What this topic covers
Scatter iron filings on paper over a bar magnet and curved lines appear, as if drawn by an invisible hand. Syllabus 4.1 explains them.
What a magnetic field is (Core)
Every magnet is surrounded by a magnetic field. Anywhere inside it, another magnetic pole would be pushed or pulled. We picture the field with magnetic field lines.
Which way a field points (Core)
The field at any spot points the way an N pole put there would be pushed. An N pole is repelled by the magnet's N pole and attracted to its S pole, so outside the magnet field lines run from N to S.
A plotting compass needle is a tiny magnet, so its N end swings round to point along the field.
Drawing the field of a bar magnet (Core)
A good drawing has:
- lines that leave the N pole and curve round outside the magnet into the S pole;
- an arrow on each line, pointing from N towards S;
- smooth lines that never cross or touch, since a field can point only one way at each place;
- a symmetrical pattern, with several lines on each side, crowded close to each pole.
Plotting with a compass (Core)
- Draw round the magnet on paper and mark its N end.
- Set a plotting compass beside the N pole. Mark a dot just beyond the N end of the needle.
- Slide the compass until the S end of the needle rests on that dot, then mark a new dot beyond the N end.
- Continue until the dots reach the S pole. Join them with a smooth curve, add arrows the way the needle pointed, then repeat from other starting points.
Showing the pattern with iron filings (Core)
Lay thin card over the magnet, sprinkle filings thinly and tap the card gently. Each filing is magnetised by induction and lines up with the field, gathering along the lines. They show the whole shape in seconds but not the direction, as no filing has a labelled N end.
Field strength from line spacing (Supplement)
Closely packed lines mean a stronger field; widely spaced lines, a weaker one. Round a bar magnet the lines bunch together near each pole, so the field is strongest there; further away they spread out as it weakens. Only spacing matters, not line length, and the field also fills the gaps between drawn lines.
Worked example: reading a field diagram
A bar magnet lies across the page with its N pole on the right. A is 2 cm beyond the N end, on the axis. B is 2 cm from the side, level with the middle. C is 15 cm away.
(a) (Core) Which way does a compass needle point at A, and at B? At A, away from the magnet (to the right), as an N pole there is repelled. At B, parallel to the magnet and towards its S end (to the left).
(b) (Supplement) Rank A, B and C by field strength. A, then B, then C: the lines are tightest near a pole and widest apart at C.
Simulation tasks
In the simulation above, One magnet opens with Field lines already showing.
- (Core) Drag the compass round the magnet: the red N end of its needle always lies along the lines.
- (Core) Choose Plotting with a compass from the Set-up menu and switch Field lines off. Press Plot about eight times: every press drops a mark at the tip of the N end, then steps the compass forward, until it is blocked near the S pole.
- (Core) Press Filings: the same shape appears, without arrows.
- (Supplement) Choose Where is it strongest? and read Field strength 2 cm beyond the S end. Drag the compass to 2 cm from the side, level with the middle: the reading drops. Switch on Strength colours: they glow brightest at the poles.
The With the Earth’s field set-up and Neutral points card are extras beyond 0625.