Skip to content

GCSE Physics — AQA · Magnetism and electromagnetism

Electromagnetism and solenoids

4.7.2.1

Both tiers, Physics and Combined Science. A current in a wire is circled by field lines, weaker further out and stronger with more current. A solenoid's field is strong and uniform inside and shaped like a bar magnet's outside, and an iron core turns it into an electromagnet.

Loading simulation…

Symbols match your course. Open the full magnetic field around a wire and solenoid simulation for more presets and teacher tools.

Spec point 4.7.2.1: who sits it

Both tiers study this, in Physics and in Combined Science. No equation or required practical comes with it. Aim to:

  • describe a demonstration that a current is magnetic
  • sketch the fields of a straight wire and a solenoid, with arrows
  • explain why coiling the wire strengthens the effect
  • GCSE Physics only: explain an electromagnetic device from its diagram

AQA never names the right-hand grip rule, but the rule is a quick way to get the arrows right.

Showing the effect

Pass a vertical wire through a horizontal card, with plotting compasses round it: all point north. Switch on a current of several amps: the needles near the wire swing into a circle round it. Swap the supply leads and they turn the other way. Tapped iron filings form rings: the shape, but no direction.

The field round a straight wire

  • Circles centred on the wire, at right angles to it.
  • Weaker further out, so the circles get further apart.
  • Stronger with more current: draw the circles closer together.
  • Reversed current: every arrow turns round, and the shape stays.

Point your right thumb along the conventional current (+ to −) and close your fingers round the wire: they curl the way the circles run. Current towards you (⊙) gives anticlockwise circles; current away (⊗), clockwise.

Why a solenoid is stronger

A solenoid is a wire wound into a long coil. Through its middle, every turn's field points the same way, so the fields add up: far stronger than round a straight wire with the same current. Inside, away from the ends, the lines are straight, parallel and equally spaced: the field is strong and uniform. Outside, the pattern matches a bar magnet's.

More current, or more turns on the same length, makes it stronger. So does an iron core, which the coil turns into an induced magnet (4.7.1.1) adding its own field. With the core in place, it is an electromagnet. Cut the current and the iron loses nearly all its magnetism, so the electromagnet lets go.

Worked example: which end is N?

Facing the right-hand end of a solenoid, you see the current going round clockwise. Which end is N?

  1. Curl your right hand's fingers the way the current goes round the turns.
  2. Your thumb points left, and the thumb marks N: the left-hand end is N, the right-hand end S.
  3. Check: facing an end, anticlockwise current means N and clockwise means S. The right-hand end looks clockwise, so S.
  4. Arrow the outside lines from the left-hand end round to the right-hand end, and the inside lines from right to left.

GCSE Physics only: explaining a device

Follow the current, the magnet it makes, and what that magnet moves. In a relay, a low-voltage push button starts a large mains motor:

  1. Pressing the button lets a small current flow in the relay's coil, which has an iron core.
  2. The electromagnet attracts an iron armature, which turns on its pivot.
  3. The armature closes a pair of contacts, completing the motor's circuit.
  4. On release, the core loses its magnetism, a spring pulls the armature back and the contacts open.

The coil is not electrically connected to the contacts, so the button's thin wires carry only the small current. The same chain explains bells and circuit breakers.

On screen

In the simulation above, Straight wire opens with 5 A flowing up, out of the card (⊙), and eight compasses 4 cm from the wire.

  1. Field lines go reads Anticlockwise: check with your right hand. Press Reverse: the red N ends swing round and it reads Clockwise. Press Reverse again.
  2. Field at compass 1 reads 25 μT. Set Distance from the wire to 2 cm: 50 μT. Press More I five times (10 A): 100 μT. These values use an equation beyond GCSE.
  3. Choose Solenoid: N pole reads Right-hand end. Press Reverse: Left-hand end. Pick Soft iron under Core: the Core card puts the field at about 34 times the coil's own.
  4. Choose Electromagnet and pick None (air): no clips, whatever the current. Soft iron holds 6 at 200 turns and 2 A, and 28 at 5 A and 400 turns. Press Switch: every clip falls.
  5. (GCSE Physics only) Choose Relay and press Switch: Coil circuit shows 0.05 A, Contacts turns to Closed and Motor circuit shows 6 A.

