What is on the stage
A battery, a switch, two ammeters and one component make a single loop. Glowing dots drift away from the battery's negative terminal. Each dot stands for a huge number of free electrons, and every sixth dot marks the middle of a bunch holding exactly one coulomb. A stopwatch, a charge counter and an energy counter sit inside the loop. Swap the lamp for a heater, a motor or a resistor, change the battery's voltage and the resistance, and every number responds.
Counting coulombs
The stopwatch runs only while the switch is closed, so its reading is the time for which charge has been moving. The number of bunches crossing an ammeter each second equals the current in amperes, and the counter climbs by that many coulombs every second:
Both ammeters always agree. A bunch entering the component leaves it with exactly the same charge, because nothing in a series loop can store or destroy charge. On the charge–time graph the line is straight, and its gradient is the current; try the tangent tool.
A volt is a joule per coulomb
Each bunch carries an amber energy bar. It leaves the battery full, empties while it crosses the component, travels back empty and is refilled inside the battery. With a 6 V battery every coulomb hands over 6 J, so
That is exactly what the p.d. across a component measures. The e.m.f. of the battery describes the same exchange from the other side: the work the battery does on each coulomb it sends round. The model battery has no internal resistance, so its e.m.f. and the p.d. across the component are equal.
Power three ways
Power is energy transferred per second. Joules per coulomb multiplied by coulombs per second gives , and for a fixed resistance, substituting gives two more forms:
The Working box checks all three with live values, and the gradient of the energy–time graph gives the same answer. Doubling the voltage across the same resistor makes the power four times bigger, because the current doubles too. A motor is different: in this model, most of its energy goes to its kinetic store, so with the coil's resistance only finds the small share that heats the coil. Use for the total.
From joules to kilowatt-hours
Press Appliances to leave the bench for a home. Pick a kettle, a fan heater, a desk fan, a phone charger or an LED lamp, each with a typical rounded power rating, then set the hours of use and the price of a kilowatt-hour. A time-lapse meter rolls through the energy used:
The cost is the energy in kWh multiplied by the price of one kWh, so a 2 kW heater left on for 3 hours uses 6 kWh. The comparison bars show how heating water or air dwarfs charging a phone.
Honest about the model
The dots move far faster than real electrons, whose drift is well under a millimetre per second. A lamp still lights almost at once, because the electric field reaches the whole loop at nearly the speed of light and sets every electron moving together. Lamps, heaters and resistors keep fixed resistances here, although a real filament's resistance rises as it warms up. The energy bars picture what voltage means; in reality the energy travels through the fields around the wires.
Symbols in your course
Choose your course under Show symbols for. GCSE (AQA) students see the battery's p.d., since AQA never uses e.m.f., and the kilowatt-hour goes beyond that specification. Cambridge writes work done as , so , and gives e.m.f. the symbol . The Punjab Physics 10 book covers all of these ideas in Chapter 16.