Skip to content

Cambridge IGCSE Physics (0625) · Waves and sound

Speed of sound and echoes

3.4

Sound moves through air at some 330–350 m/s. To measure it, time sound over a known distance. With an echo, the sound makes a return trip to the wall, so v = 2s ÷ t. Timing many echoes makes reaction time matter less. Supplement: in general, solids carry sound fastest and gases slowest.

Loading simulation…

Symbols match your course. Open the full speed of sound and echoes simulation for more presets and teacher tools.

Where this fits in 3.4

For a survey of all of 3.4, including the two-observer method, see Sound waves: the overview. This page looks closely at echo timing and its errors. Pulses, scans and sonar depths are on the Ultrasound page.

How fast is sound?

Core. In air, sound covers about 330 to 350 metres each second. (Beyond the syllabus: the speed rises a little as the air warms, roughly 331 m/s at 0 °C and 349 m/s at 30 °C, following v≈331+0.6θv \approx 331 + 0.6\theta with θ\theta in °C. This is one reason for the range.)

Supplement. The material matters far more than the temperature:

MaterialStateTypical speedCompared with air
Airgas340 m/s×1
Sea waterliquid1500 m/sabout ×4.4
Steelsolid5900 m/sabout ×17

The words "in general" matter, as there are exceptions: a few soft solids are slower than water. Cork, for example, carries sound at only about 500 m/s. Beyond the syllabus: a stiff solid springs back hard and fast when squeezed, so each compression is handed on quickly, while a gas is easily squashed.

Worked example 1 (Supplement). Two boats on a lake are 4.5 km apart. One strikes a bell under the water and sets off a bright flash at the same moment. On the other boat, an underwater microphone picks up the bell 3.0 s after the flash is seen. Given: s=4500s = 4500 m, t=3.0t = 3.0 s. Equation: v=stv = \dfrac{s}{t}. Substitution: v=45003.0v = \dfrac{4500}{3.0}. Answer: v=1500v = 1500 m/s, about 4.4 times faster than in air, where the sound would take about 13 s.

Echoes (Core)

An echo is sound that a surface has reflected. Large, hard, flat surfaces such as cliffs and brick walls send back strong echoes. Curtains, carpets and foam absorb much of the sound, which is why recording studios and cinemas use them.

Timing echoes to find the speed (Core)

  1. Stand a measured distance, such as 80 m, from a tall wall with open ground around you.
  2. Clap, then clap again each time the echo returns, keeping a steady rhythm.
  3. A partner starts a stopwatch on one clap, counts 25 intervals and stops it.
  4. Every interval is a trip to the wall and back: 2×80=1602 \times 80 = 160 m. Speed = 160 m ÷ time for one interval.

Every press of the stopwatch lags behind the sound by a reaction time, and the lag varies by up to about 0.1 s from press to press. Against a single half-second echo, that is a 20% error; spread over 25 intervals lasting about 12 s, it is under 1%. A microphone and electronic timer remove reaction time altogether. Beyond the syllabus: ears need about 0.1 s between a clap and its echo to hear them apart, so stand at least 17 m away.

Worked example 2 (Core). At 80 m from the wall, 25 intervals take 11.9 s. Time for one interval: 11.9÷25=0.47611.9 \div 25 = 0.476 s. Distance in one interval: 2×80=1602 \times 80 = 160 m. Substitution: v=1600.476v = \dfrac{160}{0.476}. Answer: v=336v = 336 m/s, inside 330–350 m/s. Forgetting the 2 gives 168 m/s, half the true value.

Clapping at the virtual wall

In the simulation above, a student claps 85 m from a wall in air at 15 °C. Echo time (under Readings) shows 0.500 s: 170 m at 340 m/s.

  1. (Core) Press Clap five times, letting the stopwatch stop each time. Under Results (a tab on phones, below the stage on a computer), the readings scatter around 0.5 s.
  2. (Core) Switch Timing to Clap ×20. Press the Clap ×20 button and wait about 11 s (it runs in real time) until the reading is added, then press it again. In Results, its mean time per echo has a far smaller ± than the stopwatch mean.
  3. (Core) Choose Mic + timer, move the Distance to the wall slider to 170 m and press Clap: 1.000 s, twice the time for twice the distance.
  4. (Beyond the syllabus) Drag Air temperature to 0 °C, then 30 °C: Speed of sound reads 331 m/s, then 349 m/s, both inside the 330–350 m/s range.
  5. (Supplement) Switch the scene to Sonar, then to Scan and choose Steel block: Speed of sound reads 1500 m/s in sea water, then 5900 m/s in steel.

Equations

Common mistakes

  • Using the distance to the wall as the distance travelled. For an echo the sound goes there and back, so it covers twice that distance: v = 2s ÷ t.
  • Dividing the total time by the number of claps. Twenty-one claps make 20 intervals, and each interval is one journey to the wall and back.
  • Trusting a single stopwatch timing of one echo. It lasts well under a second, so a reaction-time error of about 0.1 s can be 20% of it; time many intervals and repeat.
  • Rounding the time for one interval too early. 11.9 ÷ 25 = 0.476 s; using 0.48 s changes the answer from 336 m/s to 333 m/s.
  • (Supplement) Ranking liquids below gases because liquids seem thicker. In general, sound in water is over four times faster than in air, and in steel faster still.
  • Standing very close to the wall. Within about 17 m the echo returns less than 0.1 s after the clap and blends with it, so it cannot be timed by ear (this rule is beyond the syllabus).

