Skip to content

GCSE Physics — AQA · Forces and motion

Stopping distance and reaction time

4.5.6.3.14.5.6.3.24.5.6.3.34.5.6.3.4

Stopping distance = thinking distance + braking distance. Reaction times are typically 0.2–0.9 s. Thinking distance is proportional to speed; at a fixed braking force, braking distance grows with speed squared because the brakes must do work equal to the kinetic energy.

Loading simulation…

Symbols match your course. Open the full stopping distance simulation for more presets and teacher tools.

Stopping distance in the AQA course

This covers spec points 4.5.6.3.1 to 4.5.6.3.4, mostly on both tiers, with two extras:

  • GCSE Physics only (not Combined Science): estimate the emergency stopping distance of one particular vehicle across the speeds it normally drives at, and read graphs comparing stopping distance and speed for different vehicles. (Estimating how emergency stopping distances change across typical road speeds in general is on both courses.)
  • Higher tier only: estimate the forces that slow road vehicles in everyday driving.

You must remember these three equations; none is on the equation sheet:

  • distance travelled = speed × time: s=vts = vt
  • kinetic energy: Ek=12mv2E_k = \tfrac12 m v^2
  • work done = force × distance: W=FsW = Fs

Thinking distance plus braking distance

A vehicle stops in two stages:

stopping distance=thinking distance+braking distance\text{stopping distance} = \text{thinking distance} + \text{braking distance}

The thinking distance is covered during the reaction time, from seeing the hazard to the brakes starting to act. The braking distance is covered from then until the vehicle is at rest.

Reaction time and thinking distance

Each person is different, but most take 0.2 s to 0.9 s to react. During that time the vehicle keeps its speed, so the thinking distance is speed × reaction time. With the reaction time unchanged, doubling the speed doubles the thinking distance.

Tiredness, alcohol and drugs (including some medicines) all slow a driver's reactions, so they lengthen the thinking distance. Distractions such as a phone call can delay a response too.

To measure reaction times in class, use a ruler drop test. A partner holds a ruler vertically, its zero mark level with your open finger and thumb, and lets go without warning. You catch it as fast as you can; a conversion table turns the distance it fell into a time. Repeat several times and take a mean. Clicking when a computer screen changes colour works too. Results usually sit near the quick end of the range, because you are ready and waiting.

Factors that affect braking distance

Braking distance grows with speed. It is also longer when the road is wet or icy (the tyres grip less), when the brakes are worn, or when the tyres are worn with too little tread. A heavier load makes it longer too, because the same braking force then gives a smaller deceleration (F=maF = ma). Road, brakes, tyres and load do not affect the thinking distance.

Where the kinetic energy goes

When the brakes are applied, friction between the brakes and the wheels does work on the vehicle. This reduces its kinetic energy and heats up the brakes. If the brakes alone stop the car, the work they do equals all its kinetic energy:

Fs=12mv2F s = \tfrac12 m v^2

At the same braking force, doubling the speed gives four times the kinetic energy, so the braking distance quadruples. So stopping a faster car within the same distance takes a bigger braking force. Harder braking means a bigger deceleration, and very large decelerations are dangerous: the brakes may overheat, the tyres may skid so the driver loses control, and the people inside feel large forces.

Worked example: a car on a dual carriageway

A car of mass 1200 kg travels at 20 m/s near Leeds. The driver reacts in 0.70 s, and the braking distance is 40 m.

(a) Thinking distance. Given: v=20v = 20 m/s, t=0.70t = 0.70 s. Equation: s=vts = vt. Substitution: s=20×0.70s = 20 \times 0.70. Answer: s=14s = 14 m

(b) Stopping distance. 14+40=5414 + 40 = 54 m

(c) Higher tier: braking force. Equation: Ek=12mv2E_k = \tfrac12 m v^2. Substitution: Ek=12×1200×202=240 000E_k = \tfrac12 \times 1200 \times 20^2 = 240\,000 J. The brakes do this much work, so W=FsW = Fs gives F=240 00040F = \dfrac{240\,000}{40}. Answer: F=6000F = 6000 N

Using the simulation

In the simulation above, choose the scenario Exam-style numbers: 20 m/s, 0.7 s, 5 m/s² and press play. The readouts match the worked example: 14.0 m, 40.0 m and 54.0 m. In the Braking controls, pick Force and mass. Its starting values, 1200 kg and 6 kN, keep the deceleration at 5 m/s², and the Energy check shows 240 kJ for both the brakes' work and the starting kinetic energy. Then return to Road surface, swap between Dry, Wet and Icy, and try each option under How is the driver? Which part of the road changes each time?

Equations

  • Speed, distance and time

    Learn this

    s=vt

    distance travelled = speed × time

    Open calculator →
  • Kinetic energy

    Learn this

    Ek=12mv2

    kinetic energy = 0.5 × mass × (speed)²

    Open calculator →
  • Work done

    Learn this

    W=Fs

    work done = force × distance (along the line of action of the force)

    Open calculator →

Common mistakes

  • Saying a wet or icy road increases the thinking distance. Road conditions change only the braking distance.
  • Saying a tired or distracted driver increases the braking distance. A slower reaction changes only the thinking distance.
  • Writing that the braking distance doubles when the speed doubles. At the same braking force it becomes four times as long.
  • Mixing up reaction time (measured in seconds) with thinking distance (measured in metres).
  • Forgetting to square the speed in E_k = ½mv², or forgetting to convert a time in milliseconds into seconds.
  • Higher tier: using the whole stopping distance instead of the braking distance in work done = force × distance.

