Skip to content

Cambridge IGCSE Physics (0625) · Magnetism and electromagnetic effects

Magnets and magnetic materials

4.1

Core: like poles repel and unlike poles attract; a magnet attracts unmagnetised iron, steel, nickel and cobalt by inducing magnetism in them; soft iron makes temporary magnets, steel permanent ones; uses of both kinds. Supplement: magnetic forces come from fields acting on each other.

Loading simulation…

Symbols match your course. Open the full magnetic field of a bar magnet simulation for more presets and teacher tools.

What this topic covers

A scrapyard crane in Mombasa lifts a crushed car, drops it onto a lorry, and leaves the aluminium window frames in the heap untouched. The first half of syllabus 4.1 explains why.

Poles, attraction and repulsion (Core)

Every magnet has a north pole (N pole) and a south pole (S pole). A freely hanging magnet turns its N pole roughly northwards, because of the Earth's magnetic field (an extra fact, not needed for 0625).

  • N facing N, or S facing S: they push apart. Like poles repel.
  • N facing S: they pull together. Unlike poles attract.

A magnet also pulls on unmagnetised iron, with either pole, but never pushes it away. Attraction proves nothing, so repulsion is the only sure test: it needs a magnet on both sides. Magnetic forces act across a gap and get stronger as the gap closes.

Magnetic or non-magnetic? (Core)

A magnetic material is attracted by a magnet and can be magnetised. A non-magnetic material is neither.

MagneticNon-magnetic
Iron, steel, nickel, cobaltCopper, aluminium, brass, gold, glass, wood, plastic

Most metals are on the non-magnetic side.

Induced magnetism (Core)

Hold an unmagnetised iron nail near a magnet's N pole and the nail becomes a magnet, even before contact: its magnetism is induced. The end facing the N pole gains an S pole, so opposite poles sit side by side and the nail is pulled in. Near the S pole the induced poles swap, and it is attracted again. The nail can then lift a second nail, forming a chain.

Soft iron and steel (Core)

Soft ironSteel
Magnetising itVery easyHarder
After the magnet is removedLoses almost all its magnetismKeeps its magnetism
Kind of magnetTemporaryPermanent
Typical jobElectromagnet coreCompass needle, bar magnet

Where each kind is used (Core)

A permanent magnet needs no power supply. An electromagnet is a coil of wire, usually round a soft iron core, that is magnetic only while a current flows, so it can be switched on and off.

  • Permanent: compasses, fridge door seals, cupboard catches, loudspeakers, microphones, small motors.
  • Electromagnets: scrapyard cranes, electric door locks, MRI scanners, relays (topic 4.5.3) and electric bells.

When the crane's current stops, the soft iron core loses its magnetism and the scrap falls. A steel core would keep its grip.

Why magnets push and pull (Supplement)

Each magnet sits inside the other's magnetic field, and each field acts on the other magnet's poles. So the push or pull comes from the two fields acting on each other, which is why no contact is needed.

Worked example: sorting three bars (Core)

Three grey bars are tested against both poles of a labelled magnet. X is attracted by both. Y feels nothing. One end of Z is drawn towards the N pole but pushed away by the S pole.

(a) Identify each bar. Z is a magnet: only a magnet is repelled. X is magnetic but unmagnetised, such as iron. Y is non-magnetic, such as aluminium.

(b) Why is X attracted by both poles? Whichever pole comes near induces the opposite pole at X's near end.

(c) Which end of Z is N? The tested end was repelled by an S pole, so it is S. The far end is N.

Simulation tasks

In the simulation above, there is no iron or aluminium, so try induced magnetism with real nails.

  1. (Core) Choose Like poles facing (N to N) from the Set-up menu. The readout The two magnets shows Repel, and the force arrows point apart.
  2. (Core) Press Flip to reverse magnet 1. With an S pole now facing an N pole, the readout switches to Attract.
  3. (Core) Choose One magnet and drag the compass near each end. The needle is a tiny magnet: its N end points away from the magnet's N end and towards its S end.
  4. (Supplement) Choose Unlike poles facing (N to S): the Field lines join across the gap. Press Flip and the lines from the facing ends push away from each other.

