The bench
A thin wire lies along a wooden metre rule, taped down at each end. A red clip holds it at the zero mark and a black crocodile clip bites onto it wherever you put it, so the reading at that clip is the length of wire carrying current. The supply, an ammeter and that length of wire make a single series loop. The voltmeter is clipped on at those same two points, so its reading is the potential difference across only the stretch being tested. Both meters are digital and choose their own range, showing three decimal places below 2.
Two readings, one resistance
Each press of Record stores both meter readings and works out
The clip goes on afresh for the next reading, so a repeat at the same mark lands a millimetre or so away and gives a slightly different value. Two or three readings at every length, averaged, smooth out that scatter.
A straight line through zero
Plot the mean resistance against length and the crosses settle on a straight line aimed back at the origin. Twice the length gives twice the resistance, so while the temperature holds steady. The gradient is the resistance of one metre of this wire. The dashed triangle under the line covers more than half of it, as examiners expect, and the box beneath the graph shows the division.
Thinner wire, steeper line
Resistance also depends on cross-sectional area, and the area of a round wire grows with the square of its diameter:
Half the diameter leaves a quarter of the area and four times the resistance per metre, so that line climbs four times as steeply. The micrometer panel measures the diameter at three points along the wire. Use the mean, because a 1% slip in becomes a 2% slip in .
Resistivity
Courses that go further merge both effects into , where the resistivity belongs to the material, not the shape. Multiply the gradient by the measured area to find in ohm metres. Typical values are about for constantan, for nichrome and for copper. Copper makes a poor test wire: a whole metre of it has well under an ohm, about as much as the leads and clips.
Keep it cool
Current warms the wire, and a warmer metal resists more. Leave the supply on with a short piece of nichrome and the ammeter reading creeps down; force far too much current through and the wire starts to glow. Constantan hardly changes, which is why schools like it, yet it still gets hot enough to burn a finger. A low supply setting, sensible lengths and switching off between readings protect your results. The temperatures shown come from a simple model.
Zero errors
Switch on contact resistance and every reading picks up roughly 0.3 Ω extra. The new line runs parallel to the old one but meets the resistance axis above zero. That is why the gradient, rather than any single value of , gives the trustworthy answer.
In your course
AQA GCSE uses this set-up for Required practical 3 and asks only for and the effect of length, so area and resistivity are marked beyond GCSE. Cambridge IGCSE adds the effect of cross-sectional area but stops short of resistivity. The Punjab Physics 10 book uses in Chapter 16.