Exam-style questions

Original questions written in the style of GCSE AQA. Try each one before you reveal the answer.

  1. 1.A driver sees a cyclist fall off a bike ahead and makes an emergency stop.

    1. (a)Complete the sentence. Stopping distance = thinking distance + ______

      1 mark
      Show the answer

      Answer: braking distance

      Marking points

      • Braking distance.
    2. (b)Give two factors that could increase the driver's reaction time.

      2 marks
      Show the answer

      Answer: Any two from: tiredness, drinking alcohol, taking drugs, being distracted (for example by a phone).

      Marking points

      • First correct factor from: tiredness, alcohol, drugs, distraction.
      • Second correct factor from the same list.
    3. (c)The car is moving at 15 m/s and the driver's reaction time is 0.60 s. Calculate the thinking distance.

      2 marks
      Show the answer

      Answer: s = vt = 15 × 0.60 = 9.0 m

      Marking points

      • s = 15 × 0.60
      • s = 9.0 m
  2. 2.Two students use a 30 cm ruler to measure their reaction times.

    1. (a)Describe a method the students could use.

      4 marks
      Show the answer

      Answer: One student holds the ruler vertically with the zero mark level with the other student's open finger and thumb. The ruler is dropped without warning and caught as quickly as possible. The distance the ruler fell is read off and converted to a reaction time using a table. The test is repeated several times and a mean is calculated.

      Marking points

      • Ruler held vertically, with the zero mark level with the catcher's finger and thumb.
      • Ruler dropped without warning and caught as soon as possible.
      • Read the distance fallen and convert it to a time (using a conversion table).
      • Repeat several times and calculate a mean.
    2. (b)One student repeats the test while having a conversation on a phone. The mean distance fallen increases from 16 cm to 24 cm. What does this result show?

      1 mark
      Show the answer

      Answer: Being distracted increases the student's reaction time.

      Marking points

      • Distraction increases reaction time.
    3. (c)Suggest why a driver's reaction time on a real road is usually longer than the results of this test.

      2 marks
      Show the answer

      Answer: In the test the student is expecting the ruler to fall and is concentrating on it. A driver does not know when a hazard will appear, so first has to notice it, and then has to move a foot to the brake pedal.

      Marking points

      • The student is ready and expecting the drop (a driver is not expecting the hazard).
      • A driver has to notice the hazard and move a foot to the brake pedal.
  3. 3.Higher tier. A delivery van of mass 2500 kg is travelling at 16 m/s. The driver brakes, and the van comes to rest over a braking distance of 32 m.

    1. (a)Calculate the kinetic energy of the van before it brakes.

      2 marks
      Show the answer

      Answer: E_k = ½ × 2500 × 16² = 320 000 J

      Marking points

      • E_k = ½ × 2500 × 16²
      • E_k = 320 000 J
    2. (b)Calculate the average braking force on the van.

      3 marks
      Show the answer

      Answer: The brakes must do 320 000 J of work, removing all the kinetic energy. F = W ÷ s = 320 000 ÷ 32 = 10 000 N

      Marking points

      • Work done by the brakes = 320 000 J (equal to the kinetic energy lost)
      • F = 320 000 ÷ 32
      • F = 10 000 N
    3. (c)Explain what happens to the temperature of the brakes as the van stops.

      2 marks
      Show the answer

      Answer: The temperature increases, because the friction force between the brakes and the wheels does work, transferring energy from the kinetic energy store of the van to the thermal energy store of the brakes.

      Marking points

      • The temperature of the brakes increases.
      • Work done by friction transfers energy from the van's kinetic energy store to the thermal energy store of the brakes.
  4. 4.Data for a car with the same driver on a dry road: at 10 m/s, thinking distance 7.0 m and braking distance 8.0 m; at 20 m/s, thinking distance 14 m and braking distance 32 m; at 30 m/s, thinking distance 21 m and braking distance 72 m.

    1. (a)Describe the relationship between speed and thinking distance.

      1 mark
      Show the answer

      Answer: Thinking distance is directly proportional to speed (doubling the speed doubles the thinking distance).

      Marking points

      • Directly proportional (doubling the speed doubles the thinking distance).
    2. (b)Use the data to show that braking distance is not directly proportional to speed.

      2 marks
      Show the answer

      Answer: When the speed doubles from 10 m/s to 20 m/s, the braking distance goes from 8.0 m to 32 m, which is four times as far, not twice.

      Marking points

      • Uses a pair of values, e.g. 10 m/s to 20 m/s gives 8.0 m to 32 m.
      • Braking distance increases by a factor of four (not two) when the speed doubles.
    3. (c)Calculate the stopping distance at 30 m/s.

      1 mark
      Show the answer

      Answer: 21 + 72 = 93 m

      Marking points

      • 93 m
    4. (d)The same car later brakes on an icy road. Explain how this would affect its braking distances.

      2 marks
      Show the answer

      Answer: The braking distances would be longer, because there is less friction (grip) between the tyres and the road, so the deceleration is smaller.

      Marking points

      • Braking distances increase.
      • Less friction between the tyres and the road, so a smaller deceleration (or smaller braking force before skidding).

Quick check

6 questions

  1. 1.Which of these increases the thinking distance but not the braking distance?
  2. 2.What is the typical range of human reaction times given in the AQA course?
  3. 3.A car's speed doubles and the braking force stays the same. What happens to the braking distance?
  4. 4.When a car brakes to a stop, where does most of its kinetic energy go?
  5. 5.A car travels at 25 m/s and the driver's reaction time is 0.80 s. What is the thinking distance?
  6. 6.Why can a very large deceleration be dangerous?