A tank seen from above
The stage shows a shallow tank from directly overhead, like the shadow picture a real ripple tank throws onto paper below it. A motor drives a straight bar, or one or two dippers, up and down. Each crest acts as a weak lens, gathering the lamp's light into a bright line, and each trough spreads it into a darker band. Gauze beaches soak up ripples at the edges.
The model water is about 6 mm deep, where ripples travel at 0.25 m/s; over the glass plate it is about 2 mm deep and they slow to 0.15 m/s. The motor alone sets the frequency, from 4 to 10 Hz.
Measuring wavelength, frequency and speed
The Measure set-up follows the required practical. Ripples race past too quickly to measure by eye, so switch on the strobe: it flashes once per wave, catching each crest exactly where the one before it stood, so the pattern seems to stand still. Put marker A on one bright line and marker B on another several lines further on, then count the gaps between them rather than the lines. Measuring across many wavelengths makes a slip at either end matter less.
For the frequency, press Count. A stopwatch runs for ten seconds of tank time and adds one for every crest that lifts the cork; divide the tally by ten. Or pin two neighbouring crests on the cork's height graph to read the period, then take its reciprocal. Multiply your frequency in hertz by your wavelength in metres, not centimetres, and compare the product with 0.25 m/s.
Reflection and refraction
In the Reflection set-up a metal strip stands at a slant across the ripples. The guides draw the normal, at right angles to the strip. The incoming and outgoing ripples make equal angles with it, on opposite sides.
In the Refraction set-up the glass plate is a raised step in the floor of the tank. The ripples keep the bar's frequency but cover less ground in every cycle, so the bright lines crowd together: lines 5.0 cm apart in the deep part close up to 3.0 cm over the plate at 5 Hz. When the edge is slanted, one end of each front reaches the shallow water and slows first, so the front swings round to lie more nearly along the edge, and the direction of travel turns towards the normal. With the edge parallel to the ripples, only their spacing changes.
Gaps and edges
Make the gap match the wavelength and the ripples leave it as curved fronts spreading behind the barrier. Widen it to four wavelengths and most of the energy travels straight on as a beam whose ends curve only slightly. Lowering the frequency at a fixed gap does the same as narrowing it: what matters is the gap compared with the wavelength. At a single edge, ripples with a longer wavelength curl further round into the shadow.
Two dippers
With two dippers moving in step, their circles overlap. Along some lines crests always meet crests and the water swings strongly; along others a crest from one dipper always meets a trough from the other, and the water barely moves. The still lines are where one dipper is half a wavelength, or one and a half, further away than the other. This goes beyond GCSE and IGCSE.
AQA GCSE uses the tank in required practical 8; diffraction and interference are not on that specification. Cambridge IGCSE uses it for reflection, refraction and diffraction (Core), adding how gap width and wavelength matter (Supplement). Punjab students meet it in Class 10, Chapter 12.