Skip to content

Cambridge IGCSE Physics (0625) · Waves and sound

Sound waves

3.4

A vibrating source makes sound, a longitudinal wave that needs a medium and crosses air at about 330–350 m/s. We hear about 20 Hz to 20 000 Hz. Amplitude sets loudness; frequency sets pitch. An echo is reflected sound; ultrasound is above 20 kHz. Supplement: compressions, speeds, ultrasound uses.

Loading simulation…

Symbols match your course. Open the full sound waves and the oscilloscope simulation for more presets and teacher tools.

What topic 3.4 asks for

Making sound (Core)

Every sound starts with a vibration: a tabla skin, your vocal folds or a loudspeaker cone. Moving forwards, the surface crowds nearby air particles together; moving back, it lets them spread out. The particles vibrate backwards and forwards along the line the sound travels, so sound is a longitudinal wave. Each stays near its own fixed position: energy crosses the room, but the air does not.

Compressions and rarefactions (Supplement)

In a compression, particles crowd closer than normal and the pressure rises slightly. In a rarefaction, they spread further apart and the pressure dips. One compression to the next is one wavelength.

A medium is essential (Core)

Sound is passed on by particles, so it crosses solids, liquids and gases but never a vacuum. Pump the air out of a glass jar holding a ringing electric bell: the sound fades almost to nothing, yet the hammer is still seen striking.

Core: in air, the speed of sound is about 330–350 m/s, higher when the air is warm.

Supplement: in general, sound is quickest in solids, slower in liquids and slowest in gases: roughly 1500 m/s in water and nearly 6000 m/s in steel.

Measuring the speed in air (Core)

Two students stand a long, measured distance apart. One claps two flat pieces of wood together; the partner starts a stopwatch on seeing the clap and stops it on hearing it. Light arrives almost at once. Take several readings and use the mean time. Over a long distance, reaction-time errors form a smaller fraction of the time.

Worked example 1 (Core). The students are 240 m apart and time 0.70 s, 0.72 s and 0.71 s. Find the speed of sound.

Given: s=240s = 240 m; mean t=(0.70+0.72+0.71)÷3=0.71t = (0.70 + 0.72 + 0.71) \div 3 = 0.71 s. Equation: v=stv = \dfrac{s}{t}. Substitution: v=2400.71v = \dfrac{240}{0.71}. Answer: v=338v = 338 m/s, about 340 m/s.

Loudness, pitch and hearing (Core)

A larger amplitude gives a louder sound; a higher frequency gives a higher pitch. Neither changes the speed in a given material. Most people hear from about 20 Hz to 20 000 Hz, and the upper limit falls with age.

Echoes and ultrasound

Core. An echo is sound reflected off a surface such as a cliff. Ultrasound is sound whose frequency is above 20 kHz, too high for humans to hear.

Supplement. Ultrasound pulses partly reflect at each boundary between materials. Echo time × speed is the distance there and back, so halve it.

  • Non-destructive testing: finding hidden cracks in welds or rails without damaging them.
  • Medical scanning: imaging soft tissue, such as an unborn baby or the liver.
  • Sonar: ships measure sea depth or find shoals of fish.

Worked example 2 (Supplement). A fishing boat's sonar pulse comes back from a shoal of fish after 0.36 s. In sea water, sound travels at 1500 m/s. How deep is the shoal?

Equation: s=v×ts = v \times t, then halve. Substitution: s=1500×0.36=540s = 1500 \times 0.36 = 540 m, there and back. Answer: 540÷2=270540 \div 2 = 270 m.

Simulation tasks

In the simulation above, the starting note is 500 Hz at Amplitude 4, sent through Air at 340 m/s. Nothing moves before you press Play; the stage runs in labelled slow motion.

