What happens on the bench
An immersion heater sits in a 1 kg sample: a beaker of water, a beaker of cooking oil, or a metal block with one hole for the heater and another for a thermometer probe. A small drop of oil in the probe hole gives good thermal contact. A joulemeter counts the energy going into the heater, a digital thermometer shows the temperature to 0.1 °C and a stopwatch runs alongside. One second on screen is twenty seconds of the experiment, so ten minutes of heating takes half a minute.
Press play, then press Record whenever you want a row in the results table. The simulation also notes the readings once a minute, unless you switch that off in the Results panel. Switch the heater off and on yourself, or let the timer do it.
Two ways to get c from your readings
The quick method uses just two readings, the first one and the highest one:
Take the energy from the joulemeter and the temperature rise from the thermometer. For the rise, use the highest reading, which comes a little after the heater goes off.
The more reliable method uses a graph. Plot temperature against energy supplied. In the straight part, each joule raises the temperature by , so the gradient equals and . A line through many points smooths out the small rounding in each reading. The simulation leaves out readings from the first minute, while the block is still evening out, and readings taken with the heater off.
Why your answer comes out too high
With the starting settings you should find a value close to 930 J/(kg °C), slightly above the accepted 900. Remove the lagging and it rises above 1000. The reason is worth learning properly. The joulemeter measures every joule the heater supplies, yet some of that energy warms the air, the bench and the mat instead of the block. That energy never appears as a temperature rise. The rise is therefore smaller than it would be, and dividing the energy by a smaller rise gives a bigger value of c.
The loss rate in the model grows with how far the sample is above room temperature. That is why the temperature–time graph bends over more and more as the block gets hotter, and why lagging, which slows the losses, straightens it. The green line on the graph shows where the temperature would be if nothing escaped. The bar under the readouts splits the supplied energy into the part stored in the sample and the part lost to the room. The two parts always add up to the joulemeter total, because no energy is created or destroyed.
Comparing materials
Heat a second sample beside the first with an identical heater. Equal masses and equal energy give very different rises. Copper warms more than twice as much as aluminium, and water warms least of all. Notice the sizes too: 1 kg of copper is a much smaller block than 1 kg of aluminium, because copper is far denser.
Choose No losses to see the ideal case that no real lab reaches. The final reading then matches exactly. For the energy and power side of this practical, the power and efficiency simulation is a good next step.