A clap, a wall and a stopwatch
A student claps once in front of a tall wall. The stage draws the sound as an orange ring spreading out from the hands. When it meets the wall, part of it turns round and heads back as a teal ring, as if it came from a second clapper hidden behind the wall. That returning ring is the echo, shown four times slower than real life.
By the time the echo is heard, the sound has crossed the gap twice. If the wall is a distance away, the sound covers in the echo time , so and
Leaving out the 2 is the most common slip in echo questions. At the start, 85 m from the wall in air at 15 °C, sound moves at 340 m/s and the echo takes s. Warmer air carries sound slightly faster ( with in °C, a formula beyond the AQA, Cambridge and Punjab courses).
Why one stopwatch timing is not enough
Whoever holds the stopwatch presses start a moment after the clap and stop a moment after the echo. Each delay is a reaction time of around a fifth of a second, and it changes from press to press, so repeated readings spread out. The strip under the scene marks each late press, and the Results card gives every set of timings a mean, a speed and an uncertainty of half the range.
Here the start and stop delays have the same average, so they cancel on average and only the scatter is left. In real life one press is often later than the other, for example when the clap can be seen coming. That difference is a systematic error: repeating does not remove it, although timing many echoes still shrinks it.
There are two cures. Moving further back makes the echo take longer while the reaction error stays the same size. Better still, clap again each time an echo arrives and time 20 intervals together: the same error is now spread over twenty journeys, and the uncertainty in the speed shrinks to about one per cent or less. Closer than about 17 m, the echo returns in under a tenth of a second and merges with the clap, so a stopwatch cannot time it at all, although the microphone and timer can. (This 0.1 s rule is in the Punjab course; AQA and Cambridge do not ask for it.)
Two microphones, no echo
The two-microphone scene measures the speed of sound without a reflection. A clap passes microphone A, which starts a fast timer, and then microphone B, which stops it. Each microphone hears the sound once, so here with no halving.
Echo sounding at sea
Choose Sonar and a ship sends a short pulse of ultrasound down through sea water at about 1500 m/s. A shoal of fish returns a small early echo and the seabed a larger, later one, and the echo sounder plots both against time. Halve speed × time for each to find its depth; the shallower reflector always answers first.
The Sonar 1 kHz set-up puts the fish 1 m above a seabed 30 m down and sends an audible 1 kHz note instead. A pulse lasts a few cycles, so a low frequency means a long pulse, and the two echoes smear into one. Switch back to 50 kHz and they separate: the wavelength in sea water is only 3 cm, which is why ultrasound picks out finer detail.
Looking inside the body and inside steel
The scan scene puts a probe on the skin or on a steel block. The A-scan shows a spike for each boundary the pulse meets: fat and muscle, both sides of an organ, then bone. Each depth follows from the same rule, using 1540 m/s in soft tissue or about 5900 m/s in steel. Slide the probe across the block and a hidden crack appears as an extra echo before the far side. For the waves themselves, see the sound waves and oscilloscope simulation.