  1. (Core) Press Play. The particle labelled vibrates in place slides to and fro on the line the sound follows.
  2. (Supplement) C marks compressions (high pressure) and R rarefactions (low pressure); λ, 0.680 m, spans neighbouring compressions.
  3. (Core) Turn the volume down and press Sound beside Play. From Set-ups…, pick Louder: the note grows louder and the trace peaks rise from 2.0 to 3.0 divisions. Pick Start: 500 Hz, then Higher pitch (1 kHz): the note rises and the waves crowd closer, while the peaks stay 2.0 divisions high.
  4. (Core) Under What the sound travels through, choose Vacuum: the cone moves, but the trace is flat and nothing plays.
  5. (Supplement) Choose Water, then Steel: Speed of sound reads 1500 m/s, then 5900 m/s, while Frequency stays the same.
  6. (Core) Pick Ultrasound (25 kHz) from Set-ups…: the Frequency card names its band.

It shows no echoes, and its oscilloscope trace is beyond the syllabus.

Common mistakes

  • Forgetting to halve in an echo or sonar calculation. The time measured covers the trip to the reflecting surface and back, so speed × time gives twice the distance.
  • Linking pitch to amplitude, or loudness to frequency. A larger amplitude makes a sound louder; a higher frequency makes its pitch higher.
  • Writing the top of the hearing range as 20 000 kHz. It is 20 000 Hz, which is 20 kHz, and ultrasound is any sound above that.
  • Saying a louder or higher note travels faster. In one material, the speed of sound does not depend on its amplitude or its frequency.
  • (Supplement) Claiming sound is fastest in gases because their particles move freely. In general, solids carry sound fastest, then liquids, and gases slowest.
  • In the timing method, starting the stopwatch on hearing the bang. Start it on seeing the sound being made, since light arrives almost at once, and stop it on hearing the sound.

Exam-style questions

Original questions written in the style of Cambridge IGCSE. Try each one before you reveal the answer.

  1. 1.A drummer in a school band hits a drum. The drum skin vibrates, and the sound travels through the air to the audience.

    1. (a)Describe how the vibrating drum skin produces a sound wave in the air.

      2 marks
      Show the answer

      Answer: As the skin moves outwards it pushes the nearby air particles together, and as it moves back they spread out. Each particle passes the vibration on to its neighbours, so the sound travels outwards.

      Marking points

      • vibrating skin pushes and pulls on (makes vibrate) the air particles next to it
      • vibration passed on from particle to particle through the air
    2. (b)Sound is a longitudinal wave. State what this means.

      1 mark
      Show the answer

      Answer: The particles vibrate parallel to the direction in which the wave travels.

      Marking points

      • vibrations parallel to (along) the direction of travel (propagation)
    3. (c)The drummer hits the drum harder. State how the sound changes, and name the property of the wave that causes this change.

      2 marks
      Show the answer

      Answer: The sound is louder, because its amplitude is larger.

      Marking points

      • louder
      • larger amplitude
    4. (d)A smaller drum gives a note of higher pitch. State how the frequency of this note compares with the first.

      1 mark
      Show the answer

      Answer: Its frequency is higher.

      Marking points

      • higher frequency
    5. (e)State the approximate range of frequencies that humans can hear.

      1 mark
      Show the answer

      Answer: 20 Hz to 20 000 Hz

      Marking points

      • 20 Hz to 20 000 Hz (both values needed; accept 20 kHz)
  2. 2.Two students find the speed of sound in air on a large school field. They have a starting pistol, which gives a puff of smoke as it fires, a stopwatch and a long tape measure.

    1. (a)Describe how they should carry out the experiment and calculate the speed of sound.

      4 marks
      Show the answer

      Answer: Use the tape to measure a long distance between them, such as 200 m. One student fires the pistol. The other starts the stopwatch on seeing the smoke and stops it on hearing the bang. Repeat several times and find the mean time. Speed of sound = distance ÷ mean time.

      Marking points

      • measure a large distance (100 m or more) between the students with the tape
      • start the stopwatch on seeing the smoke (flash)
      • stop the stopwatch on hearing the bang
      • repeat and use the mean time; speed = distance ÷ time
    2. (b)The students stand 210 m apart and their mean time is 0.62 s. Calculate the speed of sound.

