Skip to content

GCSE Physics — AQA · Electromagnetic waves

Lenses

4.6.2.5Physics only

A convex lens brings parallel rays together at the principal focus; a concave lens spreads them apart. Ray diagrams locate the image: real or virtual for a convex lens, always virtual for a concave one. Magnification = image height ÷ object height is on the equation sheet. Physics only, both tiers.

Loading simulation…

Symbols match your course. Open the full lenses and ray diagrams simulation for more presets and teacher tools.

Physics only: spec point 4.6.2.5

Lenses are GCSE Physics only (Combined Science skips them) and are tested on both tiers. You need to:

  • explain what convex and concave lenses do to light, using principal focus and focal length;
  • construct ray diagrams for both kinds of lens and compare them;
  • say whether an image is real or virtual;
  • calculate magnification with the equation given on the Physics equation sheet.

There is no lens equation; the devices named below are context only.

Convex and concave

A lens forms images by refraction. A convex lens is fatter in the middle than at its rim. Rays parallel to the principal axis are bent inwards and cross at one point on the far side: the principal focus F. A concave lens, thinnest in the middle, bends the same rays apart, as if they spread from F on the side the light arrived from.

The focal length is how far F lies from the centre of the lens. There is an F at that distance on each side.

AQA ray diagrams show a lens as one vertical line, with arrowheads pointing outwards for convex and inwards for concave. Each ray changes direction once, at that line.

The three rays

Rule each ray from the top of the object and add an arrowhead.

Ray from the top of the objectConvex lensConcave lens
Travels parallel to the axisgoes on through F on the far sidebends outwards, in line with F on the object's side
Aimed at the centre of the lensis not bentis not bent
Through F on the object's side (convex), or towards F on the far side (concave)comes out parallel to the axiscomes out parallel to the axis

Two rays locate the image; a third confirms it. If the rays really meet beyond the lens, the image is real: light gathers there, so a screen shows it. If they spread apart, dashed lines extended backwards meet on the object's side at a virtual image. You see it through the lens, but no screen can show it: the light only appears to come from there.

A convex lens can make either kind. A concave lens only makes virtual ones.

Where the image forms

Check your diagrams against this table. 2F is two focal lengths from the lens.

ObjectImageContext only
Convex, beyond 2Fbetween F and 2F, far side; real, inverted, diminishedcamera
Convex, at 2Fat 2F, far side; real, inverted, same size—
Convex, between F and 2Fbeyond 2F, far side; real, inverted, magnifiedprojector
Convex, at Fno image: the rays come out parallel—
Convex, inside Fobject's side, further away than the object; virtual, upright, magnifiedmagnifying glass
Concave, anywherebetween F and the lens, object's side; virtual, upright, diminishedglasses for short sight

Magnification (on the equation sheet)

magnification=image heightobject height\text{magnification} = \frac{\text{image height}}{\text{object height}}

Measure both heights in the same unit, mm or cm. The units cancel, so magnification has no unit. Above 1 means magnified; below 1, diminished.

Worked example 1. In a class investigation, a convex lens projects a lamp-box letter 1.5 cm tall onto a screen. The image is 42 mm tall. Find the magnification.

Given: image height = 42 mm, object height = 1.5 cm = 15 mm

Equation: magnification=image heightobject height\text{magnification} = \dfrac{\text{image height}}{\text{object height}}

Substitution: magnification=4215\text{magnification} = \dfrac{42}{15}

Answer: magnification = 2.8 (no unit), above 1, so the image is magnified.

Worked example 2. A magnifying glass gives a magnification of 2.5. A digit on a railway timetable is 4.0 mm tall. How tall is the image of the digit?

Given: magnification = 2.5, object height = 4.0 mm

Equation: image height=magnification×object height\text{image height} = \text{magnification} \times \text{object height}

Substitution: image height=2.5×4.0\text{image height} = 2.5 \times 4.0

Answer: image height = 10 mm

Try the lens bench

In the simulation above, the Convex lens has Focal length 10 cm and the 5 cm object is 30 cm away. Rays bend only where they cross the symbol drawn on the glass.