Exam-style questions

Original questions written in the style of Cambridge IGCSE. Try each one before you reveal the answer.

  1. 1.A student stands 102 m from a tall brick wall on open ground. The student claps, and the sound reflects from the wall.

    1. (a)Suggest why the student uses a tall brick wall rather than a hedge.

      1 mark
      Show the answer

      Answer: A large, hard, flat surface reflects sound strongly and gives a clear echo; a hedge absorbs and scatters much of the sound.

      Marking points

      • a hard, flat surface reflects sound well (a hedge absorbs or scatters it)
    2. (b)The student claps in time with the echoes. A friend times 20 intervals between claps as 12.0 s. Calculate the speed of sound.

      3 marks
      Show the answer

      Answer: Time for one interval = 12.0 ÷ 20 = 0.600 s. Distance in one interval = 2 × 102 = 204 m. v = s ÷ t = 204 ÷ 0.600 = 340 m/s.

      Marking points

      • 12.0 ÷ 20 = 0.600 s
      • distance = 2 × 102 = 204 m
      • v = 204 ÷ 0.600 = 340 m/s
    3. (c)Explain why the friend times 20 intervals rather than a single echo.

      2 marks
      Show the answer

      Answer: Starting and stopping the stopwatch involves a reaction-time error of roughly the same size whatever is being timed. Over 20 intervals, that error is a much smaller fraction of the time measured.

      Marking points

      • reaction time causes an error (of about the same size) at the start and stop
      • the error is a much smaller fraction (percentage) of a longer measured time
    4. (d)State one other way to improve the reliability of the result.

      1 mark
      Show the answer

      Answer: Repeat the timing several times and take the mean. (Also accept: stand further from the wall, or use a microphone and electronic timer.)

      Marking points

      • repeat and find the mean / move further from the wall / use electronic timing
  2. 2.Two microphones are placed 1.50 m apart in a straight line and connected to an electronic timer. The timer starts when a sound reaches the first microphone and stops when it reaches the second. A student makes a sharp sound in line with the microphones.

    1. (a)The timer reads 4.4 ms. Calculate the speed of sound in air.

      3 marks
      Show the answer

      Answer: t = 4.4 ms = 0.0044 s. v = s ÷ t = 1.50 ÷ 0.0044 = 341 m/s (about 340 m/s).

      Marking points

      • 4.4 ms = 0.0044 s
      • v = 1.50 ÷ 0.0044
      • v = 341 m/s (accept 340 m/s)
    2. (b)Explain why the distance is not doubled in this method.

      1 mark
      Show the answer

      Answer: Nothing is reflected: the sound passes each microphone once, so it covers the 1.50 m gap only once.

      Marking points

      • no reflection, so the sound crosses the gap only once
    3. (c)Suggest why this method can measure such a short time accurately, but a stopwatch cannot.

      2 marks
      Show the answer

      Answer: The timer starts and stops automatically, so there is no human reaction time. A reaction time of about 0.2 s is far longer than the 4.4 ms being measured.

      Marking points

      • the timer is triggered automatically: no reaction time
      • a reaction time (about 0.2 s) is much longer than the time measured
    4. (d)Sound travels faster in warmer air. The experiment is repeated on a much warmer day. State and explain how the timer reading changes.

      2 marks
      Show the answer

      Answer: The reading is smaller: the sound crosses the same 1.50 m gap at a higher speed, so it takes less time (t = s ÷ v).

      Marking points

      • smaller (a shorter time)
      • the same distance at a higher speed takes less time (t = s ÷ v)
  3. 3.A test explosion is set off at the surface of the sea. A research ship 6.0 km away records the sound with an underwater microphone and with a microphone in the air.

    1. (a)(Supplement) State which microphone detects the sound first. Give a reason.

      2 marks
      Show the answer

      Answer: The underwater microphone, because sound generally travels faster in liquids than in gases.

      Marking points

      • the underwater microphone
      • sound travels faster in a liquid (water) than in a gas (air)
    2. (b)(Supplement) Take 1500 m/s for the speed of sound in sea water and 340 m/s in air. Calculate how long the sound needs to reach each microphone.

      2 marks
      Show the answer

      Answer: Water: t = s ÷ v = 6000 ÷ 1500 = 4.0 s. Air: t = 6000 ÷ 340 = 17.6 s (about 18 s).

      Marking points

      • through water: 6000 ÷ 1500 = 4.0 s
      • through air: 6000 ÷ 340 = 17.6 s (allow 18 s)
    3. (c)(Supplement) Calculate the time between the two arrivals.

      1 mark
      Show the answer

      Answer: 17.6 − 4.0 = 13.6 s (about 14 s).

      Marking points

      • 13.6 s (allow 14 s, or their values subtracted)

Quick check

6 questions

  1. 1.A student 60 m from a wall hears the echo of a clap 0.36 s later. Which speed of sound does this give?
  2. 2.Clapping in time with echoes, a student makes 21 claps while a friend times from the first clap to the last. What should the total time be divided by to get the time for one echo?
  3. 3.(Supplement) In which of these does sound generally travel fastest?
  4. 4.Why does timing 20 echo intervals give a more reliable speed than timing a single echo?
  5. 5.Which surface would give the clearest echo?
  6. 6.Sound travels a little faster in warm air than in cold air. A student times the echo from the same wall on a hot day and on a cold day. How does the echo time on the hot day compare?