Skip to content

Motion simulation

Free Fall and Air Resistance Simulation

Drop objects on four worlds, with or without air. Watch weight and drag arrows change as the speed builds, see the velocity–time graph flatten at terminal velocity, and open a parachute partway down to find a new, slower steady speed.

Loading simulation…
Show symbols for

Predict first

Question 1 of 4

On the Moon, a hammer and a feather are let go at the same moment from 1.5 m above the ground. What will happen?

Try this

  1. 1Choose the Moon, pick the hammer and add the feather beside it. Predict which lands first, then press play.
  2. 2Choose the skydiver on Earth with the ½ρCdAv² model. Watch the drag arrow grow until it matches the weight arrow. What does the acceleration readout show at that moment?
  3. 3Press Open parachute once the skydiver has reached terminal velocity. Describe the shape of the velocity–time graph straight afterwards.
  4. 4Double the mass of the ball and drop it again with air resistance on. Then switch air resistance off and repeat. In which case does the mass change the result?
  5. 5Keep the same object and swap between F = kv and ½ρCdAv². Compare how quickly each velocity–time curve levels off.

What this simulation shows

Pick an object, a planet and a drop height, then let go. The object heads for the ground while the simulation tracks its height, velocity and acceleration, and plots a velocity–time graph as it goes. You can turn air resistance off, use a simple model in which drag is proportional to speed, or use a more realistic model in which drag grows with the square of speed.

Downwards counts as positive throughout, so a falling object has a positive velocity. A negative acceleration means the object is slowing down while still moving down.

Two forces on a falling object

Once an object has been released, two forces matter. Its weight pulls it down and is found from W=mgW = mg. Air resistance, also called drag, pushes against the direction of motion, so for a falling object it acts upwards. The arrows on the stage show both forces, plus the resultant, which is weight minus drag.

That resultant decides the acceleration: a=(W−D)÷ma = (W - D) \div m. At the moment of release the object is not yet moving, so there is no drag and the acceleration equals gg.

Why terminal velocity happens

Drag depends on speed. As the object gains speed, the drag arrow lengthens while the weight arrow stays put. The resultant shrinks, so each extra metre per second takes longer to gain. Eventually drag grows as large as the weight. With the two forces balanced, the acceleration drops to zero and the velocity stops changing. This steady speed is the terminal velocity.

The readout gives the terminal velocity calculated for the model you chose, and the moment the object comes within 1% of it. A short drop can end before that happens.

Reading the velocity–time graph

Acceleration shows up as the slope of the velocity–time graph. Without air the graph is a straight line, because the acceleration never changes from gg. With air resistance the line begins with that same gradient, then bends over and levels off as it closes in on the terminal velocity. Use the tangent tool to measure the gradient at several times and compare each value with the acceleration readout. The motion graphs simulation explores gradients and areas in more detail.

Opening the parachute

Choose the skydiver and press the parachute button partway down. The canopy greatly increases the area facing the air, so drag suddenly becomes far larger than weight. The resultant now points upwards and the skydiver decelerates, even though the motion is still downwards. As the speed falls, so does the drag, until the forces balance again at a new, much lower terminal velocity. Here the canopy takes about 2.5 s to fill, which keeps the deceleration to a few times gg, as happens with a real parachute.

Falling without air

Choose the Moon, drop the hammer and add the feather beside it. With no atmosphere there is no drag, so each object feels only its weight. A heavier object has a bigger weight but also more mass to accelerate, and the two effects cancel exactly, so everything falls with the same acceleration. Astronaut David Scott showed this on the Moon during the Apollo 15 mission in 1971. Repeat the drop on Earth to see how much the air matters.

Two models of drag

The linear model, F=kvF = kv, is easy to analyse and gives a terminal velocity of vt=mg÷kv_t = mg \div k. The quadratic model, F=12ρCdAv2F = \tfrac12 \rho C_d A v^2, is closer to how air behaves at everyday speeds, and its terminal velocity is vt=2mg÷(ρCdA)v_t = \sqrt{2mg \div (\rho C_d A)}. The air densities, drag coefficients and areas are model values of the right size, not measurements, and the air density is treated as constant with height. Mars has a far thinner atmosphere than Earth, so objects there reach much higher terminal velocities.

Equations

  • Weight

    W=mg

    weight = mass × gravitational field strength

    Open calculator →
  • Newton's second law

    F=ma

    resultant force = mass × acceleration

    Open calculator →
  • Uniform acceleration (v² − u² = 2as)

    v=u2+2as

    (final velocity)² − (initial velocity)² = 2 × acceleration × distance

    Open calculator →
  • Final velocity (v = u + at)

    v=u+at

    final velocity = initial velocity + acceleration × time

    Open calculator →
  • Distance under uniform acceleration (s = ut + ½at²)

    s=ut+12at2

    distance = initial velocity × time + 0.5 × acceleration × (time)²

    Open calculator →

Check your understanding

8 questions

  1. 1.A skydiver is falling at terminal velocity. Which statement is correct?
  2. 2.An object is let go from rest. What is its acceleration at the instant it is released, with or without air?
  3. 3.A ball falls through air. On its velocity–time graph, what happens to the gradient as time goes on?
  4. 4.An 80 kg skydiver falls at terminal velocity. Taking g = 10 N/kg, how big is the drag force?
  5. 5.Why does a skydiver slow down when the parachute opens?
  6. 6.On the Moon, a hammer and a feather dropped together land together. Why?
  7. 7.Using the linear model F = kv, a 2 kg object has k = 4 N s/m. Taking g = 10 N/kg, what is its terminal velocity?
  8. 8.Two balls of the same size fall through air. One has four times the mass of the other. With the quadratic drag model, how do their terminal velocities compare?

For teachers

Embed it in your site or open it full-screen for the projector.

Read more