Steel cores and Demagnetise go beyond the specification.

Common mistakes

  • Spacing the circles round a straight wire evenly. The field weakens with distance, so each circle should sit further from the next as you move out from the wire.
  • Using the left hand to find the field's direction. Fleming's left-hand rule gives the force on a wire in a field; for the field that a current makes, grip with the right hand, thumb along the conventional current.
  • Claiming a solenoid has a weak field inside, or none because the turns cancel. Through the middle of the coil the turns' fields combine, giving a strong, uniform field.
  • Arrowing the lines inside a solenoid from N to S. Outside they go from the N end to the S end; inside they continue from the S end to the N end, closing every loop.
  • Writing 'a bigger battery' or 'more power' as a way to strengthen an electromagnet. Name the change: a larger current, more turns of wire, or an iron core.
  • (GCSE Physics only) Saying that a relay's switch circuit carries the motor's large current. The coil is not electrically connected to the contacts: its small current only moves the armature.

Exam-style questions

Original questions written in the style of GCSE AQA. Try each one before you reveal the answer.

  1. 1.A student wants to show that an electric current produces a magnetic field. A long straight wire passes vertically through a hole in a horizontal sheet of card. The student also has a low-voltage d.c. power supply, a switch, six small plotting compasses and some iron filings.

    1. (a)Describe how the student could use this equipment to show the shape and direction of the field around the wire.

      6 marks
      Show the answer

      Answer: Connect the wire in series with the switch and the power supply. Before switching on, put the compasses on the card around the wire and note that they all point north. Close the switch so that a large current flows: the needles turn to lie along circles around the wire. Mark the way each N end points, then move the compasses round to build up complete circles with arrows. Sprinkle a thin layer of iron filings on the card and tap it gently, so that the filings form circles centred on the wire, showing the shape but not the direction. Finally, swap the supply connections and check that the needles now point the opposite way. Open the switch between observations so that the wire does not overheat. (Marked by level of response: the examiner judges the description as a whole. A clear, logically ordered method that covers both the shape and the direction, like this one, reaches the top level.)

      Marking points

      • Wire connected in series with the switch and the d.c. supply, and a (large) current switched on.
      • Compasses placed on the card around the wire, at different distances from it.
      • The direction of each needle's N end marked, giving arrows on the field lines.
      • Iron filings sprinkled on the card and the card tapped gently.
      • Compasses or filings show circles centred on the wire.
      • Current reversed and the needles seen to point the other way (or: switched off between readings because the wire gets hot).
    2. (b)Suggest why the compasses should be placed close to the wire.

      1 mark
      Show the answer

      Answer: Near the wire the field is at its strongest. Further away it is weaker, so the needles are turned less far from north.

      Marking points

      • The field is stronger near the wire (weaker further away), so the needles turn further from north there.
    3. (c)State one way the student should keep safe, and give the reason.

      2 marks
      Show the answer

      Answer: Switch the current on only for short times. A large current makes the wire hot enough to burn the student's fingers.

      Marking points

      • Switch off between readings / keep the current on only briefly.
      • A large current heats the wire, which could burn the skin.
  2. 2.A solenoid is made by winding insulated copper wire around a cardboard tube, and it is connected to a battery. Looking at end A from outside the tube, the current goes anticlockwise around the turns. End B is at the other end of the tube.

    1. (a)State which end of the solenoid is the north pole.

      1 mark
      Show the answer

      Answer: End A.

      Marking points

      • End A.
    2. (b)Describe the magnetic field produced by the solenoid, inside and outside the tube.

      3 marks
      Show the answer

      Answer: Inside the tube the field is strong, and its lines are straight, parallel and equally spaced, which shows it is uniform. Outside, the pattern matches a bar magnet's, with lines running round from end A to end B.

      Marking points

      • Inside: strong (stronger than outside).
      • Inside: uniform (straight, parallel, evenly spaced lines).
      • Outside: shaped like a bar magnet's field, with lines from A round to B.
    3. (c)A plotting compass is placed just beyond end B, on the axis of the solenoid. State which way the N end of the compass needle points, and explain why.

      2 marks
      Show the answer

      Answer: Towards the solenoid. End B is a south pole: outside the solenoid the field points into end B, and unlike poles attract, so the N end of the needle is pulled towards it.

