What happens on the stage
A steel spring hangs from the arm of a clamp stand, next to a metre rule whose zero lines up with the top of the spring. A red pointer fixed to the bottom of the spring marks its length on the rule, and a magnifier follows the pointer so you can read it to a fraction of a millimetre. Each press of Add hangs another 100 g. The hanger itself counts as the first 100 g. The spring dips, bounces gently and settles.
The load is the weight of everything hanging below the spring, found from with the value of g your course uses. Record copies the load, the length and the extension into the results table and adds a point to the graph.
Length is not extension
The commonest slip in this practical is plotting how long the spring is instead of how much it has grown. The dashed line marks where the pointer sat with nothing on, which is the original length. The glowing bracket beside the rule runs from that line down to the pointer, and its size is the extension:
Double the load and watch. The bracket doubles, but the pointer reading does not, because every reading still includes the original length. Cambridge, Punjab and several other courses call the extension rather than . Pick your course in the symbol switcher and the readouts change letter to match.
What the graph tells you
Plot force up the side and extension along the bottom. Cambridge calls this a load–extension graph. While the spring obeys Hooke's law, the points fall on a straight line passing through the origin, and its slope is the spring constant k in newtons per metre. Choose the gradient tool, run it along the line to measure k, then check your value against the Spring constant card. A stiffer spring gives a steeper line.
The area under the line is the work you did to stretch the spring. On the straight section that area is a triangle, so the energy stored is
Use the area tool from zero to your last point and compare it with the Energy stored card.
Past the limit of proportionality
Keep loading the soft spring. After 500 g the points begin to bend away from the straight line towards the extension axis, because each extra 100 g now pulls it out further than the one before. That bend is the limit of proportionality. Slightly beyond it is the elastic limit. Below that point, lifting the masses off brings the pointer all the way back to the dashed line. Above it the coils open up for good, and with everything removed the pointer stays below the line. The leftover stretch is a permanent extension, and points taken on the way down form a second, lower line on the graph. Swap in a new one to start again with a fresh spring.
Pairs of springs and a rubber band
Hang two stiff springs one below the other and each carries the whole load, so their extensions add and the pair acts like a softer spring with half the spring constant. Hang them side by side and they share the load, which doubles the spring constant. A rubber band is different again. It goes back to its original length, so it is elastic, yet its graph curves from the very first point, so it never obeys Hooke's law.
About the numbers
The spring constants and limits are model values, chosen so that the important changes fall between whole numbers of 100 g masses. Real springs vary, and a real rubber band returns along a slightly lower curve as it is unloaded. The bounce after each change is only there to look natural: every reading uses the settled position.