Common mistakes

  • Using attraction to prove that a bar is a magnet. Plain unmagnetised iron is attracted as well, so attraction proves nothing; repulsion is the test, because it needs two magnets.
  • Calling aluminium, copper or brass magnetic just because they are metals. Of the everyday metals, only iron, nickel, cobalt and alloys such as steel are magnetic.
  • Swapping soft iron and steel. Soft iron is magnetised easily but loses its magnetism as soon as the magnet goes (a temporary magnet); steel is harder to magnetise but keeps it (a permanent magnet).
  • Reading 'soft' iron as iron that bends easily. In magnetism the word means that its magnetism comes and goes readily; here 'soft' describes its magnetism, not how bendy it is.
  • Saying that the end of a nail nearest a magnet's N pole becomes an N pole. It becomes an S pole, so unlike poles face each other and the nail is attracted.
  • Stating that an electromagnet should have a steel core. Its core is soft iron, so that it loses its magnetism when the current is switched off; a steel core would stay magnetised.

Exam-style questions

Original questions written in the style of Cambridge IGCSE. Try each one before you reveal the answer.

  1. 1.A technician in a school laboratory in Nairobi finds four rods, A, B, C and D, that look alike. Each rod is held in turn near the N pole and then near the S pole of a labelled bar magnet. Rod A is attracted by both poles. Rod B is not affected by either pole. One end of rod C is attracted by the N pole and repelled by the S pole. Rod D is attracted by both poles.

    1. (a)State which rod is a magnet. Give a reason for your answer.

      2 marks
      Show the answer

      Answer: Rod C, because it is repelled by one of the poles, and repulsion only happens between two magnets.

      Marking points

      • rod C
      • it is repelled (by the S pole) / only a magnet can be repelled
    2. (b)Rod B is a metal. Suggest which metal it could be made of.

      1 mark
      Show the answer

      Answer: Any non-magnetic metal, such as copper, aluminium or brass.

      Marking points

      • a non-magnetic metal, e.g. copper / aluminium / brass
    3. (c)State which end of rod C is its N pole.

      1 mark
      Show the answer

      Answer: The end that was tested is an S pole (it was repelled by the S pole), so the other end of rod C is its N pole.

      Marking points

      • the end that was not tested / the opposite end (the tested end is an S pole)
    4. (d)Rods A and D are soft iron and steel, but nobody knows which is which. Describe a test, using the bar magnet and some steel paper clips, to find which rod is steel.

      3 marks
      Show the answer

      Answer: Place each rod against the magnet, or stroke it with the magnet, so that it becomes magnetised. Take the magnet away and dip each rod into the paper clips. The steel rod keeps its magnetism and still picks up clips; the soft iron rod picks up few or none.

      Marking points

      • magnetise each rod (put each against the magnet / stroke each with it)
      • remove the magnet, then see whether each rod still picks up paper clips
      • the rod that still picks up clips (picks up more) is steel; soft iron picks up few or none
  2. 2.A student lets an iron nail cling to the S pole of a magnet, then hangs another iron nail below the first, making a short chain.

    1. (a)Name the effect that makes the nails into magnets.

      1 mark
      Show the answer

      Answer: Induced magnetism (magnetic induction).

      Marking points

      • induced magnetism / magnetic induction
    2. (b)State the type of pole at the top end of the upper nail, which touches the magnet.

      1 mark
      Show the answer

      Answer: An N pole, the opposite of the magnet's S pole.

      Marking points

      • N pole / north pole
    3. (c)The upper nail is pulled off the magnet, with the lower nail still hanging from it. State and explain what happens to the lower nail.

