What happens in the crash
A car drives into a solid concrete barrier and stops. A crash-test dummy sits in the driving seat, and the side of the car is cut away so you can watch the dummy, the seat belt and the airbag during the impact. The whole event lasts about a tenth of a second, so it plays many times slower than real life. Live meters show the force on the car and on the dummy, and the table gives each one's stopping time, average and peak force, and deceleration.
The change in momentum is fixed
Before the crash the car has momentum . Afterwards it is at rest. However the stop happens, the momentum has to fall by exactly that amount, so no safety feature can change . What a feature can change is how quickly the momentum disappears. The average force equals the change in momentum divided by the time it takes,
so spreading the same change over a longer time gives a smaller average force. The readouts show this at once: with the crumple zone, the car's stopping time is five times as long as with a stiff front, and its average force is one fifth as big.
Reading the force–time graphs
Each graph plots the size of a force against the time since impact. The shaded area under a curve is the impulse, , which equals the change in momentum. Choose the area tool and drag across the whole curve to measure it in newton seconds. It matches in kilogram metres per second, because those two units are identical. Your previous crash stays on the graph for comparison, along with the same crash with no safety features. Without the features you get a tall, thin spike; with them, a lower and wider hump. The areas are equal.
Belts, airbags and the dummy
A belted dummy is held to the seat from the first instant, so it slows down with the car and then a little more while the belt stretches. Without a belt nothing pushes on the dummy at first. It carries on at the original speed until its chest meets the steering wheel, which stops it very abruptly. On the dummy's graph, the force does not even start until the car has nearly or completely stopped. An airbag gives an unbelted dummy something softer to sink into, but it is the belt that lets the dummy share the car's longer stop.
How the model works
The numbers come from a simple model, set out under the graphs. After touching the barrier the car travels a fixed crush distance: 0.10 m with a stiff front and 0.50 m with a crumple zone. The force on the car, and on a belted dummy, rises steadily, levels off and falls again in a symmetric pattern. So the average speed during the stop is half the starting speed, which gives a stopping time of . Because the crush distance in this model does not depend on speed (a real car crushes further in a faster crash), doubling the speed doubles but halves , so the average force becomes four times as large. Real crashes are messier. The simulation shows how stopping time affects force; it does not tell you how likely an injury is.
Is this on my course?
AQA GCSE Physics covers this in section 4.5.7.3, Changes in momentum. It appears only in the separate physics course, not in Combined Science, and it is Higher tier, as is everything in section 4.5.7. You are given on the equation sheet and should be able to use it to explain how safety features such as seat belts and air bags work. For Cambridge IGCSE Physics (0625), topic 1.6 lists momentum, impulse and as Supplement material, which is assessed only on the Extended papers. Neither syllabus mentions force–time graphs, and AQA does not use the word impulse, so treat the area under the graph as a useful extra that follows from the same equation.