three straight parts:
- 0 to 8.0 s: velocity rises from 0 to 12 m/s.
- 8.0 s to 28 s: velocity stays at 12 m/s.
- 28 s to 34 s: velocity falls from 12 m/s to 0.
(a) Acceleration in the first part
Given: ,
Equation: , which is the gradient of the line
Substitution:
Answer:
(b) Acceleration in the last part
Substitution:
Answer: , a deceleration of 2.0 m/s². This line is steeper than the first one, so the bus slows down more sharply than it sped up.
(c) Higher tier: distance travelled
Split the area under the line into simple shapes.
- First triangle:
- Rectangle:
- Last triangle:
Answer: total distance
Higher tier: why the area gives distance
For a steady velocity, distance equals velocity multiplied by time. On the graph, that is the height of a rectangle times its width, which is its area. The same idea holds for any shape of line, because every thin strip of area is a small velocity multiplied by a short time.
Higher tier: counting squares under a curve
When the line is curved, you cannot use triangles and rectangles. Count squares instead.
- Work out the distance one grid square stands for. If a square is 2 s wide and 5 m/s tall, it represents .
- Count every whole square under the line.
- Count part-squares that are about half or more as whole ones, and ignore the smaller bits.
- Multiply your total number of squares by the distance per square.
Using the simulation
In the simulation above, choose Journey. The car speeds up at 3 m/s² for 4 s, cruises at 12 m/s, then brakes to a stop at 12 s. Drag along the velocity–time graph and read the gradient at different times: 3 m/s², then 0, then −3 m/s². The area under the velocity–time graph is shaded (this is switched on at the start). When the run ends, the shaded area and the distance readout should both show 96 m. Check this yourself with two triangles and a rectangle.