The space a magnet controls
The region round a magnet in which a magnetic pole, another magnet or a piece of magnetic material feels a magnetic force is called its magnetic field.
At every point a field has a magnitude (its strength) and a direction. The direction is the way the N pole of a compass needle points there: the way a lone N pole would be pushed.
Magnetic lines of force
Magnetic lines of force are imaginary lines drawn so that, at every point on a line, the field points along it. A compass placed on a line lies along it, its N end pointing the way of the arrow. Key properties:
- Outside a magnet, each line leaves the N pole and enters the S pole.
- Lines of force never cross: at a crossing the field would point two ways at once.
- They crowd together near the poles and spread apart further out.
- The field fills all the space round the magnet; a drawing shows one flat slice.
Reading strength from the spacing
Picture a small window of fixed size facing the lines head-on. The field strength there is proportional to the number of lines passing through it. Packed lines mean a strong field; widely spaced lines, a weak one. Around a bar magnet the lines are densest near the two ends, where the field is strongest.
Between the poles of a horseshoe magnet, nearly parallel, evenly spaced lines show an almost uniform field.
Filings or compass?
Iron filings sprinkled on a card over a magnet are magnetised by the field. Tap the card and they line up, showing the whole pattern at once but not its direction. A plotting compass gives the direction, one point at a time.
Step by step: drawing a line of force
- Lay the magnet on white paper, draw round it and label N and S.
- Set a small compass near the N pole. Put a pencil dot at the N end of its needle.
- Slide the compass on until the S end of the needle sits on that dot. Mark a new dot at the N end.
- Keep stepping along, dot by dot, to the S pole or the paper's edge.
- Join the dots with a smooth curve and add arrows from N towards S. Repeat from other starting points.
Keep other magnets and steel almirahs away.
Neutral points
Place two identical bar magnets in a line with their N poles facing: the lines from each pole bend aside instead of joining. Midway, one magnet's field is equal in size and opposite in direction to the other's, so they cancel and the resultant field is zero. This is a neutral point, marked ×. A compass placed there gets no direction from the magnets.
With an N pole facing an S pole, lines run across the gap from N to S and there is no neutral point between them.
Mapping the field in the simulation
In the simulation above, the Lines of force are already on, running from the red N end to the blue S end.
- Choose Plotting with a compass and switch Lines of force off. Press Plot again and again: every press leaves a mark at the needle's tip and steps the compass forward, as in steps 2 to 4. The trail curves over the magnet until the compass is blocked near the S end. Switch the lines back on to check it. Then press Filings and turn the lines off once more: the filings make the same curves but show no direction. Turn the lines on again before step 2.
- Pick the Where is it strongest? set-up. With the compass in line, 2 cm out from the S end, Field strength shows about 770 μT. Under Move, pick Compass, set Up the paper to 3 cm, then Across the paper to 0 cm. Level with the middle, about 2 cm from the side, it reads only about 440 μT.
- Choose Like poles facing (N to N). With Compass still picked, set Up the paper to 0 cm. The compass sits on the × and the Compass needle card reads No direction.
- Choose Unlike poles facing (N to S). Lines bridge the gap, and no × lies between the magnets. The Neutral points card shows 2: they lie about 9 cm above and below the middle of the gap.