  1. The cards show Image distance 15 cm (between F and 2F, far side), Image height 2.5 cm, Magnification 0.5 (2.5 ÷ 5) and Real, inverted, diminished.
  2. Move Object distance to 20 cm (2F): the magnification becomes 1. At 15 cm, the image is 30 cm away and 10 cm tall, a magnification of 2.
  3. At 10 cm, the cards say No image. At 5 cm, the image is virtual, upright and magnified, 10 cm away on the object's side.
  4. Press Concave and drag the object anywhere: the image stays virtual, upright and diminished.

Ignore the Lens equation box, marked Beyond GCSE.

Equations

  • Magnification

    On the equation sheet · Physics only

    M=hiho

    magnification = image height ÷ object height

    Open calculator →

Common mistakes

  • Writing a unit after a magnification, such as 2.5 cm. Magnification is one height divided by another, so the units cancel and the answer is just a number.
  • Dividing heights measured in different units, such as 42 mm by 1.5 cm. Change both to millimetres or both to centimetres before you divide.
  • Bending the parallel ray of a convex lens through F on the object's side. Once through the lens, it heads for F on the far side.
  • Drawing a ray that bends at each curved face of the lens, or a ray with no arrowhead. In an AQA ray diagram the lens is one straight line, and each ray changes direction once, at that line.
  • Thinking a convex lens always makes things look bigger. With the object beyond 2F the image is diminished, and at 2F it is the same size.
  • Saying a concave lens can form a real image if the object is moved, or drawing the backward extensions as solid lines. Its image is always virtual, and the dashed lines carry no light, so no screen can show it.

Exam-style questions

Original questions written in the style of GCSE AQA. Try each one before you reveal the answer.

  1. 1.A student uses a convex lens to form a sharp image of a lit object on a white screen. The object is 2.0 cm tall. The image on the screen is 5.0 cm tall.

    1. (a)Is the image real or virtual? Give a reason for your answer.

      2 marks
      Show the answer

      Answer: Real. It appears on a screen, which is only possible where rays of light actually meet.

      Marking points

      • Real.
      • It forms on a screen / light rays actually meet (cross) there.
    2. (b)Calculate the magnification. Use the Physics Equations Sheet.

      2 marks
      Show the answer

      Answer: magnification = 5.0 ÷ 2.0 = 2.5 (no unit)

      Marking points

      • magnification = 5.0 ÷ 2.0
      • 2.5 (no unit)
    3. (c)Explain why magnification has no unit.

      1 mark
      Show the answer

      Answer: It is a ratio of two heights measured in the same unit, so the units cancel.

      Marking points

      • It is a ratio of two heights in the same unit, so the units cancel.
    4. (d)The student moves the object closer to the lens than its principal focus. Describe what the student now observes on the screen and when looking through the lens.

      2 marks
      Show the answer

      Answer: No image can be found on the screen, wherever it is placed. Looking through the lens, the student sees a virtual image that is upright and magnified.

      Marking points

      • No image forms on the screen.
      • A virtual, upright, magnified image is seen through the lens.
  2. 2.A convex lens has a focal length of 5.0 cm. An object 2.0 cm tall stands on the principal axis, 15 cm from the lens.

    1. (a)Describe how a ray diagram with two rays, both starting at the tip of the object, can be used to locate the image.

      3 marks
      Show the answer

      Answer: Draw a ray from the tip of the object parallel to the principal axis as far as the lens, then on through the principal focus on the far side. Draw a second ray from the same point to the middle of the lens, continuing in a straight line. The top of the image is where these two rays cross; draw the image as an arrow from the axis to that point.

      Marking points

      • Ray parallel to the axis, refracted through the principal focus (F) on the far side.
      • Ray through the centre of the lens, not changing direction.
      • Top of the image where the rays cross (image drawn from the axis to that point).
    2. (b)On a correct diagram the rays cross at a point 7.5 cm beyond the lens, 1.0 cm below the principal axis. Describe the image.

      3 marks
      Show the answer

      Answer: It is real (the rays really cross), inverted (below the axis) and diminished (1.0 cm tall, smaller than the 2.0 cm object).

