What this topic covers
A ceiling fan in Dhaka, a car's starter motor in Toronto and a phone speaker all rely on one effect: a wire carrying a current is pushed when it sits in a magnetic field. Syllabus 4.5.4 covers that push on one straight wire; spinning coils are on the d.c. motor page.
Showing the force (Core)
A light copper rod rests across two bare copper rails. A U-shaped magnet sits with one pole above the rod and the other below it, so its field passes vertically through the rod. The rails are joined through a switch to a low-voltage d.c. supply.
- Close the switch: the rod rolls along the rails, so a force acts on it.
- Swap the leads at the supply to reverse the current. The rod rolls the opposite way.
- Put the leads back and turn the magnet over so its poles swap places. Again the rod rolls the opposite way.
- Reverse the current and the field together: the rod goes the same way as in step 1.
Close the switch only briefly: the rod and rails are almost a short circuit, so they heat up fast. With no current, or no magnet, the rod stays put. A larger current or a stronger magnet gives a bigger push.
Fleming's left-hand rule (Supplement)
Hold out your left hand with its thumb and first two fingers all at right angles. Line up the first finger with the field, from N towards S, and the second finger with the conventional current, from + round to −. The thumb then shows the force: the wire moves that way.
The rule needs the current to cross the field at right angles; a wire lying along the field lines is not pushed.
Worked example: predicting the push (Supplement)
A diagram shows an N pole above a wire and an S pole below it. Current flows into the paper along the wire. Which way is the wire pushed?
- Field: N to S, so down the page. First finger downwards.
- Current: into the paper. Second finger pointing away from you.
- Force: your thumb points to the left.
With the current out of the paper, the push is to the right. Turn the magnet upside down too and it is left again.
Beams of charged particles (Supplement)
Moving charges are a current even without a wire, so a magnetic field pushes on them. The push is always at right angles to their motion, so the beam bends into a curve. For positive particles, point your second finger the way they travel. For electrons, point it the opposite way, as conventional current runs against the electron flow.
Electrons travel from left to right across a field pointing into the page. Conventional current: right to left. First finger into the page, second finger to the left: the thumb points down, so the beam curves downwards. Positive particles moving the same way would curve upwards.
In the simulation above
In the simulation above, Wire in a field opens with a copper rod hanging in a U-shaped magnet's gap, N on the left. Field strength is 0.5 T and Current is 2 A, drawn in violet and flowing out of the screen. Hand rule is already pressed, so a left hand in the corner follows every change.
- (Core) The rod is pushed up. Press Reverse I: now it is pushed down. Press Flip magnet too: back up.
- (Core) Raise Current, then Field strength: the force arrow grows. Take either to zero and the force vanishes, then raise it again.
- (Supplement) Press Hand rule to hide the hand. Before each press of Reverse I or Flip magnet, predict the push with your own left hand, then check the Direction of the force card.
- (Supplement) Under Moving charges, choose Electrons: the dots now drift the opposite way to the conventional current, which is how electrons move in a wire or a beam.
The force values, the F = BIL working and the tesla go beyond 0625. So does Turn the wire to an angle.