      Marking points

      • Towards the solenoid (towards end B).
      • End B is a south pole, which attracts the N end of the needle (the field there points into B).
    4. (d)Explain why winding the wire into a solenoid gives a much stronger magnetic field than the same wire laid out straight with the same current.

      2 marks
      Show the answer

      Answer: Through the middle of the coil, the field of each turn points in the same direction. These fields reinforce one another, so the field inside is strong.

      Marking points

      • Inside the coil the field of each turn points the same way.
      • So the turns' fields add up (reinforce each other), giving a stronger field.
  3. 3.A recycling centre uses an electromagnet hanging from a crane to lift steel cans out of a heap of mixed metal waste.

    1. (a)What is meant by an electromagnet?

      1 mark
      Show the answer

      Answer: A coil of wire (a solenoid) wound round an iron core, which is magnetic while a current flows in the coil.

      Marking points

      • Coil of wire (solenoid) around an iron core.
    2. (b)Give two changes that would let the electromagnet lift a bigger load of steel cans.

      2 marks
      Show the answer

      Answer: Wind extra turns onto the coil, and increase the current through it.

      Marking points

      • Increase the current (in the coil).
      • Increase the number of turns (on the coil).
    3. (c)When the current is switched off, the cans fall. Explain why.

      2 marks
      Show the answer

      Answer: Once the current stops, the coil has no magnetic field of its own. The iron core was only an induced magnet, so its magnetism dies away almost at once and it no longer attracts the cans.

      Marking points

      • No current, so the coil makes no magnetic field.
      • The iron core was an induced magnet and quickly loses (most of) its magnetism, so the cans are no longer attracted.
    4. (d)The waste also contains aluminium cans. Explain why the electromagnet does not lift them.

      2 marks
      Show the answer

      Answer: Aluminium is not a magnetic material. The magnetic field does not magnetise it, so no force of attraction acts on the aluminium cans.

      Marking points

      • Aluminium is not a magnetic material (unlike iron, steel, cobalt and nickel).
      • So no (attractive) force acts on the aluminium cans.
  4. 4.(GCSE Physics only) A diagram shows a relay used to start a powerful motor in a factory. Circuit 1 contains a push switch, a low-voltage battery and the relay's coil, which is wound on an iron core. An iron armature on a pivot sits above the core, held up by a spring. When the armature is pulled down, its other end pushes two contacts together in circuit 2, which contains the motor and the mains supply.

    1. (a)Explain how pressing the push switch makes the motor start.

      4 marks
      Show the answer

      Answer: A current flows in the coil, so the coil and its iron core become an electromagnet. The electromagnet attracts the iron armature, which turns about the pivot, and the armature's far end presses the contacts together. This completes circuit 2, so a current flows through the motor.

      Marking points

      • Current in the coil makes a magnetic field (the core becomes an electromagnet).
      • The iron armature is attracted towards the core.
      • The armature turns about the pivot and pushes the contacts together.
      • Circuit 2 is completed, so current flows in the motor.
    2. (b)Explain one reason for using a relay instead of wiring the push switch straight into circuit 2.

      2 marks
      Show the answer

      Answer: It is safer for the operator. The switch is in a separate low-voltage circuit that carries only a small current, because the coil is not electrically connected to the contacts in the mains circuit.

      Marking points

      • Safer: the operator is kept away from the high-current mains circuit.
      • The switch circuit is separate (not electrically connected) and carries only a small current at low voltage.
    3. (c)The push switch is released. Describe what happens to the armature.

      1 mark
      Show the answer

      Answer: The core loses its magnetism, so the spring pulls the armature back up and the contacts separate. The motor stops.

      Marking points

      • The spring pulls the armature back, so the contacts open.

Quick check

6 questions

  1. 1.What shape are the field lines around a long, straight wire that is carrying a current?
  2. 2.You look at one end of a solenoid and see the current going clockwise round the turns. What is that end?
  3. 3.Which phrase describes the field in the middle of a solenoid carrying a current?
  4. 4.What happens to the poles of a solenoid when the current through it is reversed?
  5. 5.Why does putting an iron core inside a solenoid make its magnetic field stronger?
  6. 6.(GCSE Physics only) What does a relay allow?