      Marking points

      • Real.
      • Inverted.
      • Diminished (smaller than the object).
    3. (c)Calculate the magnification.

      2 marks
      Show the answer

      Answer: magnification = 1.0 ÷ 2.0 = 0.5 (no unit)

      Marking points

      • magnification = 1.0 ÷ 2.0
      • 0.5
  3. 3.Rays of light travelling parallel to the principal axis pass through a concave lens with a focal length of 20 cm.

    1. (a)Describe what happens to the rays as they pass through the lens.

      2 marks
      Show the answer

      Answer: They are refracted outwards so that they spread apart (diverge). Traced backwards, they all seem to come from the principal focus on the side of the lens the light entered.

      Marking points

      • The rays spread out / diverge.
      • They appear to come from the principal focus on the side the light enters.
    2. (b)Describe how the ray diagram symbol for a concave lens differs from the symbol for a convex lens.

      1 mark
      Show the answer

      Answer: Each symbol is a vertical line ending in two arrowheads. On the concave symbol they point inwards; on the convex symbol they point outwards.

      Marking points

      • Concave: arrowheads point inwards; convex: arrowheads point outwards.
    3. (c)An object 3.0 cm tall is placed 30 cm from the lens. The magnification is 0.40. Calculate the height of the image.

      3 marks
      Show the answer

      Answer: 0.40 = image height ÷ 3.0, so image height = 0.40 × 3.0 = 1.2 cm

      Marking points

      • 0.40 = image height ÷ 3.0
      • image height = 0.40 × 3.0
      • 1.2 cm
    4. (d)Explain why this image cannot be shown on a screen.

      2 marks
      Show the answer

      Answer: The image is virtual. The rays leaving the lens spread apart and never meet; they only appear to come from the image, so no light reaches a screen placed there.

      Marking points

      • The image is virtual / the rays diverge after the lens and never meet.
      • The light only appears to come from the image, so none arrives at a screen there.
  4. 4.Convex and concave lenses both refract light, but the images they form are different.

    1. (a)Describe the similarities and differences between the images formed by convex and concave lenses. You may refer to ray diagrams in your answer.

      6 marks
      Show the answer

      Answer: Both lenses refract light, and in both ray diagrams a ray aimed at the lens centre carries straight on. A convex lens makes parallel rays converge through the principal focus, while a concave lens makes them diverge as if from the principal focus on the object's side. With the object further away than the principal focus, a convex lens forms a real, inverted image on the far side, which can be shown on a screen; it can be diminished, the same size or magnified depending on the object's position. With the object closer than the principal focus, a convex lens forms a virtual, upright, magnified image on the same side as the object. A concave lens always forms a virtual, upright, diminished image on the same side as the object, between the principal focus and the lens. Virtual images cannot be shown on a screen, because the rays only appear to come from them. (Level-of-response marking: examiners compare the whole answer with level descriptors. The top level needs a clear comparison that covers both lenses, real and virtual images, and how the convex lens's image depends on where the object is.)

      Marking points

      • Both lenses refract light; a ray through the centre of either lens is not bent.
      • Convex lens: parallel rays converge to the principal focus; concave lens: they diverge as if from the principal focus.
      • Convex lens, object beyond the principal focus: real, inverted image on the far side of the lens.
      • Convex lens, object closer than the principal focus: virtual, upright, magnified image on the object's side.
      • Concave lens: the image is always virtual, upright and diminished, on the object's side.
      • A real image can be shown on a screen; a virtual image cannot, because the light only appears to come from it.

Quick check

6 questions

  1. 1.In an AQA ray diagram, which symbol stands for a concave lens?
  2. 2.An image is 15 mm tall. The object is 6.0 mm tall. What is the magnification?
  3. 3.An object is placed at different distances from a concave lens. What is its image always like?
  4. 4.What is the principal focus of a convex lens?
  5. 5.An object is between F and 2F in front of a convex lens. Which describes the image?
  6. 6.A lens gives a magnification of 0.25. The object is 8.0 cm tall. What is the height of the image?