      2 marks
      Show the answer

      Answer: The lower nail drops off, because iron loses its magnetism almost at once when it is taken out of the magnet's field (it forms only a temporary magnet).

      Marking points

      • the lower nail drops / the nails separate
      • iron loses its (induced) magnetism easily / iron makes a temporary magnet
    4. (d)The nails are replaced by steel pins and the experiment is repeated. Suggest how the result is different when the upper pin is pulled off the magnet.

      1 mark
      Show the answer

      Answer: The steel pins keep some of their magnetism, so the lower pin may stay attached to the upper one.

      Marking points

      • pins stay together / still attract each other because steel keeps its magnetism
  3. 3.A scrapyard in Karachi uses a crane fitted with an electromagnet to load scrap onto lorries. The heap contains steel car parts and aluminium window frames.

    1. (a)State one advantage of using an electromagnet rather than a permanent magnet on the crane.

      1 mark
      Show the answer

      Answer: It can be switched off, so the crane can let go of its load where it is needed.

      Marking points

      • can be switched on and off / can release the load
    2. (b)The electromagnet has a soft iron core. Explain why soft iron is used rather than steel.

      2 marks
      Show the answer

      Answer: Soft iron loses its magnetism as soon as the current is switched off, so the scrap is released. A steel core would stay magnetised and keep holding the scrap.

      Marking points

      • soft iron loses its magnetism easily / is a temporary magnet
      • so the load drops when the current stops / steel would keep its magnetism and hold the load
    3. (c)Explain why the crane lifts the car parts but not the window frames.

      2 marks
      Show the answer

      Answer: The steel parts are made of a magnetic material and are pulled towards the electromagnet. Aluminium is non-magnetic, so there is no magnetic force on it.

      Marking points

      • steel is magnetic / is attracted (has magnetism induced in it)
      • aluminium is non-magnetic / is not attracted
    4. (d)Name one device that contains a permanent magnet.

      1 mark
      Show the answer

      Answer: For example a compass, a loudspeaker, a microphone or a fridge door seal.

      Marking points

      • any one: compass / loudspeaker / microphone / fridge door seal / magnetic catch / small electric motor
  4. 4.Two bar magnets lie end to end on a bench in Toronto, with their N poles facing each other and a small gap between them.

    1. (a)State the type of force between the magnets.

      1 mark
      Show the answer

      Answer: Repulsion: like poles push each other apart.

      Marking points

      • repulsion / they repel
    2. (b)One magnet is reversed, so an S pole is now opposite the other magnet's N pole. State what happens to the force.

      1 mark
      Show the answer

      Answer: It becomes a force of attraction.

      Marking points

      • attraction / they now attract
    3. (c)(Supplement) The magnets are not touching. Explain how they can still exert forces on each other.

      2 marks
      Show the answer

      Answer: Each magnet has a magnetic field that reaches the other magnet. The force between them is caused by the two magnetic fields interacting.

      Marking points

      • each magnet has a magnetic field that extends to (surrounds) the other magnet
      • the force is due to the interaction between the (two) magnetic fields
    4. (d)(Supplement) A thin sheet of plastic is pushed into the gap. Suggest whether the force between the magnets still acts, and give a reason.

      2 marks
      Show the answer

      Answer: Yes. Plastic is non-magnetic, so the fields pass through it and still interact.

      Marking points

      • yes, the force still acts
      • plastic is non-magnetic / the fields pass through it (and still interact)

Quick check

6 questions

  1. 1.Which pair contains only magnetic materials?
  2. 2.The N pole of a magnet repels one end of a metal bar. What does this show?
  3. 3.Why is soft iron chosen for the core of an electromagnet?
  4. 4.An unmagnetised iron nail is held near the S pole of a magnet. What happens?
  5. 5.Which job needs an electromagnet rather than a permanent magnet?
  6. 6.(Supplement) Two magnets attract each other without touching. What causes this force?