Skip to content

GCSE Physics — AQA · Magnetism and electromagnetism

Fleming's left-hand rule

4.7.2.2Higher tier

Higher tier only, in GCSE Physics and Combined Science. A wire carrying a current across a magnetic field is pushed sideways: the motor effect. Fleming's left-hand rule links force, field and current, and F = BIl (on the equation sheet) gives the force on a wire perpendicular to the field.

Loading simulation…

Symbols match your course. Open the full the motor effect simulation for more presets and teacher tools.

Higher tier only: spec point 4.7.2.2

Only Higher tier papers test this, in both GCSE Physics and Combined Science. By the end, aim to:

  • explain the motor effect, including the push on the magnet
  • use Fleming's left-hand rule to find force, current or field from the other two
  • name the three things the size of the force depends on
  • apply F=BIlF = BIl, which is given on the equation sheet: select it rather than memorise it

Fields around current-carrying wires (4.7.2.1, both tiers) have their own page.

The motor effect

Every current sets up a magnetic field around its wire. Put that wire between two magnetic poles and the two fields interact, so the wire is shoved sideways: the motor effect. The magnet is shoved too, by a force just as big but pointing the other way, a Newton's third law pair.

The push is greatest when the wire crosses the field lines at right angles. Turn the wire until it lies along the field lines and the push vanishes.

Fleming's left-hand rule

On your left hand, hold the thumb, first finger and second finger at 90° to one another, like the edges at the corner of a box.

DigitLines up withMemory hook
First fingerthe magnetic field, from N to SFirst for Field
Second fingerthe conventional current, from + to −seCond for Current
Thumbthe force, which is the way the wire movesThumb for thrust

Flip the current or the field and the force flips. Flip both and the force is back where it started.

Worked explanation: finding the direction

In a diagram, a magnet's N pole is at the left-hand side and its S pole at the right-hand side. A wire between them carries current into the page. Which way is it pushed?

  1. First finger: from N to S, so to the right.
  2. Second finger: into the page.
  3. Thumb: down the page. The wire is pushed downwards.

How big is the force?

Three quantities decide the size of the push:

  • magnetic flux density BB, in tesla (T), a measure of field strength
  • current II, in amperes (A)
  • length of conductor in the field ll, in metres (m)

When the wire is perpendicular to the field,

F=BIlF = BIl

and FF comes out in newtons (N). Doubling any one quantity doubles the force. Use the equation only for a perpendicular wire: a wire parallel to the field feels no force, and AQA does not ask you to calculate the force at angles in between.

Worked example: a rod on rails

A copper rod lies across two metal rails, and 6.0 cm of it sits in a 0.35 T field, perpendicular to the rod. The rod carries 4.0 A. Find the force on it.

Given: B=0.35B = 0.35 T, I=4.0I = 4.0 A, l=6.0l = 6.0 cm =0.060= 0.060 m. Equation: F=BIlF = BIl. Substitution: F=0.35×4.0×0.060F = 0.35 \times 4.0 \times 0.060. Answer: F=0.084F = 0.084 N (2 s.f.).

Rearranging: if a 0.15 m wire carrying 2.5 A feels a force of 0.045 N, then B=FIl=0.0452.5×0.15=0.0450.375=0.12B = \dfrac{F}{Il} = \dfrac{0.045}{2.5 \times 0.15} = \dfrac{0.045}{0.375} = 0.12 T.

Try the rule on screen

In the simulation above, the stage opens on Wire in a field: a 0.1 m rod carrying 2 A across a 0.5 T field, with N on the left. The current, labelled with a violet I, flows towards you, and the hand rule is already on show, its current arrow violet too.

  1. Force on the wire reads 0.1 N, since 0.5×2×0.1=0.10.5 \times 2 \times 0.1 = 0.1, and Direction of the force says upwards. Match the drawn hand with yours.
  2. Press Reverse I: the rod is pushed downwards and the hand turns over, but the size stays 0.1 N. Press Flip magnet as well, and the push is upwards again.
  3. Set Current to 4 A and the force becomes 0.2 N. Then halve Length of wire in the field to 0.05 m: back to 0.1 N.
  4. Use the Turn the wire to an angle toggle, then drag Angle between wire and field down to 0°. The force falls to 0 N. Working at other angles is tagged Beyond GCSE.

Equations

  • Force on a current-carrying conductor

    On the equation sheet · Higher tier

    F=BIl

    force on a conductor (at right angles to a magnetic field) carrying a current = magnetic flux density × current × length

    Open calculator →

Common mistakes

  • Using the right hand. The rule for the force on a current in a field is the left-hand rule, and the right hand gives exactly the opposite direction.
  • Muddling the digits. The first finger points along the field, the second finger along the current and the thumb gives the force, which is the way the wire moves.
  • Aiming the second finger along the electron flow. The rule uses conventional current, from + to −, and electrons drift the other way.
  • Leaving the length in centimetres. Change l to metres before substituting into F = BIl, or the force comes out 100 times too large.
  • Using F = BIl for a wire that is not perpendicular to the field. The equation only applies when the wire crosses the field at 90°; a wire lying along the field lines feels no force at all.
  • Forgetting that the magnet is pushed too. The wire and the magnet exert forces of equal size on each other, in opposite directions.

Exam-style questions

Original questions written in the style of GCSE AQA. Try each one before you reveal the answer.

  1. 1.A student clamps a short, horizontal copper wire in the gap of a horseshoe magnet, with the N pole at the left of the gap and the S pole at the right. Closing the switch sends a current through the wire into the page, and the wire moves.

    1. (a)Name the effect that makes the wire move.

      1 mark
      Show the answer

      Answer: The motor effect.