      2 marks
      Show the answer

      Answer: v = s ÷ t = 210 ÷ 0.62 = 340 m/s (339 m/s)

      Marking points

      • 210 ÷ 0.62 seen
      • 340 m/s (accept 339 m/s)
    3. (c)Suggest why standing further apart gives a more accurate result.

      1 mark
      Show the answer

      Answer: Reaction time then makes up a smaller part of the time being measured.

      Marking points

      • reaction time is a smaller fraction (percentage) of the measured time
    4. (d)State why the students can ignore the time the light from the pistol takes to reach the timer.

      1 mark
      Show the answer

      Answer: Light travels so much faster than sound that it arrives almost instantly.

      Marking points

      • light is very much faster than sound / arrives almost instantly
  3. 3.A survey ship uses sonar to measure the depth of the sea. It sends a short pulse of ultrasound straight down and detects the echo from the seabed.

    1. (a)State what is meant by an echo.

      1 mark
      Show the answer

      Answer: Sound that has been reflected from a surface.

      Marking points

      • reflection of sound (from a surface)
    2. (b)Define ultrasound.

      1 mark
      Show the answer

      Answer: Sound with a frequency above 20 kHz.

      Marking points

      • sound of frequency above 20 kHz (20 000 Hz)
    3. (c)(Supplement) The echo returns 0.52 s after the pulse is sent. The speed of sound in sea water is 1500 m/s. Calculate the depth of the sea.

      3 marks
      Show the answer

      Answer: Distance there and back = 1500 × 0.52 = 780 m, so depth = 780 ÷ 2 = 390 m

      Marking points

      • distance = speed × time
      • 1500 × 0.52 = 780 m
      • depth = 780 ÷ 2 = 390 m
    4. (d)(Supplement) State one use of ultrasound other than sonar.

      1 mark
      Show the answer

      Answer: Checking metal parts or welds for hidden cracks (non-destructive testing), or scanning soft tissue such as an unborn baby.

      Marking points

      • testing materials for hidden flaws without damaging them / scanning soft body tissue in medicine
  4. 4.An electric bell rings inside a sealed glass jar. A vacuum pump slowly removes the air from the jar.

    1. (a)Describe what a student near the jar hears as the air is removed, and explain why.

      2 marks
      Show the answer

      Answer: The ringing gets quieter until it is very faint. Sound needs a medium to travel through, and as the air is removed there are fewer and fewer particles to pass the vibrations on.

      Marking points

      • the sound gets quieter / fades
      • sound needs a medium (particles); there is almost none left in the jar
    2. (b)The hammer is still visible as it hits the bell. State what this shows about light.

      1 mark
      Show the answer

      Answer: Light can travel through a vacuum.

      Marking points

      • light does not need a medium / can cross a vacuum
    3. (c)(Supplement) Describe the difference between a compression and a rarefaction in a sound wave.

      2 marks
      Show the answer

      Answer: In a compression, the particles are closer together than normal and the pressure is higher. In a rarefaction, they are further apart than normal and the pressure is lower.

      Marking points

      • compression: particles closer together / higher pressure
      • rarefaction: particles further apart / lower pressure
    4. (d)(Supplement) A worker strikes one end of a long steel railing. Someone standing at the other end, with an ear near the railing, hears two bangs. Explain why.

      2 marks
      Show the answer

      Answer: Sound travels faster in steel, a solid, than in air, a gas. The sound through the railing arrives first, and the sound through the air arrives later.

      Marking points

      • sound is faster in solids (steel) than in gases (air)
      • so the sound through the railing arrives before the sound through the air

Quick check

6 questions

  1. 1.Which of these frequencies can most humans hear?
  2. 2.A sound becomes louder, but its pitch stays the same. What has changed?
  3. 3.What is the approximate speed of sound in air?
  4. 4.(Supplement) In general, in which order does the speed of sound increase?
  5. 5.(Supplement) A sonar pulse returns from the seabed after 0.40 s. If sound moves at 1500 m/s in sea water, what is the depth?
  6. 6.What is an echo?