Spec point 4.6.1.2 at a glance
- Both tiers, GCSE Physics and Combined Science: describe waves using amplitude, wavelength, frequency and period, and spot amplitude and wavelength on diagrams. Recall ; is given on the GCSE Physics equation sheet (check your own sheet if you take Combined Science). Describe ways to measure the speed of sound in air and of ripples.
- GCSE Physics only: link speed, frequency and wavelength when sound enters a new medium.
- Required practical 8: with ripples in a tank and with waves on a stretched string (a solid), judge which apparatus suits each measurement, then find the frequency, the wavelength and the speed. Combined Science has it too, numbered differently.
The words examiners expect
- Amplitude: the largest displacement a point on the wave reaches, measured from its rest (undisturbed) position up to a crest. Crest to trough is double.
- Wavelength , in m: the length of one whole wave, such as crest to next crest, or the centre of one compression to the centre of the next.
- Frequency , in Hz: how many complete waves pass a fixed point each second.
- Period , in s: the time one complete wave takes to pass that point.
- Wave speed , in m/s: the distance the wave, and the energy it carries, covers in the medium each second.
The source sets the frequency and the medium sets the speed, so the wavelength adjusts to fit. In one medium, doubling halves .
Two graphs, one shape
A displacement–distance graph is a snapshot of the whole wave: crest to crest along it is the wavelength. A displacement–time graph follows one point: crest to crest is the period. Both show the amplitude, from zero to a crest. Check the axis label first, and measure several waves, then divide.
For a longitudinal wave, forward displacement is still plotted upwards. A peak is a particle pushed furthest forward, not a compression: compressions and rarefactions sit where the line crosses zero.
Worked example 1. A displacement–distance graph for waves on a stretched spring shows 4 complete waves across 1.80 m. A displacement–time graph for one coil shows crests 0.025 s apart. Find the wave speed.
Given: m and s. Equations: , then . Substitution: Hz, so . Answer: m/s.
Physics only: sound changing medium
The source sends the same number of waves each second, so the frequency stays the same. The speed changes, and changes in proportion.
Worked example 2. A 250 Hz note passes from air (330 m/s) into water (1500 m/s). Equation: . Substitution: and . Answer: 1.3 m in air, 6.0 m in water.
Measuring wave speeds
Sound in air. Two people stand about 150 m apart, measured with a trundle wheel. One bangs two wooden blocks together; the other times from seeing them meet to hearing the bang. Repeat, average, and divide distance by time. A long distance makes reaction time matter less.
Required practical 8, ripple tank. Use water about 1 cm deep, with a lamp above casting the ripples' shadows onto white paper below. Run the vibrating bar at a low frequency.
- Wavelength: measure across 10 shadow waves with a metre rule and divide by 10. A photo with the rule in shot freezes the pattern.
- Frequency: count waves passing a mark in 10 s and divide by 10, or read the setting of the signal generator driving the bar. Then .
Required practical 8, waves in a solid. Run a string from a vibration generator over a pulley, with masses hanging from the end. Tune the signal generator until steady loops form. Each loop is half a wavelength: measure across several, divide by the number of loops and double it. The signal generator gives .
Using the simulation
In the simulation above, four cards show Frequency 1.0 Hz, Period 1.00 s, Wavelength 2.00 m and Wave speed 2.0 m/s. Press Play, pause after a few seconds and make sure Ruler is on. Drag markers A and B onto neighbouring crests: Ruler, A to B reads about 2.00 m. Play again and press Count, then press it again once the stopwatch shows Waves: 4. It stops at the next crest with Waves counted: 5, in 5.00 s, so s.
Raise Frequency to 2.0 Hz: Wavelength falls to 1.00 m while Wave speed stays 2.0 m/s.