      Marking points

      • Motor effect.
    2. (b)Use Fleming's left-hand rule to work out which way the wire is pushed.

      1 mark
      Show the answer

      Answer: Downwards, towards the bottom of the page. With the first finger aimed right, from N to S, and the second finger into the page, the thumb aims down.

      Marking points

      • Downwards (down the page).
    3. (c)Give two separate changes that would each make the wire move in the opposite direction.

      2 marks
      Show the answer

      Answer: Reverse the current, for example by swapping the connections to the power supply. Turn the magnet round so that the N and S poles change sides.

      Marking points

      • Reverse the current (swap the supply connections).
      • Reverse the magnetic field (turn the magnet round / swap the poles).
    4. (d)The wire also exerts a force on the magnet. Compare this force with the force that the magnet exerts on the wire.

      2 marks
      Show the answer

      Answer: The forces are equal in size and point opposite ways, so the magnet is pushed upwards.

      Marking points

      • Equal in size.
      • Opposite in direction (upwards on the magnet).
  2. 2.A straight wire passes through a uniform magnetic field at right angles to the field. 4.0 cm of the wire is inside the field. The magnetic flux density is 0.30 T and the current in the wire is 1.5 A.

    1. (a)Calculate the force on the wire. Use the Physics equation sheet.

      3 marks
      Show the answer

      Answer: l = 4.0 cm = 0.040 m. F = BIl = 0.30 × 1.5 × 0.040 = 0.018 N.

      Marking points

      • Length converted to 0.040 m.
      • Substitution: F = 0.30 × 1.5 × 0.040.
      • F = 0.018 N.
    2. (b)The current is changed until the force on the wire is 0.030 N. Calculate the new current.

      3 marks
      Show the answer

      Answer: I = F ÷ (B × l) = 0.030 ÷ (0.30 × 0.040) = 0.030 ÷ 0.012 = 2.5 A.

      Marking points

      • Rearrangement: I = F ÷ (B × l).
      • Substitution: I = 0.030 ÷ (0.30 × 0.040).
      • I = 2.5 A.
    3. (c)The wire is turned so that it lies parallel to the field lines. State the force on the wire now.

      1 mark
      Show the answer

      Answer: Zero: 0 N.

      Marking points

      • Zero (0 N).
  3. 3.A teacher places a U-shaped magnet on a top-pan balance. A stiff horizontal wire is clamped so that it passes through the gap between the poles without touching the magnet. With no current in the wire, the balance is set to read zero.

    1. (a)When a current flows in the wire, the reading on the balance increases. Explain why.

      3 marks
      Show the answer

      Answer: A current flows through the wire inside the field, so the wire feels a force (the motor effect), upwards in this case. The magnet receives an equal push the opposite way. This downward force on the magnet makes it press harder on the balance.

      Marking points

      • A force acts on the current-carrying wire in the field (motor effect).
      • The magnet feels an equal and opposite force (Newton's third law).
      • The force on the magnet is downwards, so the balance reading goes up.
    2. (b)Describe how the teacher could use this apparatus to find out how the force depends on the current.

      6 marks
      Show the answer

      Answer: Put an ammeter and a variable resistor in series with the wire and the power supply. Zero the balance with no current. Set a small current, read the ammeter and record the change in the balance reading. Increase the current in equal steps, about five or six times, recording the balance reading each time. Convert each reading into a force: mass in kilograms × 9.8 N/kg. Keep the same magnet and the same length of wire in the field throughout. Repeat each reading and find a mean. Plot force against current: a straight line through the origin shows the force is directly proportional to the current. Turn the current off between readings to stop the wire heating up. (Level of response: the answer is judged as a whole and given a level. A complete method in a sensible order, with a way to analyse the results, gets the top level.)

      Marking points

      • Ammeter and variable resistor (or variable supply) in the circuit to measure and change the current.
      • Balance zeroed with no current, then the reading recorded for each current.
      • At least five different currents used.
      • Balance readings converted to force (mass in kg × 9.8 N/kg).
      • Same magnet and same length of wire in the field kept throughout (control variables); readings repeated and averaged.
      • Graph of force against current plotted; a straight line through the origin shows direct proportion.
  4. 4.Fleming's left-hand rule shows how three quantities are arranged when a current-carrying wire is in a magnetic field.

    1. (a)State what the first finger and the second finger each represent.

      2 marks
      Show the answer

      Answer: The first finger represents the magnetic field (from N to S). The second finger represents the conventional current.

      Marking points

      • First finger: the (direction of the) magnetic field.
      • Second finger: the (direction of the conventional) current.
    2. (b)Describe how the directions of the force, the field and the current are arranged.

      1 mark
      Show the answer

      Answer: No two of them are parallel: force, field and current are all at right angles to one another.

      Marking points

      • All three at right angles (90°) to one another.
    3. (c)Name three quantities that determine how big the force on the wire is.

      3 marks
      Show the answer

      Answer: The magnetic flux density (strength of the field), the size of the current, and the length of wire inside the field.

      Marking points

      • Magnetic flux density (strength of the magnetic field).
      • Current in the wire.
      • Length of the wire in the field.

Quick check

6 questions

  1. 1.In Fleming's left-hand rule, which part of the hand shows the direction of the magnetic field?
  2. 2.A 0.20 m wire carries 3.0 A at right angles to a 0.050 T field. What is the force on it?
  3. 3.Which change leaves the force on a wire in a field just as big as before?
  4. 4.The current in a wire and the flux density of the field are both doubled. What happens to the force?
  5. 5.A field points to the right and the current in a wire flows into the page. Which way is the force?
  6. 6.Why does a magnet feel a force when a current flows in a wire between its poles?